2016 KIA K900 stop start

STEERING WHEEL CONTROLS
15*IF EQUIPPED
A LWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFETY WARNINGS.
Power Tilt/Telescoping Steering Wheel
To adjust the steering wheel distance, move the switch A forward or backward.
To adjust the steering wheel angle, move the switch
A up or down.
A
B
(Switch located on left side of steering wheel)
\fuick Tips
- If ignition is turned OFF then ON again within 30
minutes of the steering wheel heater being turned
ON, the system will remain in the ON position
- System does NOT turn off when ignition is
cycled. To turn system of f, press the heated
steering wheel buttonWhile the ENGINE START/STOP button is in the ON position,
press B to turn steering wheel heater ON. The button
indicator will illuminate.
The steering wheel heater will turn off automatically in 30
minutes, or when button is pressed again to deactivate.
He\bted Steering Wheel*
(Button located on left side of steering wheel)
29319_Text.indd 1511/6/15 10:22 AM

STEERING WHEEL CONTROLS
17*IF EQUIPPED
A LWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFETY WARNINGS.
A
Windshield Wipers & Washers
To operate:
§ Move lever up/down to change wiper modes
M I S T: Single wipe
OFF: Wiper off
AUTO: Auto Rain Sensing LO:
Slow wipe
HI: Fast wipe
§ Pull to spray and wipe
Quick Tips
- When the ENGINE START/STOP button is in the
ON position and the wiper switch is in AUTO
mode, the wiper will automatically operate once
to perform a self-check of the system
- Set the wiper to the OFF position when the wiper
is not in use
- If going through a car wash, remind the
attendant to keep the vehicle in Neutral (N)
and keep the engine running. Also, disable the
Power Trunk lid control using the button inside
the glove compartment, turn off the auto rain-
sensing wipers and fold in the mirrors
Au\fo Rain Sensin\b
The rain sensor located on the upper end of the windshield
glass senses the amount of rainfall and controls the wiping
cycle for the proper interval. The more it rains, the faster the
wiper operates. When the rain stops, the wiper stops.
To turn ON the auto rain-sensing wipers, move lever up/down
to AUTO.
To adjust the auto rain-sensing wiper speed setting, move
the speed control switch
A up/down.
www.KuTechVideos.com/kh13/2016
AUTO RAIN-SENSING
WINDSHIELD WIPERS
VIDEO
To view a video on your
mobile device, snap this
QR Code or visit the listed
website. Refer to page 2
for more information.
LCD Con\frols and Modes
The LCD modes B on the instrument cluster can be
changed using the control buttons C on the right side of
the steering wheel.
Press Mode buttons
/ to change LCD mode.
Press Move buttons
/ to select item.
Press Select/Reset button
in center to set/reset the item.
C
B
For more detailed information, see the LC D Instrument Cluster Modes section on page 6.
29319_Text.indd 1711/6/15 10:22 AM

STEERING WHEEL CONTROLS
*IF EQUIPPED 18
The Advanced Smart Cruise Control (ASCC)* system allows
you to set the vehicle to maintain a speed so long as it is not
limited by trafc. When trafc is encountered, the vehicle will
be slowed to maintain a set distance behind trafc without
depressing the accelerator or brake pedal.
To set /adjust the ASCC speed:
§ Press the CRUISE button up
A to turn system ON. The
CRUISE indicator will illuminate on the instrument cluster
§ Accelerate/decelerate to the desired speed
§ Press the RES+ / S E T- button up/down
B to set or
adjust speed
To set the vehicle-to-vehicle distance:
§ Press the ASCC button
C on the steering wheel.
§ Each time you press
C the vehicle-to-vehicle distance
will change, indicated by the number of bars that appear
on the display
D
To turn the ASCC system OFF:
§ Press the CANCEL button
E. The CRUISE indicator on the
instrument cluster will turn off and the LCD screen ASCC
image will show cancelled
Advanced Smart Cruise Control (ASCC\f*
Quick \bips
The speed setting for the ASCC can be adjusted
under the following conditions:
- With no vehicle in front, you must be travelling at
a minimum speed of 20 mph
- When following a vehicle, there is no minimum
speed requirement
When following a vehicle, the system will
automatically adjust your cruise speed based on
the vehicle in front. It will even bring the vehicle to
a complete stop if necessary. If the vehicle remains
at a standstill for more than 3 seconds, the system
will disable.
To change the cruise control mode from ASCC to
standard cruise control, press and hold button
C.
Repeat to switch back to ASCC mode. (The ASCC
system must not be activated to change modes).
www.KuTechVideos.com/kh13/2016
ADVANCED SMART
CRUISE CONTROL
(ASCC) VIDEO
To view a video on
your mobile device,
snap this QR Code or
visit the listed website.
Refer to page 2 for
more information.
REMINDERS:
-
CRUISE indicator must be ON in order to
operate ASCC
- The cruise control system will not activate until
the brake pedal has been depressed at least once
after ignition ON or engine starting
C
BA
E65mphCRUISE
(Display on
instrument cluster)
(Buttons located on right side of the steering wheel)D
29319_Text.indd 1811/6/15 10:22 AM

