2016 Hyundai Creta ignition

7-49
7
Maintenance
If you connect unauthorized elec
tronic devices to the battery, the bat
tery may be discharged. Never use
unauthorized devices.
Battery capacity label
❈The actual battery label in the vehicle
may differ from the illustration.
1. MF45LBCI : The HYUNDAI model name of battery
2. 12V : The nominal voltage
3. 45Ah(20HR) : The nominal capac ity (in Ampere hours)
4. 80RC : The nominal reser ve capacity (in min.)
5. 410CCA : The coldtest current in amperes by SAE
6. 328A : The coldtest current in amperes by EN
Battery recharging
Your vehicle has a maintenancefree,
calciumbased battery.
• If the battery becomes dischargedin a short time (because, for exam
ple, the headlights or interior lights
were left on while the vehicle was
not in use), recharge it by slow
charging (trickle) for 10 hours.
• If the battery gradually discharges because of high electric load while
the vehicle is being used, recharge
it at 2030A for two hours.
Battery Replacing
Replacing a Battery is required pre
cautionary measures.
We recommend that you consult an
authorized HYUNDAI dealer.
NOTICE
•Never attempt to recharge the
battery when the battery cables
are connected.
•The electrical ignition system
works with high voltage. Never
touch these components with
the engine running or the igni
tion switched on.
Failure to follow the above warn
ings can result in serious bodily
injury or death.
OGS075056
■
Example

7-64
Maintenance
•When replacing a blown fuse or
relay with a new one, make sure
the new fuse or relay fits tightly into
the clips. The incomplete fastening
fuse or relay may cause the vehi
cle wiring and electric systems
damage and a possible fire.
•Do not remove fuses, relays and
terminals fastened with bolts or
nuts. The fuses, relays and termi
nals may be fastened incomplete
ly, and it may cause a possible fire.
If fuses, relays and terminals fas
tened with bolts or nuts are blown,
consult with an authorized
HYUNDAI dealer.
•Do not input any other objects
except fuses or relays into
fuse/relay terminals such as a driv
er or wiring. It may cause contact
failure and system malfunction.
(Continued)
(Continued)
•Check the blown fuse with the fuse
information on the fuse box cover.
•Replace the blown fuse on the
same place after turning off the
ignition switch and all electric
switches and disconnecting the
negative battery cable.
Instrument panel fuse replace
ment
1. Turn the ignition switch and allother switches off.
2. Open the fuse panel cover.
NOTICE
OGS075016

7-66
Maintenance
Information
If the fuse switch is OFF, the above
message will appear on instrument
cluster display.Engine compartment panel fuse
replacement
1. Turn the ignition switch and all other switches off.
2. Remove the fuse box cover by pressing the tab and pulling up the
cover.
3. Check the removed fuse; replace it if it is blown. To remove or insert
the fuse, use the fuse puller in the
engine compartment fuse panel.
4. Push in a new fuse of the same rating, and make sure it fits tightly
in the clips. If it fits loosely, we rec
ommend that you consult an
authorized HYUNDAI dealer.
After checking the fuse panel in the
engine compartment, securely install
the fuse panel cover. If not, electrical
failures may occur from water leak
ing in.
iNOTICE
OGS075019
OGS045120

7-76
Maintenance
ItemNameSymbolFuse RatingCircuit Protected
FUSE
IG140AW/o Button start: Ignition SW
With Button start: PDM Relay Block
B+150AInstrument Panel Fuse Block Fuse: FS14,FS05,FS13,FS17,FS10,FS02,FS09, IOD
relay(Leakage Current Auto cut)
Glow80AD4FC/D4FB: Glow Relay, Glow Plug
FUEL
HEATER30AD4FC/D4FB: Fuel heater
ECU 1'30A(Engine Control)Main Relay
FRONT WIPER25AWiper Motor(Front)
HORN15AHorn(Dual), Burglar Alarm Horn
FUEL PUMPFUEL
PUMP20AG4FC: Fuel Pump Relay, Fuel Pump Motor
C/FAN40A/50AG4FC(40A),Radiator Fan Motor
D4FC/D4FB(50A)Radiator Fan Motor
BLOWER40ABlower Motor
IG240AW/o Button Start : Start Relay, Start Solenoid, Ignition SW
With Button Start : Start Relay, Start Solenoid, PDM Relay Block
B+330AInstrument Panel Fuse Block Fuse: FS04, IPS4, IPS5
* G4FC : Gamma 1.6 (Gasoline), D4FC : UII 1.4 (Diesel), D4FB : UII 1.6 (Diesel)

7-77
7
Maintenance
ItemNameSymbolFuse RatingCircuit Protected
FUSE
B+250AInstrument Panel Fuse Block Fuse: FS03, P/window Relay, P/Outlet Relay
INJECTORINJECTOR15AG4FC: Injector(#1,#2,#3,#4)
BACK UPLAMPB/UP LAMP10ABack up switch(MT Only), Rear Combination Lamp LH/RH
IGN COILIGN COIL15AG4FC: Condenser, Ignition Coil Extn.
SENSOR 1610AG4FC: Variable Intake System Solenoid, Output Variable Cam(IN, EX),Purge
Control Solenoid Valve, Oxygen Sensor(UP, DN), IMMO
D4FB: Lambda Sensor, Stop SW, EGR Actuator, D4FC: Stop SW
ECU 3(20AD4FC/D4FB: ECU
G4FC: ECU(M/T),PCU(A/T)
RelayGlowD4FC/D4FB: Glow Plug
* G4FC : Gamma 1.6 (Gasoline), D4FC : UII 1.4 (Diesel), D4FB : UII 1.6 (Diesel)

Operating precautions for catalytic
converters (if equipped)
Your vehicle is equipped with a cat
alytic conver ter emission control
device.
Therefore, the following precautions
must be observed:
• Use only UNLEADED FUEL forGasoline engine.
• Do not operate the vehicle when there are signs of engine malfunc
tion, such as misfire or a noticeable
loss of performance.
• Do not misuse or abuse the engine. Examples of misuse are
coasting with the ignition off and
descending steep grades in gear
with the ignition off.
• Do not operate the engine at high idle speed for extended periods (5
minutes or more).
• Do not modify or tamper with any part of the engine or emission con
trol system. All inspections and
adjustments must be made by an
authorized HYUNDAI dealer. • Avoid driving with a extremely low
fuel level. Running out of fuel could
cause the engine to misfire, dam
aging the catalytic converter.
Failure to observe these precautions
could result in damage to the catalyt
ic converter and to your vehicle.
Additionally, such actions could void
your warranties.
Fire
•A hot exhaust system can ignite
flammable items under your
vehicle. Do not park, idle, or
drive the vehicle over or near
flammable objects, such as
grass, vegetation, paper,
leaves, etc.
•The exhaust system and catalyt
ic system are very hot while the
engine is running or immediate
ly after the engine is turned off.
Keep away from the exhaust
system and catalytic, you may
get burned. Also, do not remove
the heat sink around the
exhaust system, do not seal the
bottom of the vehicle or do not
coat the vehicle for corrosion
control. It may present a fire risk
under certain conditions.
WARNING
Maintenance
7-98