2016 Hyundai Creta lock

If the engine stalls while driving
• Reduce your speed gradually,keeping a straight line. Move cau
tiously off the road to a safe place.
• Turn on your hazard warning flash er.
• Try to start the engine again. If your vehicle will not start, we recom
mend that you contact an author
ized HYUNDAI dealer.
If the engine stalls at a cross
road or crossing
If the engine stalls at a crossroad or
crossing, if safe to do so, move the
shift lever to the N (Neutral) position
and then push the vehicle to a safelocation.
• If your vehicle has a manualtransaxle not equipped with a igni
tion lock switch, the vehicle can
move forward by shifting to the
2(second) or 3(third) gear and then
turning the starter without depress
ing the clutch pedal.
If you have a flat tire while driv
ing
If a tire goes flat while you are driv ing:
• Take your foot off the accelerator pedal and let the vehicle slow
down while driving straight ahead.
Do not apply the brakes immedi
ately or attempt to pull off the road
as this may cause loss of vehicle
control resulting in an accident.
When the vehicle has slowed to
such a speed that it is safe to do
so, brake carefully and pull off the
road. Drive off the road as far as
possible and park on firm, level
ground. If you are on a divided
highway, do not park in the median
area between the two traffic lanes.
• When the vehicle is stopped, press the hazard warning flasher button,
move the shift lever into P (Park,
for automatic transaxle vehicle) or
neutral (for manual transaxle vehi
cle), apply the parking brake, and
place the ignition switch in theLOCK/OFF position. • Have all passengers get out of the
vehicle. Be sure they all get out on
the side of the vehicle that is away
from traffic.
• When changing a flat tire, follow the instructions provided later in
this chapter.
IN CASE OF AN EMERGENCY WHILE DRIVING
6-3
What to do in an emergency
6

If your temperature gauge indicates
overheating, you experience a loss
of power, or hear loud pinging or
knocking, the engine may be over
heating. If this happens, you should:
1. Pull off the road and stop as soonas it is safe to do so.
2. Place the shift lever in P (Park, for automatic transaxle vehicle) or
neutral (for manual transaxle vehi
cle) and set the parking brake. If
the air conditioning is ON, turn it
OFF.
3. If engine coolant is running out under the vehicle or steam is com
ing out from the hood, stop the
engine. Do not open the hood until
the coolant has stopped running
or the steaming has stopped. If
there is no visible loss of engine
coolant and no steam, leave the
engine running and check to be
sure the engine cooling fan is
operating. If the fan is not running,
turn the engine off. 4. Check for coolant leaking from the
radiator, hoses or under the vehi
cle. (If the air conditioning had
been in use, it is normal for cold
water to be draining from it when
you stop.)
5. If engine coolant is leaking out, stop the engine immediately and
we recommend that you call an
authorized HYUNDAI dealer for
assistance.
IF THE ENGINE OVERHEATS
6-8
What to do in an emergency
While the engine is run
ning, keep hands,
clothing and tools away
from the moving parts
such as the cooling fan
and drive belt to pre
vent serious injury.
WARNING
NEVER remove the
radiator cap or the
drain plug while the
engine and radiator are
hot. Hot coolant and
steam may blow out under pres
sure, causing serious injury.
Turn the engine off and wait until
the engine cools down. Use
extreme care when removing the
radiator cap. Wrap a thick towel
around it, and turn it counterclock
wise slowly to the first stop. Step
back while the pressure is
released from the cooling system.
When you are sure all the pres
sure has been released, press
down on the cap, using a thick
towel, and continue turning coun
terclockwise to remove it.
WARNING

6-16
What to do in an emergency
Jack and tools
ÀJack
Á Jack handle
 Wheel lug nut wrench
¯ Towing hook
These parts are stored in the lug
gage compartment under the lug
gage box cover.
The jack is provided for emergency
tire changing only.
Removing and storing the spare
tire
Turn the winged hold down bolt coun
terclockwise to remove the spare tire.
Store the spare tire in the same com
partment by turning the winged hold
down bolt clockwise.
To prevent the spare tire and tools
from “rattling,” store them in their prop
er location.
IF YOU HAVE A FLAT TIRE
Changing a tire can be dangerous.
Follow the instructions in this sec
tion when changing a tire to
reduce the risk of serious injury or
death.
WARNING
OGS065012
OGC064002

