2016 FORD F150 roof

CLIMATE CONTROLLED FRONT SEATS*
To operate the heated feature, press
repeatedly to
cycle through the various settings and off.
To operate the cooled feature, press
repeatedly to
cycle through the various settings and off. The cooled
seats will function only when the engine is running.
Note: More lights indicate higher settings.
REAR HEATED SEATS*
The rear-seat heat controls are on the back of the center console. To operate the
heated seats, press
repeatedly to cycle through the various settings and off.
The indicator light illuminates when you switch the heated seats on.
Note: When the ignition is in the on position, press the heated seat switch to
enable heating mode. The heated seats turn off automatically when you switch
off the engine. OVERHEAD CONSOLE*
From right to left, the controls operate the following functions:
Driver Lighting Controls

Driver map lamp: Press to switch on and off.
Overhead dome light: Press to switch on and off.
Door open overhead dome light: Press to override the dome lamp
automatically turning on.
Moonroof Controls*

Moonroof open button: Press to open. The moonroof stops short of the fully
opened position. To open the moonroof fully, press the open button again.

Moonroof close button: Press to close.

Moonroof vent button: Press to vent.
Sunshade Controls*

Sunshade open button: Press to open. The sunshade opens automatically
with the moonroof. You can also open the sunshade with the
moonroof closed.

Sunshade close button: Press to close.
Note: The sunshade stops short of a full-open
position for the comfort of rear passengers. To
open the sunshade fully, press the control again.
Passenger Lighting Control
Passenger map lamp: Press to switch on
and off.
Function
18 – 19
Comfort
360-DEGREE CAMERA*
The system consists
of front, side and
rear cameras. Press
the control to toggle
through different
camera views to see:
• What is directly in front or behind your vehicle.
• Cross traffic view in front and behind your vehicle.
Refer to the Parking Aids chapter in your Owner’s
Manual for more information.
REAR SENSING SYSTEM*
This system can warn you if there is an object behind
the vehicle. A warning tone sounds and increases in
frequency as you get closer to the object. It sounds a
continuous warning when the object is less than
12 inches (30 cm) away. The system is not effective
when the vehicle is traveling above 3 mph (5 km/h)
and may not detect angular or moving objects.
Note: Visibility aids do not replace the need to
watch where the vehicle is moving. Refer to your
Owner’s Manual for safety information, more
details and limitations. MYKEY
®
MyKey allows you to program certain driving
restrictions in order to promote good driving habits.
You can program speed restrictions, limited volume
levels and more, depending on your vehicle's level of
equipment. For complete information, refer to the
MyKey chapter in your Owner’s Manual.
ACTIVE PARK ASSIST*
The system detects an available parallel parking
space and automatically steers the vehicle into the
space (hands-free) while you control the accelerator,
gearshift and brakes. The system visually and audibly
instructs you to park your vehicle.
To use active park assist, press the button

located on the center console near the gearshift lever.
To stop the parking procedure, grab the steering wheel
or press the control again. Before using this feature
and for complete information, refer to the Parking
Aids chapter of your Owner’s Manual.
Note: The driver is always responsible for controlling
the vehicle, supervising the system, and intervening,
if required. LANE KEEPING SYSTEM*
The system notifies you to stay in your lane through
the steering system and the instrument cluster display
when the front camera detects an unintentional
drift out of your lane is likely to occur. The system
automatically detects and tracks the road lane
markings using a camera mounted behind the interior
rear view mirror.
Press the button
located on the center console
to switch the system on or off.
BLIS
® (BLIND SPOT
INFORMATION SYSTEM)
AND CROSS TRAFFIC ALERT*
BLIS aids you in detecting vehicles that may have
entered into your blind spot zone. The cross traffic
alert feature warns you of vehicles approaching from
the sides when the transmission is in reverse (R).
BLIS and cross traffic alert will display a yellow
indicator light in your exterior mirrors. Cross traffic
alert will also sound tones and display messages to
warn you which direction vehicles are approaching.
Refer to the Driving Aids chapter in your Owner’s
Manual for more information.
*if equipped
*if equipped*if equipped

REMOTE ENTRY SYSTEM FEATURES*
Press
once to unlock the driver door. Press again within three seconds to
unlock all of the doors and tailgate*.
Press
once to lock all the doors and the tailgate*. Press again within three
seconds to confirm that you closed and locked all of the doors and tailgate*.
Press
to activate the panic alarm. Press again or switch the ignition on to
deactivate the panic alarm.
Car finder: Press
twice within three seconds. The horn sounds and the
direction indicators flash. We recommend that you use this method to locate
your vehicle, rather than using the panic alarm.
REMOTE TAILGATE RELEASE*
With the tailgate unlocked, you can open the power tailgate by using the
remote transmitter. Press
twice within three seconds.
POWER RUNNING BOARDS*
The running boards automatically extend down and out when you open the
door. This can help you enter and exit your vehicle. When you close the doors,
the running boards return to the stowed position after a two-second delay. To
operate the Power Deploy feature manually, use the information display.
Set the running boards in the deployed position (OUT) to access the roof.
The running boards return to the stowed position and enter automatic mode
when the vehicle speed exceeds 5 mph (8 km/h). TAILGATE STEP*
Use the step to make entering the truck bed easier. This feature includes a
step-up into the box and a handle. These items store inside the tailgate.
To Use
1.
Lower the tailgate.
2. Push the button in the center of the tailgate moulding. The step pops
out slightly.
3. Pull the step out fully and lower it to the lowest position.
4. Pull the yellow handle stop toward you and out of the tailgate.
5. Rotate the handle up from a horizontal position to a vertical one until
you hear a sound, indicating that the handle locked into place.
To Close
1. Store the telescoping handle first. Press button 1 to lower the
telescoping handle.
2. Push button 2 to unlock the handle. Rotate the handle down to a horizontal
position, and then slide it back into the tailgate.
3. Raise the step up and then push it into the tailgate fully to secure.
BOX SIDE STEP*
Use the step for easier access to the trunk bed.
To Use
Push down on the release lever with your foot.
The step automatically extends from the
stowed position.
Push the step under the truck with your foot until it fully latches. Do not push
on the release lever while attempting to stow the step. CARGO AND TRAILER HOOKUP LAMPS*
The cargo lamps are positioned in the central high mounted stop lamp and
to either side of the cargo box. The trailer hookup lamp is positioned on the
tailgate next to the handle. Use the control in the box or on the instrument
panel to switch the lights on and off.
Note: The box lights turn off automatically after 10 minutes, fading
gradually to off.
BOXLINK™ CLEATS*
These cleats attach to the inner box walls to help you to tie down cargo. Lock
the cleats to prevent removal and unlock them for removal.
You can take the cleats out to attach accessories, upfitter package items and
more. See your Owner's Manual for complete details.
Function
You can enable and disable the power running board feature in the
information display. See the Information Display section in your
Owner's Manual for details.
Note: Do not use any part of the power running boards to lift your vehicle
when jacking. Always use proper jacking points. See your Owner’s Manual
for details.
*if equipped
20 – 21
*if equipped*if equipped