2016 Hyundai Creta fuse

Turn on "FUSE SWITCH"
• This warning message is displayedif the fuse switch under the steer
ing wheel is OFF.
• If this message is displayed, turn the fuse switch on.
For more information, refer to
"Fuses" in chapter 7.
Low Fuel
This warning message is displayed if
the fuel tank is almost out of fuel.
When this message is displayed, the
vehicle range is approximately 50km.
When this message is displayed, the
low fuel level warning light in the
cluster will come on.
It is recommended to look for the
nearest fueling station and refuel as
soon as possible.
3-62
Convenient features of your vehicle
OGS045119OTL045155L

3-115
Convenient features of your vehicle
iNtERioR FEAtURES
Digital clock (if equipped)Whenever the battery terminals or
related fuses are disconnected, you
must reset the time.
When the ignition switch is in the
ACC or ON position, the clock but
tons operate as follows:
• H (Hour)
Press the "H" button to advance the
time displayed by one hour.
• M (Minute)
Press the "M" button to advance the
time displayed by one minute.
• Display conversion
To change the 12 hour format to the
24 hour format, press the "H" and
"M" button simultaneously for more
than 4 seconds.
For example, if the "H" and "M" but
ton is pressed when the time is 10:15
p.m., the display will change to22:15.
Cigarette lighter (if equipped)
To use the cigarette lighter, the igni
tion switch must be in the ACC or ONposition.
Push the cigarette lighter all the way
into its socket. When the element is
heated, the lighter will pop out to the
“ready” position.
We recommend that you use parts
for replacement from an authorized
HYUNDAI dealer.
Do not adjust the clock while driv
ing. You may lose your steering
control and cause severe personal
injury or accidents.
WARNING
OGS045124OGS045092L

3-119
Convenient features of your vehicle
To prevent damage to the Power
outlet:
•Use the power outlet only when the
engine is running and remove the
accessory plug after use. Using
the accessory plug for prolonged
periods of time with the engine off
could cause the battery to dis
charge.
•Only use 12V electric accessories
which are less than 180W (Watt) in
electric capacity.
•Adjust the airconditioner or heater to
the lowest operating level when
using the power outlet.
(Continued)
(Continued)
•Close the cover when not in use.
•Some electronic devices can
cause electronic interference when
plugged into a vehicle’s power out
let. These devices may cause
excessive audio static and mal
functions in other electronic sys
tems or devices used in your vehi
cle.
•Push the plug in as far as it will go.
If good contact is not made, the
plug may overheat or the internal
temperature fuse may open.
•Plug in battery equipped electri
cal/electronic devices with reverse
current protection. The current
from the battery may flow into the
vehicle's electrical/electronic sys
tem and cause system malfunc
tion.
NOTICE
Avoid electrical shocks. Do not
place your fingers or foreign
objects (pin, etc.) into a power out
let or touch the power outlet with a
wet hand.
WARNING

5-17
Driving your vehicle
5
Starting and stopping the engine
for turbocharger intercooler
1. Do not race or accelerate theengine immediately after starting
the engine.
If the engine is cold, idle for sever
al seconds before sufficient lubri
cation is ensured in the turbo
charger unit.
2. After high speed or extended driv ing that requires heavy engine
load, idle the engine about one
minute before turning the engine
off. This idle time will allow the tur
bocharger to cool prior to shutting
the engine off.
Do not turn off the engine immedi
ately after it has been subjected to a
heavy load. Doing so may cause
severe damage to the engine or
turbo charger unit.
To prevent damage to the vehicle:
•If the engine stalls while you are in
motion, do not attempt to move the
shift lever to the P (Park) position.
If traffic and road conditions per
mit, you may put the shift lever in
the N (Neutral) position while the
vehicle is still moving and press
the Engine Start/Stop button in an
attempt to restart the engine.
•Do not push or tow your vehicle to
start the engine.
To prevent damage to the vehicle:
When the stop lamp fuse is blown,
you can't start the engine normally.
Replace the fuse with a new one. If
you are not able to replace the fuse,
you can start the engine by pressing
and holding the Engine Start/Stop
button for 10 seconds with the
Engine Start/Stop button in the ACC
position.
Do not press the Engine Start/Stop
button for more than 10 seconds
except when the stop lamp fuse is
blown.
For your safety always depress the
brake and/or clutch pedal before
starting the engine.
NOTICENOTICE
NOTICE

