2016 HONDA CIVIC COUPE ignition

83
uuIndicatorsu
Continued
Instrument Panel
*1:Models with the smart entry system have an ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
System Message
Indicator*
●
Comes on for a few seconds when
you turn the ignition switch to ON
(w *1
, then goes off.
● Comes on along with a beep
when a problem is detected. A
system message on the driver
information interface appears at
the same time.
●While the indicator is on, press the
(display/information) button to see the
message again.
● Refer to the Indicators information in this
chapter when a system message appears
on the driver information interface. Take
the appropriate action for the message.
● The driver information interface does not
return to the normal screen unless the
warning is canceled, or the button
is pressed.
—
Turn Signal and
Hazard Warning Indicators
●Blink when you operate the turn
signal lever.
● Blink along with all turn signals
when you press the hazard
warning button.●
Does not blink or blinks rapidly - A
turn signal light bulb has blown. Change
the bulb immediately. 2Replacing Light Bulbs P. 502, 505
—
High Beam
Indicator●
Comes on when the high beam
headlights are on.——
Lights On
Indicator
●Comes on whenever the light
switch is on, or in AUTO*
when
the exterior lights are on.● If you remove the key from the ignition
switch *1
while the exterior lights are on, a
chime sounds when the driver's door is
opened.
—
Fog Light
Indicator *●
Comes on when the fog lights are on.
——
* Not available on all models
16 CIVIC 2D HC２ (０A ０１ ０C)-31TBG6000.book 83 ページ >0>.>/６年>0月>/>0日　金 曜日　午後４時>/６分

84
uuIndicatorsu
Instrument Panel
*1:Models with the smart entry system have an ENGINE START/STOP button instead of an ignition switch.
*2:Canadian models only: Apply and hold the brake pedal before turning the ignition on.
IndicatorNameOn/BlinkingExplanationMessage *
Immobilizer
System Indicator
●
Blinks if the immobilizer system
cannot recognize the key information.● Blinks - You cannot start the engine. Turn
the ignition switch to LOCK
(0 *1
, pull the
key out *2
, and then insert the key and turn
it to ON
(w *1
again.
● Repeatedly blinks - The system may be
malfunctioning. Have your vehicle
checked by a dealer.
● Do not attempt to alter this system or add
other devices to it. Electrical problems can
occur.
—
Security System Alarm Indicator
●Blinks when the security system
alarm has been set.
2 Security System Alarm P. 136—
Indicator
Indicator
* Not available on all models
16 CIVIC 2D HC２ (０A ０１ ０C)-31TBG6000.book 84 ページ >0>.>/６年>0月>/>0日　金 曜日　午後４時>/６分

86
uuIndicatorsu
Instrument Panel
*1:Models with the smart entry system have an ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
Brake
Depressing
Indicator*
●
Comes on for a few seconds when
you turn the ignition switch to ON
(w *1
, then goes off.
● Blinks when the electric parking
brake switch is pressed without
depressing the brake pedal while
the electric parking brake is in operation.
● Blinks while driving - Press the electric
parking brake switch with the brake pedal
depressed. 2Parking Brake P. 445
—
●
Blinks when the automatic brake
hold button is pressed without
depressing the brake pedal while
the automatic brake hold is in operation.
● Blinks if the automatic brake hold
is automatically canceled while it is in operation. The beeper
sounds.
● Blinks while driving - Press the
automatic brake hold button with the
brake pedal depressed. 2Automatic Brake Hold P. 448
● Immediately depress the brake pedal.
—
Continuously
variable
transmission
models
Manual
transmission
models
Electric Parking Brake System
Automatic Brake Hold System
* Not available on all models
16 CIVIC 2D HC２ (０A ０１ ０C)-31TBG6000.book 86 ページ >0>.>/６年>0月>/>0日　金 曜日　午後４時>/６分

87
uuIndicatorsu
Continued
Instrument Panel
*1:Models with the smart entry system have an ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
Road Departure Mitigation (RDM)
Indicator*
●
Comes on for a few seconds
when you turn the ignition switch
to ON
(w *1
, then goes off.
● Comes on if there is a problem
with the RDM system.
●Stays on constantly - Have your vehicle
checked by a dealer.
● Comes on when the RDM system
shuts itself off.●Stays on - The temperature inside the
camera is too high.
Use the climate contro l system to cool
down the camera.
The system activates when the
temperature inside the camera cools
down. 2Front Sensor Camera *
P. 408
● Stays on - The area around the camera is
blocked by dirt, mud, etc. Stop your vehicle in a safe place, and wipe it off with
a soft cloth.
● Have your vehicle checked by a dealer if
the indicator and message come back on
after you cleaned the area around the
camera.
2Front Sensor Camera *
P. 408
* Not available on all models
16 CIVIC 2D HC２ (０A ０１ ０C)-31TBG6000.book 87 ページ >0>.>/６年>0月>/>0日　金 曜日　午後４時>/６分

