2016 Hyundai Equus warning

AUTO HOLD
The AUTO HOLD makes the brakes
keep being applied after the com-
plete stop of the vehicle with the shift
lever in D, R, or N. The brakes are
released when the throttle is applied.
Set up
1.Press the AUTO HOLD switch. TheAUTO HOLD indicator will illumi-
nate in white and the system will
be in the standby status.
2.When you completely stop the vehicle by depressing the brake
pedal, the AUTO HOLD maintains
the brake pressure in order to firm-
ly stop the vehicle. The indicator
color changes from white to green. 3.The vehicle will remain to be stand-
still even when you release the
brake pedal.
4.When setting the EPB, the Auto Hold will be released.
Leaving
When you depress the accelerator
pedal with the shift lever in
R(Reverse)/D(Drive) or in sports
mode, the AUTO HOLD will be auto-
matically released automatically.
Then, the vehicle will start to move.
The indicator color changes from
green to white.
Cancel
If you want to manually release or
cancel the AUTO HOLD, release the
Auto Hold switch while depressing
the brake pedal. The Auto Hold indi-
cator will go OFF. For your safety,
manually release the Auto Hold,
when the distance from the vehicle
ahead is too close or during downhill
driving.
5-23
Driving your vehicle05
OVI055123N
OVI055113N
When driving off from the AUTO
HOLD by depressing the accel-
erator, always take a look
around your vehicle. Slowly
press the accelerator for a
smooth starting.
WARNING

Information
• The Auto Hold does not operate,when:
- The driver's seat belt is unfastenedand driver's door is opened
- The engine hood is opened
- The trunk is opened
- The shift lever is in P (Park)
- The EPB is set
• For your safety, the Auto Hold auto- matically switches to EPB, when:
- The driver's seat belt is unfastenedand driver's door is opened
- The engine hood is opened with the shift lever in D (Drive)
- The trunk is opened with the shift lever in R (Reverse)
- The vehicle stops for more than 10 minutes
- The vehicle stands on a steep slope
- The vehicle moves several times
In these cases, the brake warning
light illuminates, the AUTO HOLD
indicator color changes from green
to white, and a message will be dis-
played with warming sound to
inform you that EPB is automatical-
ly set. (Continued)(Continued)
Before driving off again, depress
brake pedal, take a look around
your vehicle, and manually release
the parking brake and the EPB
switch.
• When the AUTO HOLD indicator illuminates in yellow, the Auto Hold
does not properly work. Take your
vehicle to an authorized EQUUS
dealer and have the system checked.
When there is a malfunction with
the driver’s door, hood or trunk
open detection system, the AUTO
HOLD may not properly operate.
Take your vehicle to an authorized
EQUUS dealer and have the sys-
tem checked.
NOTICE
i
5-24
Driving your vehicle
Depress the accelerator slow-ly when you start the vehicle.
For your safety, cancel the AUTO HOLD operation, when:
- Drive a downhill
- Slowly drive, park or drivebackwards
- Wash the vehicle in an auto- matic car wash
WARNING

When the EPB is set ON after
releasing the Auto Hold, a message
will illuminate on the LCD display.
Also, warning alarm sounds once.
When it is impossible to set ON the
EPB after releasing the Auto Hold, a
message will illuminate on the LCD
display. Also, warning alarm sounds
once. At this moment, depress the
brake pedal.
When this message is displayed,
the Auto Hold and EPB may not be
operable. For your safety, depress
the brake pedal.When you do not depress the brake
pedal while pressing the AUTO
HOLD switch to release it, a mes-
sage will be displayed on the LCD
display. Also, warning alarm sounds
once.
When you press the AUTO HOLD
switch with the driver door/engine
hood/trunk opened or with the seat-
belt unfastened, a message will be
displayed on the LCD display. Also,
warning alarm sounds once. At this
moment, press the AUTO HOLD
switch with the driver door/engine
hood/trunk closed and with the seat-
belt fastened.
NOTICE
5-25
Driving your vehicle05
OVINDR5914
OVINDR5915
OVINDR5916
OVIEDR5913

