2016 HONDA CR-Z stop start

313
uuMaintenance Under the Hood uChanging the Engine Oil and Oil Filter
Maintenance
6. Remove the oil filter and dispose of the
remaining oil.
7. Check that the filter gasket is not stuck to
the engine contact surface.
u If it is stuck, you must detach it.
8. Wipe away dirt and dust adhering to the
contact surface of the engine block, and
install a new oil filter.
u Apply a light coat of new engine oil to
the oil filter gasket.
9. Put a new washer on the drain bolt, then
reinstall the drain bolt.
u Tightening torque:
29 lbf∙ft (39 N∙m, 4.0 kgf∙m)
10. Pour the recommended engine oil into the
engine.
u Engine oil change capacity (including
filter):
3.8 US qt (3.6 L)
11. Reinstall the engine oil fill cap securely and
start the engine.
12. Run the engine for a few minutes, and
then check that there is no leak from the
drain bolt or oil filter.
13. Stop the engine, wait for three minutes,
and then check the oil level on the
dipstick.
u If necessary, add more engine oil.1Changing the Engine Oil and Oil Filter
You will need a special wrench to replace the oil
filter. You can buy this wrench from a dealer.
When installing the new oil filter, follow the
instructions supplied with the oil filter.
Reinstall the engine oil fill cap. Start the engine. The
low oil pressure indicator should go off within five
seconds. If it does not, turn off the engine, and check
your work.
Oil Filter
16 CR-Z-31SZT6500.book 313 ページ ２０１５年９月１１日　金曜日　午前１１時４７分

349
Handling the Unexpected
This chapter explains how to handle unexpected troubles.
ToolsTypes of Tools .................................. 350
If a Tire Goes Flat Temporarily Repairi ng a Flat Tire....... 351
Engine Does Not Start Checking the Engine ........................ 362
If the Smart Entry Remote Battery is Weak .......................................... 364
Emergency Engine Stop ................... 365
Jump Starting .................................... 366
Shift Lever Does Not Move .............. 369Overheating
How to Handle Overheating............. 370
Indicator, Coming On/Blinking
If the Low Oil Pressure Indicator Comes On ............................................. 372
If the 12V Battery Charging System
Indicator Comes On ....................... 373
If the Malfunction Indicator Lamp Comes On or Blinks ................................... 374
If the Brake System Indicator (Red) Comes On or Blinks ................................... 375
If the Electric Power Steering (EPS) System Indicator Comes On............................ 375
If the Brake System Indicator (Red) comes on or blinks at the same time when the Brake
System Indicator (Amber) comes on .... 376
If the IMA Indicator Comes On ........ 377
If the Low Tire Pressure/TPMS Indicator Comes On or Blinks ....................... 377
Fuses
Fuse Locations ................................. 378
Inspecting and Changing Fuses ........ 382
Emergency Towing ........................... 383
When You Cannot Open the Hatch ..... 385
16 CR-Z-31SZT6500.book 349 ページ ２０１５年９月１１日　金曜日　午前１１時４７分

362
Handling the Unexpected
Engine Does Not Start
Checking the Engine
If the engine does not start, check the starter.
Starter conditionChecklist
Starter doesn’t turn or turns
over slowly.
The 12-volt battery may be dead.
Check each of the items on the
right and respond accordingly.Check for a message on the multi-information display.
●If the TO START, HOLD REMOTE NEAR START BUTTON message appears
2If the Smart Entry Remote Battery is Weak P. 364
uMake sure the smart entry remote is in its operating range.
2 ENGINE START/STOP Button P. 126
Check the brightness of the interior lights.
Turn on the interior lights and check the brightness.
●If the interior lights are dim or do not come on at all
2Checking the 12-Volt Battery P. 340●If the interior lights come on normally

2Inspecting and Changing Fuses P. 382
1Checking the Engine
If you must start the vehi cle immediately, use an
assisting vehicle to jump start it.
2 Jump Starting P. 366
16 CR-Z-31SZT6500.book 362 ページ ２０１５年９月１１日　金曜日　午前１１時４７分

364
uuEngine Does Not Start uIf the Smart Entry Remote Battery is Weak
Handling the Unexpected
If the Smart Entry Remote Battery is Weak
If the beeper sounds, the TO START, HOLD REMO TE NEAR START BUTTON
message appears on the multi-information display, the indicator on the ENGINE
START/STOP button flashes, and the engine wo n’t start, start the engine as
follows. 1.Touch the center of the ENGINE START/
STOP button with the H logo on the smart
entry remote while the ENGINE START/
STOP button is flashing. The buttons on
the smart entry remote should be facing
you.
u The ENGINE START/STOP button
flashes for about 30 seconds.
2. Depress the brake pedal
*1 or clutch pedal*2
and press the ENGINE START/STOP
button within 10 seconds after the beeper
sounds and the ENGINE START/STOP
button changes from flashing to on.
u If you don’t depress the pedal, the mode
will change to ACCESSORY.
*1: Continuously variable transmission models
*2: Manual transmission models
16 CR-Z-31SZT6500.book 364 ページ ２０１５年９月１１日　金曜日　午前１１時４７分