88
uuIndicatorsu
Instrument Panel
*1:Models with the smart entry system have an ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
Adaptive Cruise Control (
ACC)
with Low Speed
Follow (LSF) Indicator (Amber) *
●
Comes on for a few seconds when you turn the ignition switch to ON
(w *1
, then goes off.
● Comes on if there is a problem
with ACC with LSF.
●Comes on while driving - Have your
vehicle checked by a dealer.
● Comes on if anything covers the
radar sensor cover and prevents
the sensor from detecting a
vehicle in front.
● May come on when driving in bad
weather (rain, snow, fog, etc.)
● ACC with LSF has been
automatically canceled.●When the radar sensor gets dirty, stop
your vehicle in a safe place, and wipe off
dirt using a soft cloth.
● Have your vehicle checked by a dear if the
indicator does not go off even after you
clean the sensor cover.
Adaptive Cruise Control ( ACC)
with Low Speed
Follow (LSF) Indicator
(Green) *
●
Comes on when you press the
MAIN button.2Adaptive Cruise Control (ACC) with
Low Speed Follow (LSF) *
P. 410—
● Comes on if the temperature
inside the camera is too high.
● ACC with LSF has been
automatically canceled.●Use the climate control system to cool
down the camera.
● Goes off - The camera has been cooled
down. Pressing the MAIN button can
resume the system. 2Front Sensor Camera *
P. 408
2 Adaptive Cruise Control (ACC) with
Low Speed Follow (LSF) *
P. 410
* Not available on all models
16 CIVIC 2D HC２ (０A ０１ ０C)-31TBG6000.book 88 ページ >0>.>/６年>0月>/>0日　金 曜日　午後４時>/６分

89
uuIndicatorsu
Continued
Instrument Panel
*1:Models with the smart entry system have an ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
Lane Keeping Assist System (
LKAS ) Indicator
(Amber) *●
Comes on for a few seconds
when you turn the ignition switch
to ON
(w *1
, then goes off.
● Comes on if there is a problem
with the LKAS.
● Stays on constantly - Have your vehicle
checked by a dealer.
Lane Keeping Assist System ( LKAS ) Indicator
(Green) *
●
Comes on when you press the
MAIN button.2Lane Keeping Assist System (LKAS) *

P. 428—
● Comes on if the temperature
inside the camera is too high.
● The LKAS has been automatically canceled.●
Use the climate control system to cool
down the camera.
● Goes off - The camera has been cooled
down. Pressing the LKAS button can
resume the system. 2Front Sensor Camera *
P. 408
2 Lane Keeping Assist System (LKAS) *

P. 428
● Comes on when the area around
the camera is blocked by dirt,
mud, etc. Stop your vehicle in a
safe place, and wipe it off with a
soft cloth.
● May come on when driving in bad
weather (rain, snow, fog, etc.)● Have your vehicle checked by a dealer if
the indicator and message come back on
after you cleaned the area around the
camera.
* Not available on all models
16 CIVIC 2D HC２ (０A ０１ ０C)-31TBG6000.book 89 ページ >0>.>/６年>0月>/>0日　金 曜日　午後４時>/６分

90
uuIndicatorsu
Instrument Panel
*1:Models with the smart entry system have an ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
Collision
Mitigation Braking
SystemTM

(CMBS TM
)
Indicator *
●
Comes on for a few seconds when
you turn the ignition switch to ON
(w *1
, then goes off.
● Comes on when you deactivate the CMBS TM
. A driver information
interface message appears for five
seconds.
● Comes on if there is a problem
with the CMBS TM
.
● Stays on constantly without the
CMBS TM
off - Have your vehicle checked
by a dealer. 2Collision Mitigation Braking System TM
(CMBS TM
)*
P. 453
● Comes on if the CMBS TM
is
deactivated temporarily after the
battery has been disconnected,
then re-connected.● Drive a short distance at more than 12
mph (20 km/h). The indicator should go
off. If it does not, have your vehicle checked by a dealer.
●Comes on when the CMBS TM

system shuts itself off.● Stays on - The area around the camera is
blocked by dirt, mud, etc. Stop your
vehicle in a safe place, and wipe it off with
a soft cloth. 2Front Sensor Camera *
P. 408
● Stays on - The temperature inside the
camera is too high. Use the climate control
system to cool down the camera. The
system activates when the temperature
inside the camera cools down. 2Front Sensor Camera *
P. 408
* Not available on all models
16 CIVIC 2D HC２ (０A ０１ ０C)-31TBG6000.book 90 ページ >0>.>/６年>0月>/>0日　金 曜日　午後４時>/６分

95
uuIndicatorsuDriver Information Interface Warning and Information Messages*
Continued
Instrument Panel
MessageConditionExplanation
●
Appears when the electric parking brake switch is
pressed without depressing the brake pedal while
the electric parking brake is in operation.● Appears while driving - Press the electric parking
brake switch with the brake pedal depressed. 2Parking Brake P. 445
MessageConditionExplanation
●
Appears when you open the driver’s door while the
ignition key is in ACCESSORY
(q .
●
Turn the ignition switch to LOCK (0 , then remove the
key.
● Appears when you open the driver’s door while the
ignition key is in LOCK
(0 .
●
Remove the key from the ignition switch.
Continuously variable
transmission models
Manual transmission
models
Models without smart entry system
16 CIVIC 2D HC２ (０A ０１ ０C)-31TBG6000.book 95 ページ >0>.>/６年>0月>/>0日　金 曜日　午後４時>/６分