CENTER PA NEL
*IF EQUIPPED 30
Drive Mode Integrated Control Syste\f
NORMAL, ECO, SPORT, SMART and SNOW drive modes
may be changed according the driver’s preference or road
conditions. The system’s default mode is NORMAL and is not
displayed on the instrument cluster nor the navigation screen.
To change the drive mode from the NORMAL (default) mode,
press the DRIVE MODE button
A.
ECO Mode – A green ECO indicator will illuminate on the
instrument clu s t er. To deactivate, press the DRIVE MODE
button
A again to change the selection to another setting.
SPORT Mode – A yellow SPORT indicator will illuminate on
the instrument clu s t er. To deactivate, press the DRIVE MODE
button
A again to change the selection to another setting.
SNOW Mode – To activate, press the SNOW MODE button
B
located below the gear shift. It will operate regardless of the
mode you selected with the Drive Mode button. To deactivate
SNOW mode, press SNOW mode button
B again.
S\fart Mode
When SMART mode is activated, the system automatically
selects the drive mode (ECO, NORMAL, SPORT) best suited
to the current driving style (economic, average, aggressive). A
SMART indicator will illuminate on the instrument clu s t er. The
color of the SMART indicator (green, white, red) depends on
the current driving style. To deactivate, press the DRIVE MODE
button
A again to change the selection to another setting.
Quic\b Tip

When the ENGINE START/STOP button is turned
of f, the system will default to Normal mode and
each mode will need to be selected again when the
vehicle restarts.
REMINDERS:

When ECO mode is selected, the following may
occur to improve fuel economy:
- Acceleration may be slightly reduced even when
the accelerator is fully depressed
- Air conditioner performance may be limited
- Shift pattern of the automatic transmission
may change
- Engine noise may increase
- System’s power will be limited when
driving uphill
- When SPORT mode is selected, fuel economy
may decrease
- When SNOW MODE is selected, the SNOW mode
will operate regardless of which drive mode
(NORMAL/SPORT/ECO/SMART) is selected
B
(Button located on center panel below the gear shift)
A
29319_Text.indd 3011/6/15 10:23 AM

CENTER PA NEL
33*IF EQUIPPED
A LWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFETY WARNINGS.
(Button located on center panel below the gear shift)
While the ENGINE START/STOP button is in the ACC/ON position,
press the power rear curtain button A to raise/lower curtain.
REMINDER: Raising or lowering the rear curtain by hand may cause motor failure.
Power Rear Curtain
www.KuTechVideos.com/kh13/2016
POWER REAR
CURTA IN & REAR
SIDE-WINDOW
CURTA INS VIDEO
To view a video on
your mobile device,
snap this QR Code or
visit the listed website.
Refer to page 2 for
more information.
Quick Tips
- The power rear curtain will lower automatically
when the gear shift is moved into the R (Reverse)
position and raise automatically when the gear
shift is moved from R (Reverse) into P (Park)
- When the gear shift is moved into D (Drive)
and the vehicle is traveling at speeds greater
than 12 mph, the power rear curtain will unfold
automatically
A
(Button located on rear passenger’s control system)
A
29319_Text.indd 3311/6/15 10:24 AM

