The driver must not watch the moni-
tor while driving. If the driver watches
the monitor while driving, it may lead to
carelessness and cause an accident.
This unit is for vehicles with a 12 V
battery and negative grounding. Before
installing it in a recreational vehicle, lorry
or bus, check the battery voltage. To
avoid shorts in the electrical system, be
sure to disconnect the E battery cable
before beginning the installation.CAUTION :
This product uses a Laser System.
To ensure proper use of this product,
please read this owner’s manual care-
fully and retain it for future reference.
Should the unit require maintenance,
contact an authorized service center.
Performing controls, adjustments, or
carrying out procedures other than
those specified herein may result in
hazardous radiation exposure.
To prevent direct exposure to laser
beam, do not try to open the enclosure.
Visible laser radiation when open. DO
NOT STARE INTO BEAM.CAUTION :
• Do not keep the navigation system
running with the engine stopped.
Doing so may discharge the vehicle
battery. When you use the navigation
system, always keep the engine run-
ning.
• When the driver wants to operate
the navigation system, first park the
vehicle in a safe location and set the
parking brake. Operating the system
while driving can distract the driver
and may result in a serious accident.
• Do not disassemble or modify this
system. If you do, it may result in
accidents, fire or electrical shock.
• Some country may have laws limiting
the use of video screens while driving.
Use the system only where it is legal
to do so.
• Don't use your phone when you are
driving. You must stop at a safe place
to use your phone.
• When driving your vehicle, be sure
to keep the volume of the unit low
enough to allow you to hear sounds
coming from the outside.
8
General information
CAUTION :
CLASS 1M VISIBLE AND INVISIBLE
LASER RADIATION WHEN OPEN DO
NOT VIEW DIRECTLY WITH OPTICAL
INSTRUMENTS.
Using an AUX source
It is possible to use auxiliary equipment
with unit.
1. Press “MEDIA” until “AUX” screen
appears.
2. Connect an auxiliary device to the
AUX connector, then activate the
auxiliary function.Note
• Some auxiliary devices that don’t have
the video source may not output the
video screen.
• In case of some iPod devices, Use the
iPod cable for exclusive use of iPod for
video playback when connecting iPod
to the AUX connector.
• Video is not available while driving.
(Based on the traffic regulation, Aux
Video is only available whenever vehi-
cle is in stop condition with parking
brake.)
Adjusting the video screen
(Default : Center)
For safety reasons, the video screen
cannot be viewed while your vehicle is in
motion. To view video screen, you must
stop in a safe place and put on the
handbrake.
1. Touch the screen on the aux video
mode.
2. Touch “AUX” on the screen.
3. Select the item you want to adjust.
- Brightness: Touch
or to adjust
the brightness of screen.
- Contrast: Touch
or to adjust
the contrast of screen.
- Saturation: Touch
or to adjust
the saturation of screen.
Note
Touch [Center] to return to the default
settings.
55
Auxiliary device operation
AUX Audio
AUX Video
