2016 Hyundai Creta Battery

3-53
Convenient features of your vehicle
3
Immobilizer Indicator
Light (with smart key)
(if equipped)
T h i s i n d i c a t o r l i g h t i l l u m i n a t e s f o r
u p t o 3 0 s e c o n d s :
When the vehicle detects the smart
key in the vehicle with the Engine
Start/Stop button in the ACC or ONposition.
At this time, you can start the engine.
The indicator light goes off after starting the engine.
T h i s i n d i c a t o r l i g h t b l i n k s f o r a f e w
s e c o n d s :
When the smart key is not in the
vehicle.
At this time, you cannot start theengine.
T h i s i n d i c a t o r l i g h t i l l u m i n a t e s f o r
2 s e c o n d s a n d g o e s o f f :
If the smart key is in the vehicle and
the Engine Start/Stop button is ON,
but the vehicle cannot detect the
smart key.
In this case, we recommend that you
have the vehicle inspected by an
authorized HYUNDAI dealer.
T h i s i n d i c a t o r l i g h t b l i n k s :
• When the battery voltage of the smart key is low.
At this time, you can not start theengine. However, you can start the
engine if you press the Engine
Start/Stop button with the smart
key. (For more details, refer to
“Starting the Engine” in chapter 5).
• When there is a malfunction with the immobilizer system.
In this case, we recommend that
you have the vehicle inspected by
an authorized HYUNDAI dealer.
Turn Signal Indicator
Light
T h i s i n d i c a t o r l i g h t b l i n k s :
When you operate the turn signal
indicator light.
If any of the following occurs, there
may a malfunction with the turn signal
system.
The turn signal indicator light illumi nates but does not blink
The turn signal indicator light blinks rapidly
The turn signal indicator light does not illuminate at all
If either of these conditions occur, we
recommend you to have your vehicle
inspected by an authorized HYUNDAI
dealer.

3-55
Convenient features of your vehicle
3
Overspeed Warning
Light (if equipped)
T h i s w a r n i n g l i g h t b l i n k s :
When you drive the vehicle more
than 120 km/h.
This is to prevent you from drivingyour vehicle with overspeed.
The overspeed warning chime also sound for approximately 5 seconds.
Master Warning Light
(if equipped)
T h i s i n d i c a t o r l i g h t i l l u m i n a t e s :
When the remaining mileage or time
is 0 on the “Service Interval” in the
cluster.
If the service interval setting is reset,
the master warning light turns off.
Glow Indicator Light
(Diesel Engine)
T h i s i n d i c a t o r l i g h t i l l u m i n a t e s :
When the engine is being preheated
with the ignition switch or Engine
Start/Stop button in the ON position.
The engine can be started after theglow indicator light goes off.
The illumination time varies with the engine coolant temperature, air
temperature, and battery condition.
If the indicator light remains on or
blinks after the engine has warmed
up or while driving, there may a mal
function with the engine preheating
system.
In this case, we recommend that you
have the vehicle inspected by an
authorized HYUNDAI dealer.
Information Engine
Preheating
I f t h e e n g i n e d o e s n o t s t a r t w i t h i n 1 0
s e c o n d s a f t e r t h e p r e h e a t i n g i s c o m
p l e t e d , s e t t h e i g n i t i o n s w i t c h o r
E n g i n e S t a r t / S t o p b u t t o n t o t h e
L O C K o r O F F p o s i t i o n f o r 1 0 s e c o n d s
a n d t h e n t o t h e O N p o s i t i o n i n o r d e r
t o p r e h e a t t h e e n g i n e a g a i n .
i120km/h

