Transfer Case........................... .671
Fluid ............................... .701
Maintenance .......................... .671
Transmission ........................... .469
Automatic ........................ .469, 672
Fluid ............................... .701
Maintenance .......................... .672
Shifting ............................. .465
Transmitter Battery Service (Remote Keyless Entry). . .26
Transmitter, Garage Door Opener (HomeLink) .....254
Transmitter Programming (Remote Keyless Entry). .24, 26
Transmitter, Remote Keyless Entry (RKE) .........24
Transporting Pets ........................ .109
Tread Wear Indicators ..................... .550
Turn Signals ..................... .327, 693, 694
Uconnect Customer Programmable Features ...........365
Operation ............................ .391Screen Activated Features
..................25
Uconnect Settings ....................26, 365
Uconnect 8.4A/8.4AN Voice Recognition Additional Information ...................449
Do Not Disturb ....................... .448
Siri Eyes Free ......................... .448
Uconnect Access Vehicle Health Alert .....................441
Uconnect Settings ..........................25
Customer Programmable Features . . . .35, 37, 47, 363
Passive Entry Programming ........35, 37, 47, 363
Uconnect Settings ....................47, 363
Uconnect Voice Command ...................430
Uniform Tire Quality Grades .................717
Universal Transmitter ..................... .254
Unleaded Gasoline ....................... .563
Untwisting Procedure, Seat Belt ................59
Vanity Mirrors .......................... .134
740 INDEX
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENTSpecial design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.