6-17
What to do in an emergency
6
Changing tires Follow these steps to change your
vehicle’s tire:
1. Park on a level, firm surface.
2. Move the shift lever into P (Park,for automatic transaxle vehicle) or
neutral (for manual transaxle
vehicle), apply the parking brake,
and place the ignition switch in the
LOCK/OFF position.
3. Press the hazard warning flasher button.
4. Remove the wheel lug nut wrench, jack, jack handle, and spare tire
from the vehicle.
5. Block both the front and rear of the tire diagonally opposite of the tire
you are changing.
A vehicle can slip or roll off of a
jack causing serious injury or
death to you or those nearby.
Take the following safety precau
tions:
•Do not get under a vehicle that
is supported by a jack.
•NEVER attempt to change a tire
in the lane of traffic. ALWAYS
move the vehicle completely off
the road on level, firm ground
away from traffic before trying to
change a tire. If you cannot find
a level, firm place off the road,
call a towing service for assis
tance.
•Be sure to use the jack provided
with the vehicle.
(Continued)
(Continued)
•ALWAYS place the jack on the
designated jacking positions on
the vehicle and NEVER on the
bumpers or any other part of the
vehicle for jacking support.
•Do not start or run the engine
while the vehicle is on the jack.
•Do not allow anyone to remain
in the vehicle while it is on the
jack.
•Keep children away from the
road and the vehicle.
WARNING

6-18
What to do in an emergency
6. Loosen the wheel lug nuts counterclockwise one turn each in the
order shown above, but do not
remove any lug nuts until the tire
has been raised off of the ground. 7. Place the jack at the front (1) or
rear (2) jacking position closest to
the tire you are changing. Place
the jack at the designated loca
tions under the frame. The jacking
positions are plates welded to the
frame with two tabs and a raised
dot to index with the jack.
OGC064005OGS065004
Jack location
To reduce the possibility of injury,
be sure to use only the jack pro
vided with the vehicle and in the
correct jack position; never use
any other part of the vehicle for
jack support.
WARNING

6-19
What to do in an emergency
6
8. Insert the jack handle into the jackand turn it clockwise, raising the
vehicle until the tire clears the
ground. Make sure the vehicle is
stable on the jack. 9. Loosen the lug nuts with the wheel
lug nut wrench and remove them
with your fingers. Remove the
wheel from the studs and lay it flat
on the ground out of the way.
Remove any dirt or debris from
the studs, mounting surfaces, and
wheel.
10. Install the spare tire onto the studs of the hub.
11. Tighten the lug nuts with your fin gers onto the studs with the
smaller end of the lug nuts clos
est to the wheel.
12. Lower the vehicle to the ground by turning the jack handle coun
terclockwise. 13. Use the wheel lug nut wrench to
tighten the lug nuts in the order
shown. Doublecheck each lug
nut until they are tight. After
changing tires, we recommend
that an authorized HYUNDAI
dealer tighten the lug nuts to their
proper torque as soon as possi
ble.
The wheel lug nut should be
tightened to 9~11 kg.m (65~79
lb.ft).
OGS065007OGC064006

6-23
What to do in an emergency
6
When towing your vehicle in an
emergency without wheel dollies:
1. Place the ignition switch in the ACC position.
2. Place the shift lever in N (Neutral).
3. Release the parking brake.
Failure to place the shift lever in N
(Neutral) when being towed with the
front wheels on the ground can
cause internal damage to the
transaxle.
Removable towing hook
NOTICE
OGC064010OGC064015
OGC064011
n Frontn Rear
1. Open the trunk, and remove the
towing hook from the tool case.
2. Remove the hole cover pressing the lower part of the cover on the
front bumper.
3. Install the towing hook by turning it clockwise into the hole until it is
fully secured.
4. Remove the towing hook and install the cover after use.

6-24
What to do in an emergency
Emergency towing
If towing is necessary, we recom
mend you have it done by an author
ized HYUNDAI dealer or a commer
cial tow truck service. If towing service is not available in an
emergency, your vehicle may be
temporarily towed using a cable or
chain secured to the emergency tow
ing hook at the front (or rear) of the
vehicle.
Use extreme caution when towing
the vehicle with a cable or chain. A
driver must be in the vehicle to steer
it and operate the brakes.
Towing in this manner may be done
only on hardsurfaced roads for a
short distance and at low speeds.
Also, the wheels, axles, power train,
steering and brakes must all be in
good condition.
Always follow these emergency tow
ing precautions:
• Place the ignition switch in the
ACC position so the steering
wheel is not locked.
• Place the shift lever in N (Neutral).
• Release the parking brake.
• Depress the brake pedal with more force than normal since you will
have reduced braking performance.
• More steering effort will be required because the power steering system
will be disabled.
• Use a vehicle heavier than your own to tow your vehicle.
• The drivers of both vehicles should communicate with each other fre
quently.
• Before emergency towing, check that the hook is not broken or damaged.
• Fasten the towing cable or chain securely to the hook.
• Do not jerk the hook. Apply steady and even force.
OGC064012
OGC064013
nFront
n Rear