KEY OUT Indicator Light
(if equipped)
When the Engine Start/Stop button
is in the ACC or ON position, if any
door is open, the system checks for
the smart key.
T h i s i n d i c a t o r l i g h t b l i n k s :
When the smart key is not in the
vehicle and any door is open with the
ignition switch or Engine Start/Stop
button in the ACC or ON position.
At this time, if you close all doors, the chime will also sound for
approximately 5 seconds.
The indicator will go off while the vehicle is moving.
Warning Messages
(for Type B, if equipped)
Shift to "P" position
(for smart key system and auto
matic transaxle)
This warning message is displayed if
you try to turn off the engine without
the shift lever in P (Park) position.
At this time, the Engine Start/Stop
button turns to the ACC position (If
you press the Engine Start/Stop but
ton once more, it will turn to the ONposition).
Low Key Battery
(for smart key system)
This warning message is displayed if
the battery of the smart key is dis
charged when the Engine Start/Stop
button is in the OFF position.
3-56
Convenient features of your vehicle
OGS045108
OLF044126L
KEY
OUT

3-77
Convenient features of your vehicle
Battery saver function
The purpose of this feature is to pre
vent the battery from being dis
charged. The system automatically
turns off the parking lights when the
driver removes the ignition key or
turns the engine off (for smart key)
and opens the driverside door.
With this feature, the parking lights
will turn off automatically if the driver
parks on the side of road at night.
If necessary, to keep the lights on
when the ignition key is removed or
the engine is turned off (for smart
key), perform the following:
1) Open the driverside door.
2) Turn the parking lights OFF andON again using the light switch on
the steering column.
Headlamp delay function
(if equipped)
If the key is removed from the ignition
switch or placed in the ACC or
LOCK/OFF position with the head
lights ON, the headlights (and/or
parking lights) remain on for about 5
minutes. However, with the engine off
if the driver’s door is opened and
closed, the headlights (and/or parking
lights) are turned off after 15 seconds.
The headlights (and/or parking
lights) can be turned off by pressing
the lock button on the remote key (or
smart key) twice or turning the light
switch to the OFF or AUTO position.
However, if you turn the light switch
to the AUTO position when it is dark
outside, the headlights will not be
turned off.If the driver gets out of the vehicle
through other doors (except driver's
door), the battery saver function
does not operate and the headlamp
delay function does not turn off auto
matically. Therefore, It causes the
battery to be discharged. In this
case, make sure to turn off the lamp
before getting out of the vehicle.
NOTICE

3-79
Convenient features of your vehicle
Interior lights
Do not use the interior lights for
extended periods when the engine is
turned off or the battery will dis
charge.
Interior lamp AUTO cut
The interior lamps will automatically
go off approximately 20 minutes after
the engine is turned off and the
doors closed. If a door is opened, the
lamp will go off 40 minutes after the
engine is turned off. If the doors are
locked by the remote key or smart
key and the vehicle enters the armed
stage of the theft alarm system, the
lamps will go off five seconds later.
Front lamps
(1) Front Map Lamp
(2) Front Room Lamp
Front Map Lamp:
Press either the right or left lens to
turn the map lamp on or off. This light
produces a spot beam for convenient
use as a map lamp at night or as a
personal lamp for the driver and the
front passenger.
Front Room Lamp:
The Front Room Lamp Switch acti
vates the front and rear room lamps
when the switch is pressed in either of
the three positions indicated below:
: The front or rear room lampscome on when the front or rear
doors are opened if the engine
is running or not. When doors
are unlocked by the remote
key or smart key, the front and
rear lamps come on for
approximately 15 seconds as
long as any door is not
opened. The front and rear
room lamps go out gradually
after approximately 15 sec
onds if the door is closed.
However, if the ignition switch
is in the ON position or all
doors are locked, the front and
rear lamps will turn off immedi
ately. If a door is opened with
the ignition switch in the ACC
position or the LOCK/OFF
position, the front and rear
lamps stay on for about 20
minutes. However, if a door is
opened with the ignition switch
in the ON position, the lamps
stays on continuously.
NOTICE
OIB044015/Q
Do not use the interior lights when
driving in the dark. The interior
lights may obscure your view and
cause an accident.
WARNING

