2016 INFINITI QX50 display

*See your Owner’s Manual for information.
Behind
steering wheel Behind
steering wheel
On
steering column
Behind
steering wheel
1 INSTRUMENT BRIGHTNESS CONTROL SWITCH*
2
VEHICLE INFORMATION DISPLAY
3 TRIP COMPUTER SWITCHES
4 LOW TIRE PRESSURE WARNING LIGHT
5
HEADLIGHT AND TURN SIGNAL SWITCH
6 WIPER AND WASHER SWITCH
7 STEERING WHEEL SWITCHES FOR
AUDIO* / BLUETOOTH® / NAVIGATION
8 INTELLIGENT CRUISE CONTROL BUTTONS
9 PUSH-BUTTON IGNITION
10 WARNING SYSTEMS SWITCH*
11 INTELLIGENT BRAKE ASSIST (IBA)
OFF SWITCH*
12 DYNAMIC DRIVER ASSISTANCE SWITCH*
13 INTELLIGENT KEY PORT
14 TILT / TELESCOPIC STEERING
WHEEL SWITCH*
15 HOOD RELEASE*

16 VEHICLE DYNAMIC CONTROL (VDC)
OFF SWITCH*
17 CONTROL PANEL DISPLAY SCREEN*
18 AUDIO SYSTEM
19 HEATER AND AIR CONDITIONER (automatic)
20 FRONT PASSENGER AIR BAG
STATUS LIGHT*
13
4
56
789
12
14
1516
17
18
1920
2
1011
13
2128163_16b_QX50_US_pQRG_091515.indd 39/15/15 2:54 PM

2
new system features
When the shift lever is in the R (REVERSE) position and the CAMERA button 1 is pressed,
the following views will display in order:
Rear view & bird’s-eye view
Press
Press
Press Rear view & front-side view
Rear wide view
Around View® Monitor (AVM) with Moving Object Detection (MOD)
(if so equipped)
With the ignition switch in the ON position, the
AVM is activated by pressing the CAMERA button
1,
located on the control panel, or by moving the shift lever
to the R (REVERSE) position. The control panel displays
various views of the position of the vehicle.

When the shift lever is in the P (PARK), N (NEUTRAL) or D
(DRIVE) position and the CAMERA button
1 is pressed,
the following views will display in order:
Start from any Control Panel screen
Press
Press Press
Press
Front wide view Front view & bird’s-eye viewFront view & front-side view
1
2128163_16b_QX50_US_pQRG_091515.indd 29/15/15 2:54 PM

3


The colored guide lines on the display screen indicate vehicle width and\
approximate
distances to objects with reference to the vehicle body line.
• Red 1.5 ft (0.5 m); Yellow 3 ft (1 m); Green 7 ft
(2 m) and 10 ft (3 m).

There are some areas where the system will not
show objects.
• When in the front or the rear view display, an
object below the bumper or on the ground may not
be viewed
2.
• When in the bird’s-eye view, a tall object near the
seam of the camera viewing areas
3 will not
appear in the monitor.

The distance between objects viewed on the AVM
differs from the actual distance.

Objects in the bird’s-eye view will appear further
than the actual distance.
MOVING OBJECT DETECTION

If the MOD system detects moving objects
surrounding the vehicle, a yellow frame
4 will
be displayed on the camera image and a chime
will sound.

In the bird’s-eye view, a yellow frame is displayed on
those camera images (front, rear, right, left) where
moving objects are detected.

When the following are displayed:
• Blue MOD icon
5 : the system is operative in this view.
• Gray MOD icon
6 : the system is not operative in this view.
• No MOD icon: the system is off.

To temporarily turn the system on or off, touch the MOD key 7 .
For more information, refer to the “Monitor, climate, audio, phone and voice recognition systems (secti\
on 4)” of your
Owner’s Manual.
4
7
5
6
Snow Mode
When SNOW mode is activated, engine output
is controlled to avoid wheel spin when driving or
starting the vehicle on snowy roads or slippery areas.

To turn on SNOW mode, press the SNOW switch 1,
located on the center console, to the
ON position.

The indicator light 2 will illuminate when the
SNOW mode is on.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
2
3
1
2
2128163_16b_QX50_US_pQRG_091515.indd 39/15/15 2:54 PM

5
essential information
Tire Pressure Monitoring System (TPMS)
A CHECK TIRE PRESSURE warning message will
appear in the vehicle information display
1 and
the low tire pressure warning light
2 will illuminate
when one or more tires are low in pressure and air
is needed.
• The tire pressures should be checked when the
tires are cold. The tires are considered cold after
the vehicle has been parked for 3 hours or more or
driven less than 1 mi (1.6 km) at moderate speeds.