Anti-lock brake system (ABS)
The ABS continuously monitors the
wheel speed. When the wheels are
about to be locked, the ABS system
repeatedly modulates the hydraulic
brake pressure to the wheels.When you depress brake pedals in
conditions, which may lock the
wheels, you may hear a snapping
sound or feel like that from the
brakes. This is normal and indicates
your ABS is active.
In order to obtain the maximum ben-
efit from your ABS in an emergency
situation, do not attempt to modulate
your brake pressure or to pump your
brakes. Press your brake pedal as
hard, as possible, or as the situation
allows, in order for the ABS to control
the power delivery to the brakes.
Information
A clicking sound may be heard in the
engine compartment, when the engine
is started, and the vehicle begins to
move. These conditions are normal
and indicate that the anti-lock brake
system properly operates.
Even with the anti-lock brake sys-
tem, your vehicle still requires a
safe braking distance. Always
maintain a safe distance from the
vehicle in front of you.
Always slow down the speed when cornering. The anti-lock brake sys-
tem cannot prevent accidents
resulted from an excessively high
speed.
On loose or uneven road surfaces, operation of the anti-lock brake
system may result in a longer brak-
ing distance than the one of a vehi-
cle equipped with a conventional
brake system.
i
5-26
Driving your vehicle
ABS (or ESC, Electronic
Stability Control system) can-
not prevent accidents caused
by improper or dangerous driv-
ing maneuvers. Even though
you have more control over the
vehicle with emergency brak-
ing, always maintain a safe dis-
tance between you and objects
ahead. Vehicle speeds should
always be reduced in extreme
rough road conditions. The
braking distance of an ABS(or
ESC)-equipped vehicle may be
longer than the one of a ABS-
unequipped vehicle in the fol-
lowing road conditions. In these
conditions the vehicle should
be driven at a reduced speed:
A road surface is rough, or it is covered with gravel or
snow
Tire chains are installed
The road surface is pitted or uneven.
The safety performance of an
ABS(or ESC)-equipped vehicle
should not be tested by driving
at a high speed or cornering.
This may put you and others in
danger.
WARNING

When the ABS warning light illu-minates and remains ON, your
vehicle may have a problem with
the ABS. In this case, however,
your brake system is normally
operable.
The ABS warning light will stay ON for approximately 3 seconds
after the ignition switch is ON.
Then, the ABS will perform self-
diagnosis, and if everything is
normal, the light will go OFF. If
the light stays ON, your vehicle
may have a problem with the
ABS. Immediately contact an
authorized EQUUS dealer. When continuously depressing
brakes, while driving on a road
of poor traction, such as an icy
road, the ABS will be continu-
ously active, and the ABS warn-
ing light will illuminate. Pull over
the vehicle in a safe place and
stop the engine.
When restart the engine, and then the ABS warning light goes OFF,
your ABS system is normal.
Otherwise, your vehicle may have
a problem with the ABS.
Immediately contact an author-
ized EQUUS dealer.
Information
When you jump start your vehicle
because of a drained battery, the
engine may not run as smoothly, and
the ABS warning light may be turned
ON. This happens because of the low
battery voltage. It does not indicate
the ABS malfunction.
• Do not pump your brakes!
• Recharge the battery before drivingthe vehicle.
i
NOTICE
NOTICE
5-27
Driving your vehicle05
WKH-014

