2016 Hyundai Creta VIN

7-95
7
Maintenance
Cleaning the upholstery and interi
or trim
Vinyl
Remove dust and loose dirt from
vinyl with a whisk broom or vacuum
cleaner. Clean vinyl surfaces with a
vinyl cleaner.
Fabric
Remove dust and loose dirt from fab
ric with a whisk broom or vacuum
cleaner. Clean with a mild soap solu
tion recommended for upholstery or
carpets. Remove fresh spots imme
diately with a fabric spot cleaner. If
fresh spots do not receive immediate
attention, the fabric can be stained
and its color can be affected. Also, its
fireresistant proper ties can be
reduced if the material is not proper
ly maintained.
Using anything but recommended
cleaners and procedures may affect
the fabric’s appearance and fire
resistant properties.
Cleaning the lap/shoulder belt
webbing
Clean the belt webbing with any mild
soap solution recommended for
cleaning upholstery or carpet. Follow
the instructions provided with the
soap. Do not bleach or redye the
webbing because this may weaken it.
Cleaning the interior window glass
If the interior glass surfaces of the
vehicle become fogged (that is, cov
ered with an oily, greasy or waxy
film), they should be cleaned with
glass cleaner. Follow the directions
on the glass cleaner container.
Do not scrape or scratch the inside
of the rear window. This may result
in damage to the rear window
defroster grid.
NOTICE
NOTICE

7-96
Maintenance
EMISSION CONTROl SYSTEM
The emission control system of your
vehicle is covered by a written limited
warranty. Please see the warranty
information contained in the Service
Passport in your vehicle.
Your vehicle is equipped with an
emission control system to meet all
emission regulations.
There are three emission control
systems which are as follows.
(1) Crankcase emission control system
(2) Evaporative emission control sys tem
(3) Exhaust emission control system
In order to assure the proper function
of the emission control systems, it is
recommended that you have your
car inspected and maintained by an
authorized HYUNDAI dealer in
accordance with the maintenance
schedule in this manual.1. Crankcase emission control
system
The positive crankcase ventilation
system is employed to prevent air
pollution caused by blowby gases
being emitted from the crankcase.
This system supplies fresh filtered air
to the crankcase through the air
intake hose. Inside the crankcase,
the fresh air mixes with blowby
gases, which then pass through the
PCV valve into the induction system.
2. Evaporative emission control
system
The Evaporative Emission Control
System is designed to prevent fuel
vapors from escaping into the atmos
phere.
Canister
Fuel vapors generated inside the fuel
tank are absorbed and stored in the
onboard canister. When the engine is
running, the fuel vapors absorbed in
the canister are drawn into the surge
tank through the purge control sole
noid valve.
Purge Control Solenoid Valve(PCSV)
The purge control solenoid valve is
controlled by the Engine Control
Module (ECM); when the engine
coolant temperature is low during
idling, the PCSV closes so that evap
orated fuel is not taken into the
engine. After the engine warms up
during ordinary driving, the PCSV
opens to introduce evaporated fuel to
the engine.

Operating precautions for catalytic
converters (if equipped)
Your vehicle is equipped with a cat
alytic conver ter emission control
device.
Therefore, the following precautions
must be observed:
• Use only UNLEADED FUEL forGasoline engine.
• Do not operate the vehicle when there are signs of engine malfunc
tion, such as misfire or a noticeable
loss of performance.
• Do not misuse or abuse the engine. Examples of misuse are
coasting with the ignition off and
descending steep grades in gear
with the ignition off.
• Do not operate the engine at high idle speed for extended periods (5
minutes or more).
• Do not modify or tamper with any part of the engine or emission con
trol system. All inspections and
adjustments must be made by an
authorized HYUNDAI dealer. • Avoid driving with a extremely low
fuel level. Running out of fuel could
cause the engine to misfire, dam
aging the catalytic converter.
Failure to observe these precautions
could result in damage to the catalyt
ic converter and to your vehicle.
Additionally, such actions could void
your warranties.
Fire
•A hot exhaust system can ignite
flammable items under your
vehicle. Do not park, idle, or
drive the vehicle over or near
flammable objects, such as
grass, vegetation, paper,
leaves, etc.
•The exhaust system and catalyt
ic system are very hot while the
engine is running or immediate
ly after the engine is turned off.
Keep away from the exhaust
system and catalytic, you may
get burned. Also, do not remove
the heat sink around the
exhaust system, do not seal the
bottom of the vehicle or do not
coat the vehicle for corrosion
control. It may present a fire risk
under certain conditions.
WARNING
Maintenance
7-98

8
Specifications & Consumer information
8
Specifications & Consumer information
8
Dimensions ..............................................................8-2
Engine ......................................................................8-2
Bulb wattage ...........................................................8-3
Tires and wheels ....................................................8-4
Recommended lubricants and capacities ...........8-5Recommended sae viscosity number ...........................8-7
Vehicle identification number (VIN) ....................8-8
Vehicle certification label .....................................8-8
Tire specification and pressure label .................8-9
Engine number .......................................................8-9
Air conditioner compressor label ......................8-10

8-6
Specifications & Consumer information
LubricantVolumeClassification
Brake/Clutch fluid 0.7~0.8
l
(0.74~0.85 US qt.) FMVSS116 DOT3 or DOT4
Fuel55
l(58.12 US qt.)
*1
: Refer to the recommended SAE viscosity numbers on the next page.
* 2
: Engine oils labeled Energy Conserving Oil are now available. Along with other additional benefits, they contribute to fuel econ
omy by reducing the amount of fuel necessary to overcome engine friction. Often, these improvements are difficult to measure
in everyday driving, but in a year’s time, they can offer significant cost and energy savings.
* 3
: If the ACEA A5 engine oil is not available in your country, you are able to use API SM & ILSAC GF4 or above (Except Middle
East).
* 4
: If the ACEA B4 engine oil is not available in your country, you are able to use API CH4 or above.

8-8
Specifications & Consumer information
VEhIClE IDENtIfICatIoN NumbEr (VIN)
The vehicle identification number
(VIN) is the number used in register
ing your car and in all legal matters
pertaining to its ownership, etc.
The number is punched on the floor
under the front right seat. To check
the number, pull out the slit part of
carpet. The VIN is also on a plate attached
to the top of the dashboard.
The number on the plate can easily
be seen through the windshield from
outside.
The vehicle cer tification label
attached on the driver’s (or front pas
senger’s) side center pillar gives the
vehicle identification number (VIN).
OGS085002
VEhIClE CErtIfICatIoN
labEl (If EquIppED)
OGS085010L
■ Type A■ Type B
OGS085003
OGS085004L
■ Right Hand Drive
■Left Hand Drive

The tires supplied on your new vehi
cle are chosen to provide the best
performance for normal driving.
The tire label located on the driver's
side (or front passenger’s side) cen
ter pillar gives the tire pressures rec
ommended for your car. The engine number is stamped on
the engine block as shown in the
drawing.
8-98
Specifications & Consumer information
tIrE SpECIfICatIoN aND
prESSurE labEl
OGS085004
OGS085009L
■Right Hand Drive
■Left Hand Drive
■ Gamma 1.6 MPI
■U2 1.4 TCIOGS085008/OGS085007/OGS085001
■U2 1.6 TCI
ENGINE NumbEr