3-115
Convenient features of your vehicle
iNtERioR FEAtURES
Digital clock (if equipped)Whenever the battery terminals or
related fuses are disconnected, you
must reset the time.
When the ignition switch is in the
ACC or ON position, the clock but
tons operate as follows:
• H (Hour)
Press the "H" button to advance the
time displayed by one hour.
• M (Minute)
Press the "M" button to advance the
time displayed by one minute.
• Display conversion
To change the 12 hour format to the
24 hour format, press the "H" and
"M" button simultaneously for more
than 4 seconds.
For example, if the "H" and "M" but
ton is pressed when the time is 10:15
p.m., the display will change to22:15.
Cigarette lighter (if equipped)
To use the cigarette lighter, the igni
tion switch must be in the ACC or ONposition.
Push the cigarette lighter all the way
into its socket. When the element is
heated, the lighter will pop out to the
“ready” position.
We recommend that you use parts
for replacement from an authorized
HYUNDAI dealer.
Do not adjust the clock while driv
ing. You may lose your steering
control and cause severe personal
injury or accidents.
WARNING
OGS045124OGS045092L

3-119
Convenient features of your vehicle
To prevent damage to the Power
outlet:
•Use the power outlet only when the
engine is running and remove the
accessory plug after use. Using
the accessory plug for prolonged
periods of time with the engine off
could cause the battery to dis
charge.
•Only use 12V electric accessories
which are less than 180W (Watt) in
electric capacity.
•Adjust the airconditioner or heater to
the lowest operating level when
using the power outlet.
(Continued)
(Continued)
•Close the cover when not in use.
•Some electronic devices can
cause electronic interference when
plugged into a vehicle’s power out
let. These devices may cause
excessive audio static and mal
functions in other electronic sys
tems or devices used in your vehi
cle.
•Push the plug in as far as it will go.
If good contact is not made, the
plug may overheat or the internal
temperature fuse may open.
•Plug in battery equipped electri
cal/electronic devices with reverse
current protection. The current
from the battery may flow into the
vehicle's electrical/electronic sys
tem and cause system malfunc
tion.
NOTICE
Avoid electrical shocks. Do not
place your fingers or foreign
objects (pin, etc.) into a power out
let or touch the power outlet with a
wet hand.
WARNING

4-15
Multimedia System
4
(Continued)
 When the EQ features of an exter-nal device, such as the iPod ®
, and
the audio system are both active,
EQ effects could overlap and cause
sound deterioration and distortion.
Whenever possible, turn off the EQ
feature within the external device
upon use by connecting with the
audio system.
 Noise may occur when an iPod ®
or
AUX device is connected. When
such devices are not being used, dis-
connect the device for storage.
 When the iPod ®
or AUX device
power is connected to the power
jack, playing the external device
may result in noise. In such cases,
disconnect the power connection
before use.
 Skipping or improper operation may occur depending on the characteris-
tics of your iPod ®
/Phone ®
device.
(Continued) (Continued)
 If your iPhone
®
is connected to both
the Bluetooth ®
Wireless Technology
and USB, the sound may not be
properly played. In your iPhone ®
,
select the Dock connector or
Bluetooth ®
Wireless Technology to
change the sound output (source).
 iPod mode cannot be operated when the iPod ®
cannot be recognized due
to versions that do not support com-
munication protocols.
 For fifth generation iPod ®
Nano
devices, the iPod ®
may not be recog-
nized when the battery level is low.
Please charge the iPod ®
for use.
 Search/play orders shown within the iPod ®
device may differ with the
orders shown within the audio sys-
tem.
 If the iPod ®
malfunctions due to an
iPod ®
device defect, reset the iPod ®
and try again. (To learn more, refer
to your iPod ®
manual)
(Continued) (Continued)
 Some iPod
®
s may not sync with the
System depending on its version. If
the Media is removed before the
Media is recognized, then the sys-
tem may not properly restore the
previously operated mode. (iPad ®
charging is not supported.)
 Beside support 1M cable when pur- chasing iPod/iPhone products, Long
Cable cannot be recognized.