After the tire pressures are adjusted, drive the
vehicle at speeds above 16 mph (25 km/h). The
CHECK TIRE PRESSURE warning message and the
low tire pressure warning light
2 will extinguish.

When the low tire pressure warning light 2 flashes for 1 minute and then remains on, the
TPMS is not functioning properly. Have the system checked by an INFINITI\
retailer.

Tire pressure rises and falls depending on the heat caused by the vehicl\
e’s operation and
the outside temperature. Low outside temperature can lower the temperatu\
re of the air
inside the tire, which can cause a lower tire inflation pressure. This m\
ay cause the low tire
pressure warning light
2 to illuminate. If the warning light illuminates, check the tire
pressure in your tires.
• Check the tire pressure (including the spare tire) often and always pr\
ior to long
distance trips.

The Tire and Loading Information label contains valuable information. Pl\
ease refer to the
“Technical and consumer information (section 9)” of your Owner’\
s Manual for the location
of the Tire and Loading Information label.
For more information, refer to the “Instruments and controls (section 2)”, the “Starting and driving (section 5)” and the
“Maintenance and do-it-yourself (section 8)” of your Owner’s Manual.
1
2
Loose Fuel Cap
A LOOSE FUEL CAP warning message will appear
in the vehicle information display
1 when the
fuel-filler cap is not tightened correctly.

To tighten, turn the cap clockwise until a single click
is heard.

The warning message will extinguish when the
vehicle detects the fuel-filler cap is properly
tightened and the reset button
2 is pressed.

If the cap is not properly tightened, the Malfunction
Indicator Light
may illuminate.
For more information, refer to the “Instruments and controls (section 2)”
and the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
1
2
2128163_16b_QX50_US_pQRG_091515.indd 59/15/15 2:55 PM

6
essential information
Front Armrest/Center Console Storage Box
To access the center console storage box, press
the button
1.
For more information, refer to the “Instruments and controls (section 2)”
of your Owner’s Manual.
1
Fuel-filler Door
Unlock the fuel-filler door using one of the following
operations then push and release the left side of the
door to open.

Push either door handle request switch or the liftgate
request switch while carrying the INFINITI Intelligent
Key with you (that is, in your pocket or purse).

Press the button on the Intelligent Key.

Push the power door lock switch to the position.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
Clock Set/Adjustment
DIGITAL CLOCK WITH NAVIGATION (IF SO EQUIPPED)


To adjust the time and the appearance of the clock
on the display:
1. Press the SETTING button on the control panel.
2. Select the “Others” key.
3. Select the “Clock” key.

The following settings can be adjusted:
• On-screen Clock: The clock in the upper right corner of the display can be turned
on or off.
• Clock Format (24h): The clock can be set to 12 hours or 24 hours.
• Offset (hour): The time can be adjusted by increasing or decreasing per hour.
• Offset (min): The time can be adjusted by increasing or decreasing per minute.
• Daylight Savings Time: The application of Daylight Savings Time can be turned on or off.
• Time Zone: Adjust the time zone. Choose a time zone from the available list.

Press the BACK button to return to the previous screen.
For more information, refer to the “Monitor, climate, audio, phone and voice recognition systems (secti\
on 4)” of your
Owner’s Manual.
2128163_16b_QX50_US_pQRG_091515.indd 69/15/15 2:55 PM

7
first drive features
INFINITI Intelligent Key System
The INFINITI Intelligent Key System allows you to lock
or unlock your vehicle, open your liftgate and start the
engine. It is important to make sure the Intelligent Key is
with you (that is, in your pocket or purse).
LOCKING AND UNLOCKING YOUR VEHICLE

The operating range of the Intelligent Key is within
31.5 in (80 cm) from each request switch.

To lock the vehicle, push either door handle request
switch
1 or the liftgate request switch 2 or press
the
button 3 on the key fob.

To unlock the vehicle, perform one of the
following procedures:
• Push either door handle request switch
1 or the liftgate request
switch
2; the corresponding door will unlock. Push the door handle
request switch
1 or the liftgate request switch 2 again within 1
minute; all other doors will unlock, or
• Press the
button 4 on the key fob to unlock the driver’s side
door. Press the
button 4 again; all other doors will unlock.

The Intelligent Key can also be used to activate the panic alarm by
pressing and holding the
button 5 for more than 1 second. Once
activated, the panic alarm and headlights will stay on for a period
of time.
INFINITI INTELLIGENT KEY BATTERY DISCHARGE

If the battery in the Intelligent Key is almost
discharged, the guide light
6 of the Intelligent Key
port blinks and the Intelligent Key insertion indicator
7 is displayed in the vehicle information display.

