14*if equipped*if equipped15
Liftgate continuedLiftgate
Manual Liftgate
To Open the Liftgate 1. Unlock all the vehicle doors.
2. Press the button located inside the liftgate pull cup
handle to unlatch the liftgate.
3. Pull on the outside handle to raise the liftgate.
Power Liftgate*
Note: If the vehicle is running,the liftgate operates only
with the transmission in park (P).
Touch a button to open or close the liftgate:
Press
twice within three seconds on your remote entry
transmitter or the button on the instrument panel. A
tone sounds when the liftgate starts to close. You Can Also Open the
Liftgate from the Rear
of
Your Vehicle
1. Make sure you unlock your
liftgate first and then press
the button in the top of the
liftgate pull cup handle.
2. Allow the power system
to open the liftgate after
pressing the control.
3. To close, press and release
the control pictured below.
When the liftgate begins to
close, a tone sounds.
Setting the Liftgate
Open Height
Once you open the power
liftgate, you can move it
manually to a desired height.
If the previously programmed
liftgate height is lower than the
fully opened position, you can
manually push it upward. To Program a New Height
1. Open the liftgate.
2.
Stop the liftgate movement
by pressing the control button
on the liftgate when it reaches
your desired height. Once the
liftgate stops moving, you can
also move it manually to your
desired height.
3. Press and hold the control
button on the liftgate until
you hear a tone, indicating
that your programming of the
liftgate height is successful.
The liftgate then opens to its
newly programmed height when
you use the power feature to
open it.
To change the programmed
height, repeat the process above.
Obstacle Detection
When you use the power
open or close feature and the
liftgate detects a problem, it
sounds warning tones and the
liftgate stops.
The Liftgate Cannot Power
Open or Close When
• It detects an object in its
opening or closing path. •
The vehicle battery does not
have enough charge to power
the liftgate.
• The ignition is on and
the transmission is not
in park (P).
• You are traveling at speeds at
or above 1 mph (1 km/h).
Note: Entering the vehicle while
the liftgate is closing could
cause the vehicle to bounce and
activate obstacle detection.
Hands-Free
Liftgate Operation*
To Open Your Liftgate
Hands-Free While You Are
at the Liftgate
1. Make sure you have
an intelligent access
transmitter* within
3 feet (1 meter) and
behind the liftgate.
2. Move your foot under
and away from the
rear bumper using a
single kicking motion.
Do not move your
foot sideways or
the sensors may not
detect the motion. Note:
In vehicles equipped
with the towing package
and the hands-free power
liftgate feature, you must
kick your foot between
the trailer hitch and the
exhaust system. Do not
kick under the hitch.