7
Fuses ......................................................................7-63Instrument panel fuse replacement ...........................7-64
Engine compartment panel fuse replacement.........7-66
Fuse/Relay panel description ......................................7-68
Light­bulbs.............................................................7-78 Headlight, position light, turn signal light, and front fog light bulb replacement ....................7-79
Side repeater light bulb replacement.........................7-84
Rear combination light bulb replacement .................7-84
High mounted stop light ................................................7-86
License plate light bulb replacement ........................7-87
Interior light bulb replacement ....................................7-88
Appearance­care ..................................................7-89 Exterior care ....................................................................7-89
Interior care......................................................................7-94
Emission­control­system .....................................7-96 Crankcase emission control system ...........................7-96
Evaporative emission control system.........................7-96
Exhaust emission control system ...............................7-97

7-63
7
Maintenance
FuSES
A vehicle’s electrical system is pro
tected from electrical overload dam
age by fuses.
This vehicle has 2 fuse panels, one
located in the driver’s side panel bol
ster, the other in the engine compart
ment near the battery.
If any of your vehicle’s lights, acces
sories, or controls do not work, check
the appropriate circuit fuse. If a fuse
has blown, the element inside the
fuse will be melted.
If the electrical system does not
work, first check the driver’s side
fuse panel.
Before replacing a blown fuse, dis
connect the negative battery cable.
Always replace a blown fuse with
one of the same rating.
If the replacement fuse blows, this
indicates an electrical problem. Avoid
using the system involved and imme
diately consult an authorized
HYUNDAI dealer.
Three kinds of fuses are used: blade
type for lower amperage rating, SlowBlow type and multi fuse for higheramperage ratings.
Do not use a screwdriver or any
other metal object to remove fuses
because it may cause a short circuit
and damage the system.
Information
The actual fuse/relay panel label may
differ from equipped items. i
NOTICE
OTA070039
Normal
Normal
■ Slow Blow type
■ Multi fuse
BBlloowwnn
Normal
■
Blade type
BBlloowwnn
BBlloowwnn
Fuse replacement
•Never replace a fuse with any
thing but another fuse of the
same rating.
•A higher capacity fuse could
cause damage and possibly a
fire.
•Never install a wire or aluminum
foil instead of the proper fuse
even as a temporary repair. It
may cause extensive wiring
damage and a possible fire.
WARNING

7-64
Maintenance
•When replacing a blown fuse or
relay with a new one, make sure
the new fuse or relay fits tightly into
the clips. The incomplete fastening
fuse or relay may cause the vehi
cle wiring and electric systems
damage and a possible fire.
•Do not remove fuses, relays and
terminals fastened with bolts or
nuts. The fuses, relays and termi
nals may be fastened incomplete
ly, and it may cause a possible fire.
If fuses, relays and terminals fas
tened with bolts or nuts are blown,
consult with an authorized
HYUNDAI dealer.
•Do not input any other objects
except fuses or relays into
fuse/relay terminals such as a driv
er or wiring. It may cause contact
failure and system malfunction.
(Continued)
(Continued)
•Check the blown fuse with the fuse
information on the fuse box cover.
•Replace the blown fuse on the
same place after turning off the
ignition switch and all electric
switches and disconnecting the
negative battery cable.
Instrument panel fuse replace
ment
1. Turn the ignition switch and allother switches off.
2. Open the fuse panel cover.
NOTICE
OGS075016

7-65
7
Maintenance
3. Pull the suspected fuse straight
out. Use the fuse puller provided in
the engine compar tment fusepanel.
4. Check the removed fuse; replace it if it is blown.
5. Push in a new fuse of the same rating, and make sure it fits tightly
in the clips.
If it fits loosely, we recommend that
you consult an authorized HYUNDAI
dealer.
If you do not have a spare, use a fuse of the same rating from a circuityou may not need for operating thevehicle, such as the cigarette lighterfuse.
If the electrical components do not
work and the fuses are OK, check
the fuse panel in the engine com
partment. If a fuse is blown, it must
be replaced. Fuse switch
Always, put the fuse switch at the ON position.
If you move the switch to the OFF
position, some items such as audio
and digital clock must be reset and
transmitter (or smart key and burglar
alarm) may not work properly.
Always place the fuse switch in the
ON position while driving the vehicle.
NOTICE
OGS075064
OGS075018