365
uuEngine Does Not Start uEmergency Engine Stop
Handling the Unexpected
Emergency Engine Stop
The ENGINE START/STOP button may be used to stop the engine due to an
emergency situation even while driving. If you must stop the engine, do either of the
following operations:
• Press and hold the ENGINE START/STOP button for about two seconds.
• Firmly press the ENGINE START/STOP button twice.
The steering wheel will not lock. However, because turning off the engine disables
the power assist the engine provides to the steering and braking systems, it will
require significantly more physical effort an d time to steer and slow the vehicle. Use
both feet on the brake pedal to slow down the vehicle and stop immediately in a
safe place. With manual transmission models you can also downshift the
transmission to utilize engine braking.
The power mode is in ACCESSORY when the engine is stopped.
To change the mode to VEHICLE OF F, change the gear position to
(P after the
vehicle comes to a complete stop.
Then press the ENGINE START/STOP button twice without depressing the brake
pedal.
The power mode changes to VEHICLE OFF.
1 Emergency Engine Stop
Do not press the button while driving unless it is
absolutely necessary for th e engine to be switched
off.
Continuously variable transmission for U.S. models
Continuously variable transmission for Canadian models
Manual transmission models
16 CR-Z-31SZT6500.book 365 ページ ２０１５年９月１１日　金曜日　午前１１時４７分

371
uuOverheating uHow to Handle Overheating
Handling the Unexpected
■Next thing to do
1.Check that the cooling fan is operating and
stop the engine once the high temperature
indicator goes off.
u If the cooling fan is not operating,
immediately stop the engine.
2. Once the engine has cooled down, inspect
the coolant level and check the cooling
system components for leaks.
u If the coolant level in the reserve tank is
low, add coolant until it reaches the
MAX mark.
u If there is no coolant in the reserve tank,
check that the radiator is cool. Cover the
radiator cap with a heavy cloth and open
the cap. If necessary, add coolant up to
the base of the filler neck, and put the
cap back on.
■Last thing to do
Once the engine has cooled sufficiently, restart it and check the high temperature
indicator.
If the high temperature indicator is off, resume driving. If it stays on, contact a dealer
for repairs.
1 How to Handle Overheating
If the coolant is leaking, contact a dealer for repairs.
Use water as an emergency/temporary measure only.
Have a dealer flush the system with proper antifreeze
as soon as possible.
3WARNING
Removing the radiator cap while the
engine is hot can cause the coolant to spray
out, seriously scalding you.
Always let the engine and radiator cool
down before removing the radiator cap.MAX
MIN
Reserve
Tank
16 CR-Z-31SZT6500.book 371 ページ ２０１５年９月１１日　金曜日　午前１１時４７分

372
Handling the Unexpected
Indicator, Coming On/Blinking
If the Low Oil Pressure Indicator Comes On
■Reasons for the indicator to come on
Comes on when the engine oil pressure is low.
■What to do as soon as the indicator comes on
1. Immediately park the vehicle on level ground in a safe place.
2. If necessary, turn the ha zard warning lights on.
■What to do after parking the vehicle
1. Stop the engine and let it sit for about three minutes.
2. Open the hood and check the oil level.
u Add oil as necessary.
2 Oil Check P. 310
3.Start the engine and check the low oil pressure indicator.
u The light goes off: Start driving again.
u The light does not go off within 10 seconds: Stop the engine and
contact a dealer for repairs immediately.
1If the Low Oil Pressure Indicator Comes On
NOTICE
Running the engine with low oil pressure can cause
serious mechanical damage almost immediately.
16 CR-Z-31SZT6500.book 372 ページ ２０１５年９月１１日　金曜日　午前１１時４７分

373
uuIndicator, Comin g On/BlinkinguIf the 12V Battery Charging System Indicator Comes On
Handling the Unexpected
If the 12V Battery Chargin g System Indicator Comes
On
■Reasons for the indicator to come on
Comes on when the 12-volt battery is not being charged.
■What to do when th e indicator comes on
Turn off the climate control system, rear defogger, and other electrical
systems, and immediately co ntact a dealer for repairs.
1If the 12V Battery Charging System Indicator Comes On
If you need to stop temporarily, do not turn off the
engine. Restarting the engi ne may rapidly discharge
the 12-volt battery.
This indicator may also come on when the Auto Idle
Stop function is activated for a while. Restart the
engine. 2 Auto Idle Stop P. 267
This indicator may also come on when the IMA
battery charge drops below a desired level.
The engine starts to recharge the battery.
2 Auto Idle Stop P. 264
The indicator goes off when the battery is being
charged normally.
This indicator may blink after starting when the
outside temperature is belo w -20°F (-30°C). It will
stop blinking after the IMA battery warms up.
Manual transmission models
Continuously variable transmission models
16 CR-Z-31SZT6500.book 373 ページ ２０１５年９月１１日　金曜日　午前１１時４７分