38 || 39
VEHICLE CONTROLS
VEHICLE CONTROLS
Wiper Operation
The windshield wipers and washers can be used when the vehicle is on. Move the wiper lever up or down to the desired position.
*if equipped
Pull to use
washer.
MIST OFF
INT: Low speed intermittent LO: Low speed wipe HI: High speed wipe
Headlight-Wiper Integration*
When the headlights are in the AUTO position, they automatically turn on when the
front wipers operate several times within a certain interval. The headlights turn off
shortly after the wipers are turned off, or if there is enough ambient light.
Do not use the wipers when the windshield is dry. The windshield may scratch, or the rubber blades may become damaged.
In cold weather, the blades may freeze to the windshield, becoming stuck.
Operating the wipers in this condition may damage the wipers. Use the defroster
to warm the windshield, or manually clear the windshield of ice and snow before turning on the wipers.
NOTICE
Intermittent (INT) Wipers*
When you move the lever to the INT position, the wipers operate based on the delay adjustment.
Rotate the adjustment ring to adjust the wiper delay.
Rotate the adjustment ring.
Lower speed, fewer sweeps Higher speed, more sweeps
INT position
Automatic (AUTO) Rain-Sensing Wipers*
When you move the lever to the AUTO position while
driving in rainy weather, the wipers operate based on the amount of detected rainfall. Put the lever in the AUTO position only when driving
in rainy weather. Rotate the adjustment ring to adjust the rainfall
sensor sensitivity. Return the lever to the OFF position when rain stops.
Rotate the adjustment ring.
Low sensitivity: Wipers operate whenmore rainfall is detected. High sensitivity: Wipers operate whenless rainfall is detected.
AUTO position
Always ensure the wiper lever is in the OFF position before entering a car wash to prevent severe damage to the windshield wiper system.
NOTICE
*if equipped