To start the engine under these circumstances,
insert the Intelligent Key into the key port with the
key ring side facing backward until it latches into
place. Then push the ignition switch to start
the engine.

To remove the Intelligent Key from the port, push the
ignition switch to turn the engine off and then pull
the Intelligent Key out of the port.

The Intelligent Key port does not charge the
Intelligent Key battery. If you see the Intelligent
Key warning light
8, replace the battery in the
Intelligent Key.

Do not insert the mechanical key or other objects into
the key port because they will damage the key port.
For more information, refer to the “Pre-driving checks and adjustments (section 3)”, the “Starting and driving (section 5)” and
the “Maintenance and do-it-yourself (section 8)” of your Owner’s Manual.
F E
1
2
3
4
5
6
7
8
2128163_16b_QX50_US_pQRG_091515.indd 79/15/15 2:55 PM

14
first drive features
FM/AM/SiriusXM®* Satellite Radio with CD/DVD Player
(with Navigation System - if so equipped)
1 ON•OFF BUTTON/VOL (volume) CONTROL KNOB

Press the ON•OFF button to turn the system on or off.

Turn the VOL (volume) control knob right or left to increase or decrease the volum\
e.
2 SEEK•CAT AND TRACK BUTTONS

To scan quickly through each broadcasting station, press the SEEK•CAT button or the
TRACK button to stop at the next or previous broadcast station.

For satellite radio, press the SEEK•CAT button or the TRACK button to switch to
the first channel of the next or previous category.

Press the SEEK•CAT button or the TRACK button to change tracks on a CD.

Press and hold the SEEK•CAT button or the TRACK button to fast forward or rewind a
track on a CD.
3 AUDIO BUTTON/TUNE/FOLDER KNOB

Press the AUDIO button to go to the audio settings screen.

To manually tune the radio, turn the TUNE/FOLDER knob left or right.
4 STATION PRESET BUTTONS

Twelve stations can be set for the FM band, six for the AM band and 18 f\
or
satellite radio.

To store a station in a preset, you must first select a radio band by pr\
essing the
AM•FM/SAT button
5 then tune to the desired AM, FM or satellite radio station.

Next, press and hold the desired station preset button (1-6) until the preset number is
updated on the display and the sound is briefly muted. The channel indic\
ator will then
display, and the sound will resume. Programing is now complete.

To retrieve a previously set station, select the radio band where the pr\
eset was stored
then press the corresponding station select button (1-6).
*SiriusXM® Satellite Radio is only available on vehicles equipped with an optional\
satellite radio subscription service.
For more information, refer to the “Monitor, climate, audio, phone and voice recognition systems (secti\
on 4)” of your
Owner’s Manual.
123
4
5
2128163_16b_QX50_US_pQRG_091515.indd 149/15/15 2:55 PM

15
Conventional (Fixed Speed) Cruise Control
The cruise control system enables you to set a
constant cruising speed once the vehicle has
reached 25 mph (40 km/h).

The system will automatically maintain the set
speed until you tap the brake pedal, accelerate,
cancel or turn the system off.

To activate the cruise control, push the ON/OFF
switch
1. The CRUISE indicator light in the
instrument panel will illuminate.

To set a cruising speed, accelerate the vehicle to the desired speed, pu\
sh the COAST/SET
switch
2 and release. The SET indicator light in the instrument panel will illuminate. Take
your foot off the accelerator pedal. Your vehicle will maintain the set \
speed.

To reset at a faster cruising speed, push and hold the ACCEL/RES switch 3. When the
vehicle attains the desired speed, release the switch.

To reset at a slower cruising speed, push and hold the COAST/SET switch 2. Release the
switch when the vehicle slows to the desired speed.

To cancel the preset speed, tap the brake pedal or push the CANCEL switch 4.

To turn off cruise control, push the ON/OFF switch 1. Both the CRUISE indicator light and
the SET indicator light in the instrument panel will extinguish.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
4
2
USB (Universal Serial Bus) Connection Port
and iPod® Interface
The USB port 1 is located in the center console
under the armrest.

When a compatible USB memory device or iPod®
is plugged into the USB port, compatible
audio and video files stored on the device
can be played through the vehicle’s audio
system and front display.
For more information, refer to the “Monitor, climate, audio,
phone and voice recognition systems (section 4)” of your Owner’s Manual.
3
1
1
2128163_16b_QX50_US_pQRG_091515.indd 159/15/15 2:55 PM