Check the brake warning light by
turning the ignition switch ON (do not
start the engine). This light illumi-
nates when the parking brake is
depressed with the ignition switch in
the START or ON position.
Before driving, make sure that the
parking brake is fully released and
the brake warning light goes OFF.
When the brake warning light
remains ON even after releasing the
parking brake while engine is run-
ning, there may be a malfunction in
the brake system. Immediate atten-
tion is necessary.
If at all possible, immediately stop
driving. If not, use extreme caution
and continuously drive the vehicle
until you can reach a safe location.
Electronic stability control
(ESC)
The ESC system is to stabilize the
vehicle in cornering maneuvers. The
ESC monitors your steering and driv-
ing. The ESC applies to a brake of an
individual wheel and engage in the
engine management system in order
to stabilize the vehicle.
5-28
Driving your vehicle
OVI055021N
Never drive too fast or quickly
when cornering. The ESC can-
not prevent accidents under
this condition. Excessively high
speed in turning, abrupt driving
maneuvers, and hydroplaning
on a wet surface may result in
serious accidents. Only safe
and attentive driving can pre-
vent accidents, avoiding trac-
tion loss of a vehicle. Even with
the ESC equipment of your
vehicle, always follow all the
driving precautions, including
driving at a safe speed.
WARNING
WKH-002

ESC operation OFF
ESC OFF status
This vehicle has 2 types of
ESC OFF status.
When the engine stops, and
ESC is OFF, ESC remains
OFF.
Upon restarting the engine,
the ESC will be automatical-
ly turned ON again.
ESC OFF state 1
To cancel the ESC, press the ESC
OFF button shortly (ESC OFF
indicator (ESC OFF ) illuminates).
At this state, the engine control func-
tion does not operate. It signifies the
traction control function does not
operate, either. Only the brake con-
trol function operates.
ESC OFF state 2
To cancel ESC operation, press the
ESC OFF button (ESC OFF ) for
more than 3 seconds. ESC OFF indi-
cator (ESC OFF ) illuminates with
an ESC OFF warning alarm. At this
state, the engine control function and
brake control function do not oper-
ate. It signifies the vehicle stability
control function does not operate any
more.
Indicator light
When the Engine Start/Stop button
is turned ON, the ESC indicator illu-
minates. Then, it goes OFF, when the
ESC system normally operates. The
ESC indicator flashes, when the
ESC operates or fails to operate. The
ESC OFF indicator illuminates when
the ESC is turned OFF by pressing
the button.
5-30
Driving your vehicle
OVINDR5917
OVINDR5918
■ ESC indicator light (blinks)
■ ESC OFF indicator light (comes on)

Driving with tires or wheels in var-
ious sizes may cause the ESC
system to malfunction. When
replacing tires, make sure they are
the same size as others. Never
drive the vehicle, which is
installed with the tires of different
diameters.
ESC OFF usage
When driving
ESC should be turned ON for dailydriving whenever possible.
To turn ESC OFF while driving, press the ESC OFF button while
driving on a flat road. Even if you turn OFF the ESC by
pressing the button, the ESC func-
tion may be operated. It is normal
condition for safety driving.
Information
• When driving the vehicle on a
dynamometer, make sure that the
ESC is turned OFF (ESC OFF indi-
cator illuminates with an alarm) by
pressing the button for 3 seconds.
When the ESC is left ON, it may
prevent the vehicle from increasing
the driving speed, resulting in false
diagnosis.
• Turning the ESC OFF does not affect the operation of ABS or brake
systems.
i
NOTICENOTICE
5-31
Driving your vehicle05
The ESC system is only a driv-
ing aid. Take precautions for
safe driving, such as slowing
down on curved, snowy, or icy
roads. Drive slowly and do not
attempt to accelerate when the
ESC indicator light flashes, or
when a road surface is slippery.
WARNING
Never press the ESC OFF but-
ton while ESC operates. If the
ESC is turned OFF while the
ESC operates, the vehicle may
go out of control.
To turn ESC OFF while driving,
press the ESC OFF button on a
flat road.
WARNING
Never press the ESC OFF but-
ton while the ESC operates
(ESC indicator flashes).
When the ESC is turned OFF
while the ESC operates, the
vehicle may go out of control.
WARNING