102
uuGauges and Multi-Information Display uMulti-Information Display
Instrument Panel
*1: Default Setting
*2: If equippedSetup Group Customizabl
e Features Description Selectable settings
Keyless
Access
Setup
Door Unlock ModeChanges which doors unlock when you press the
driver's door lock/unlock button.DRIVER DOOR ONLY*1/ALL
DOORS
Keyless Access Light
FlashCauses some exterior lights to blink when you
unlock/lock the doors.ON*1/ OFF
Keyless Access BeepCauses the beeper to sound when you unlock/lock
the doors.ON*1/OFF
Lighting
SetupInterior Light Dimming
TimeChanges the length of time the interior lights stay on
after you close the doors.60 sec, 30 sec*1, 15 sec
Auto Light Sensitivity*2Changes the timing for the headlights to come on.Max, High , Mid*1, Low , Min
16 CR-Z-31SZT6500.book 102 ページ ２０１５年９月１１日 金曜日 午前１１時４７分
134
uuOperating the Switches Around the Steering Wheel uWipers and Washers
Controls
Wipers and Washers
The windshield wipers and washers can be
used when the power mode is in ON.
■MIST
The wipers run at high speed until you release
the lever.
■Wiper switch (OFF, INT, LO, HI)
Change the wiper switch setting according to
the amount of rain.
■Adjusting wiper operation
Turn the adjustment ri ng to adjust wiper
operation.
■Washer
Sprays while you pull the lever toward you.
When you release the lever for more than one
second, the spray stops, the wipers sweep two
or three more times to clear the windshield,
then stop.
■Windshield Wiper/Washer1 Wipers and Washers
NOTICE
Do not use the wipers when the windshield is dry.
The windshield will get sc ratched, or the rubber
blades will get damaged.
NOTICE
In cold weather, the blades may freeze to the
windshield, becoming stuck.
Operating the wipers in th is condition may damage
the wipers. Use the defroster to warm the
windshield, then turn the wipers on.
If the vehicle speeds up while the wipers are
operating intermittently, the length of the wipe
interval shortens. When the vehicle starts moving, the
wipers make a single sweep.
When the vehicle speeds up, the wiper operation’s
shortest delay setting ( ) and the LO setting become
the same.
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
Intermittent Time
Adjustment Ring
HI: High speed wipe Pull to
use
washer.
LO
: Low speed wipe
INT: Intermittent OFF MISTLower speed, fewer sweeps
Higher speed, more sweeps
16 CR-Z-31SZT6500.book 134 ページ ２０１５年９月１１日 金曜日 午前１１時４７分
211
uuCustomized Features u
Features
*1:Default Setting
Setup
GroupCustomizable FeaturesDescriptionSelectable Settings
Camera
Rear
Camera
Fixed GuidelineSelects whether the guidelines come on the
rear camera monitor.On*1/ Off
Dynamic GuidelineSelects whether the guidelines adjust to the
steering wheel angle.On*1/Off
DefaultCancels/Resets all customized items in the
Rear Camera group as default.Yes/No
LaneWatch*
Show with Turn Signal
Selects whether the LaneWatch display comes
on when you move the turn signal lever to the
passenger side.
On*1/ Off
Display Time after Turn
Signal OffChanges the length of time the LaneWatch
display stays on after you pull the turn signal
lever back.
0 second*1/2 seconds
Reference LineSelects whether the reference lines come on
the LaneWatch monitor.On*1/ Off
DefaultCancels/Resets all customized items in the
LaneWatch group as default.Yes/No
Bluetooth Bluetooth On/Off Status
Changes the Bluetooth® status. On
*1/Off
Bluetooth Device List Pairs a new phone to HFL, edits or deletes a
paired phone, or cr
eates a security PIN.
2Phone Setup P. 220
—
Edit Pairing Code Edits the pairing code.
2
To change the pairing code setting P. 222Random/Fixed*1
Default Cancels/Resets all customized items in the
Bluetooth
group as default. Yes
/No
* Not available on all models
16 CR-Z-31SZT6500.book 211 ページ ２０１５年９月１１日 金曜日 午前１１時４７分