S E AT I N G
*IF EQUIPPED 36
Power Reclining Rear Seats*
The rear seats can be adjusted by using the control switches
located on the door.
Seatback & Seat Slide Adjustment:
§ Move the button
C forward/backward to adjust the
seatback position
§ Move the button
D forward/backward to adjust the
seat position
Easy Access (AUTO) Button – When opening the rear door, the
rear seats will automatically move rearward to provide
easier access for passengers. Press the AUTO button
E on
the door panel to turn the system ON (LED is lit) and OFF (LED
not lit).
REMINDERS:
- Keep hands and other objects away from seat
mechanisms while the seat is in motion
- Do not adjust the seat while wearing seat belts
- Do not operate the rear power seat while the child
seat is installed
- Do not operate two or more power seat control
switches at the same time. Doing so may result
in power seat motor or electrical component
malfunction
C
D
E
(Controls located on door panel)
The integrated system stores into memory the position of
the driver’s seat, outside rearview mirrors, Head-Up Display
( H UD)*, and steering wheel positions. To store positions into
memor y, rst place the gear shift into P (Park) while the
ENGINE START/STOP button is in the ON position. Then:
1. Adjust the driver’s seat, outside rearview mirrors, Head-
Up Display (HUD)* settings and steering wheel positions
2. Press the SET button
A on the control panel. System will
beep once
3. Press one of the memory buttons 1 or 2
B within 5
seconds. The system will beep twice when memory has
been stored
Driver Position \femory System
(Buttons located on driver door panel)
B
A
29319_Text.indd 3611/6/15 10:25 AM

OTHER KEY F E AT U R E S
*IF EQUIPPED 40
Smart Key
A Press to lock all doors
B Press to unlock driver’s door. Press twice within 4
seconds to unlock all doors
C Press and hold for more than 1 second to unlock trunk
and open
REMINDERS:
- Trunk lid will partially open. To fully open, lift up manually
- The trunk unlocks when the Smart Key is within close proximity of the vehicle
D Press and hold more than a half a second for panic alarm.
To turn off alarm, press any button
E Press to release mechanical key (button on reverse side)
Smart Key (Card type)*
G
Press and hold the release button to remove the mechanical
key (release button located on reverse side of the side
shown above).
www.KuTechVideos.com/kh13/2016
ENGINE STOP/START
BUTTON & SMART
KEY VIDEO
To view a video on
your mobile device,
snap this QR Code or
visit the listed website.
Refer to page 2 for
more information.
Quic\f Tips
- If the Smart Key battery is weak or not working
properly, hold the Smart Key fob up to the ENGINE
START/STOP button (lock button side closest)
and press to start engine
- The Smart Key’s signal can be blocked by
the normal operation of a cellular phone or
smartphone. To help prevent this, store each
device separately
- When reinserting the mechanical key, make
sure it is pushed all the way in until there is a
click sound
REMINDER:
Remote button conguration may vary depending on vehicle options.
ABC
D
E
F
G
(Card Type)*
29319_Text.indd 4011/6/15 10:25 AM

OTHER KEY F E AT U R E S
*IF EQUIPPED 42
Map/Room Lamps
Automatic Tu r n O\f\f Function
The interior lights automatically turn off approximately 20
seconds after the ENGINE START/STOP button is turned O F F.
Map/Room Lamp Operation
Map Lamps – These lights produce spot beams for
convenient use as map lamps or as personal lamps for the
driver or the front passenger. Press the buttons
A to turn the
map lamps ON/OFF.
ROOM button – Press the button
B to turn the front and
rear lamps ON/OFF.
REAR ROOM button – Press the button
C to turn the rear
lamp ON/OFF.
DOOR button – When the DOOR button
D is pressed (LED
lit) the front and rear lamps will turn ON as follows:
§ When a door is opened or doors are unlocked with the
Smart Key, the lamps will turn ON for approximately
30 seconds
§ If the ENGINE START/STOP button is in the ACC/OFF
position and a door is open, the lamps will stay ON for
approximately 20 minutes
§ If the ENGINE START/STOP button is in the ACC/ON
position and a door is open, the lamps will stay ON
The lamps will turn OFF immediately if the ENGINE STA R T/
STOP button is turned ON or all doors are locked.
PRIVACY button – When button
E is pressed (LED lit) and
a door is opened, that door lamp will turn ON.
REMINDER: When room lamp lens is pressed ON it
will remain ON, even when the map lamp switch is in
the OFF position.
Quic\b
Tips
- When doors are unlocked by the Smart Key, the
lamp turns ON for approximately 30 seconds
- If your vehicle is equipped with the theft alarm
system, the interior lights automatically turn off
approximately 3 seconds after the system is in
armed stage
- Using interior lights for an extended period of time
may cause battery discharge
BC
D
E
AA
29319_Text.indd 4211/6/15 10:25 AM