2016 DODGE DART brake

[x] Cancel search: brake

Page 417 of 671

DODGE DART 2016 PF / 1.G Owners Manual STARTING PROCEDURES
Before starting your vehicle, adjust your seat, adjust both
inside and outside mirrors, and fasten your seat belts.
WARNING!
•Never use the PARK position as a substitute for the

Page 418 of 671

DODGE DART 2016 PF / 1.G Owners Manual NOTE:
•The engine will not start unless the clutch pedal is
pressed to the floor.
• If the key will not turn and the steering wheel is
locked, rotate the wheel in either direction to relieve
press

Page 419 of 671

DODGE DART 2016 PF / 1.G Owners Manual 4. If you wish to stop the cranking of the engine prior tothe engine starting, push the button again.
NOTE: Normal starting of either a cold or a warm engine
is obtained without pumping or pressing th

Page 423 of 671

DODGE DART 2016 PF / 1.G Owners Manual •The engine block heater will require 110 Volts AC and
6.5 Amps to activate the heater element.
• The engine block heater must be plugged in at least
one hour to have an adequate warming effect on

Page 425 of 671

DODGE DART 2016 PF / 1.G Owners Manual Downshifting
Moving from a high gear down to a lower gear is
recommended to preserve brakes when driving down
steep hills. In addition, downshifting at the right time
provides better acceleration when

Page 427 of 671

DODGE DART 2016 PF / 1.G Owners Manual Manual Transmission Shift Speeds in MPH (KM/H)
Gear Selection 6 to 5 5 to 44 to 33 to 2 2 to 1
Maximum Speed 80 (129)
70 (113) 50 (81)30 (48) 15 (24)
CAUTION!
If you skip a gear while downshifting or

Page 428 of 671

DODGE DART 2016 PF / 1.G Owners Manual NOTE:You must press and hold the brake pedal while
shifting out of PARK.
WARNING!
• It is dangerous to shift out of PARK or NEUTRAL
if the engine speed is higher than idle speed. If
your foot is not

Page 429 of 671

DODGE DART 2016 PF / 1.G Owners Manual WARNING!(Continued)
•When leaving the vehicle, always remove the key
fob from the ignition and lock your vehicle. If
equipped with Keyless Enter-N-Go, always make
sure the keyless ignition node is i