2016 Citroen GRAND C4 PICASSO RHD light

212
To make your approach to the vehicle easier, these   illuminate:
-
 
t
he   zones   facing   the   driver’s   and  
p

assenger’s
 do
ors,
-
 
t
he   zones   for ward   of   the   door   mirrors   and  
r

ear ward   of   the   front   doors.
Door mirror spotlamps
Switching on
Switching off
They go off automatically after 30 seconds.
Exterior welcome lighting
Switching on
F Press  the   open   padlock   on   the  r
emote   control   or   one   of   the   front  
d

oor   handles   with   Keyless   Entry  
an

d
 S
tarting.
Front daytime running
lamps
(light-emitting diodes)
They come on automatically when the engine is   started,   when   the   lighting   control   stalk   is   in  
p

osition " 0" or " AUTO ".
In
  some   weather   conditions   (e.g.   low  
t

emperature   or   humidity),   the   presence  
o

f   misting   on   the   internal   sur face   of   the  
g

lass   of   the   headlamps   and   rear   lamps  
i

s   normal;   it   disappears   after   the   lamps  
h

ave   been   on   for   a   few   minutes. The
  remote   switching   on   of   the   lighting   makes  
y

our approach to the vehicle easier in poor
light.   It   is   activated   when   the   lighting   control  
i

s in the "
AUTO"   position   and   the   level   of   light  
d

etected   by   the   sunshine   sensor   is   low.
Switching off
The exterior welcome lighting switches off a
utomatically   after   a   set   time,   when   the   ignition  
i

s   switched   on   or   on   locking   the   vehicle.
When
 
the
 
courtesy
 
lamp
 
is
 
in
 
this
 
p

osition,
 
the
 
spotlamps
 
come
 
on
 au
tomatically:
-
 w
hen
 
you
 
unlock
 
the
 
vehicle,
-
 
w

hen
 
you
 
remove
 
the
 
electronic
 
key
 
from
 
t

he
 r

eader,
-
 
w

hen
 
you
 
open
 
a
 
door,
-
 
when you use the remote control to locate the vehicle.
The dipped beam headlamps and sidelamps c ome   on;   your   vehicle   is   also   unlocked.
Lighting and visibility

213
To avoid causing a nuisance to other road users,   the   headlamps   should   be   adjusted  
a

ccording   to   the   load   in   the   vehicle.
0.
 1

  or   2   people   in   the   front   seats.
-.
 I

ntermediate
 s
etting.
1.
 5

  people   +   maximum   authorised   load.
-.
 I

ntermediate
 s
etting.
2.
 D

river   +   maximum   authorised   load.
-.
 I

ntermediate
 s
etting.
3.
 5

  people   +   maximum   load   in   the   boot.
Adjusting the headlamp 
b

eam
 hei
ght
The initial setting is position "0".
Programming
The activation, deactivation and choice of w
elcome   lighting   duration   are   done   in   the   touch  
s

creen
 t
ablet.
In the Driving
 

menu,   select   the   "Settings "
tab then " Lighting"
  and   select   "Welcome
lighting ".
Use
  the   arrows   or   the   cursor   to   adjust   the  
d

uration   of   the   lighting.
Direction indicators
F Left:  lower   the   lighting   stalk   passing   the  p
oint   of   resistance.
F
 
R
ight:   raise   the   lighting   stalk   passing   the  
p

oint   of   resistance.
Three flashes of the direction
indicators
F Press  briefly   upwards   or   downwards,  w
ithout   going   beyond   the   point   of  
r

esistance;   the   direction   indicators   will  
f

lash   3   times.
5
Lighting and visibility

214
Cornering lighting
This system, if fitted to your vehicle, makes use   of   the   beam   from   a   front   foglamp   to  
i

lluminate   the   inside   of   a   bend,   when   the  
m

ain   or   dipped   beam   headlamps   are   on   and  
t

he   vehicle   speed   is   below   25   mph   (40   km/h)  
(

urban   driving,   winding   road,   junctions,   parking  
m

anoeuvres...). with cornering lighting
without cornering lighting
Switching on
This system starts:
-  w hen   the   corresponding   direction   indicator  
i

s   switched   on,
or
-
 
f
rom   a   certain   angle   of   rotation   of   the  
s

teering
 w
heel.
Switching off
The system does not operate:
-  b elow   a   certain   angle   of   rotation   of   the  
s

teering
 w
heel,
-
 
a
bove   25   mph   (40   km/h),
-
 
w
hen   reverse   gear   is   engaged.
The
  cornering   lighting   can   be   activated   or  
d

eactivated   in   the   Driving
 
menu.
F

Sel
ect the " Settings " tab, then " Lighting"
and
  "Directional headlamps ".
Lighting and visibility

215
Directional lighting
When the dipped or main beam headlamps are o
n,   this   system   allows   the   light   beams   to   better  
f

ollow   the   road.
Associated
  with   xenon   headlamps,   this   system  
i

mproves   the   quality   of   lighting   when   cornering.
with directional lighting
without directional lightingOperating fault
This system is inactive:
-  w hen   stationary   or   at   low   speeds,
-
 w

hen
 r
everse
 is enga
ged. If
  a   fault   occurs,   these   warning   lamps  
c

ome   on   in   the   instrument   panel,  
a

ccompanied   by   an   audible   signal  
a

nd   a   message.
Contact   a   CITROËN   dealer   or   a   qualified  
w

orkshop.
The   directional   lighting   can   be   activated   or  
d

eactivated   in   the   touch   screen   tablet.
In the Driving
 

menu,   select   the   "Settings "
tab, then " Lighting"
  and   select   "Directional
headlamps ".
5
Lighting and visibility

216
Wiper control stalk
Programming
Your vehicle may also include some functions that   can   be   configured:
-
 a

utomatic
 r
ain
 sen
sitive
 w
indscreen
 w
ipers,
-
 
r
ear   wiping   on   engaging   reverse   gear.
Manual controls
Windscreen wipers
Fast wipe (heavy rain).
N ormal   wipe   (moderate   rain).
Intermittent
  wipe   (proportional   to   the  
s

peed   of   the   vehicle).
Park.
Automatic
  wiping   (press   down,  
t

hen
 r
elease).
Single
  wipe   (pull   the   stalk   briefly  
t

owards   you).
The
 
wipers
 
are
 
controlled
 
directly
 
by
 
the
 
driver.
Wiping
 
speed   control   stalk:   raise   or   lower   the  
s

talk
 
to
 
the   desired   position.
Model without AUTO wiping
Model with AUTO wiping
Single wipe (press downwards or pull t
he   stalk   briefly   towards   you,   then  
r

elease).
or
In
 
wintry
 
conditions,
 
remove
 
snow,
 
ice
 
o

r
 
frost
 
present
 
on
 
the
 
windscreen,
 
a

round
 
the
 
wiper
 
arms
 
and
 
blades
 
and
 
t

he
 
windscreen
 
seal,
 
before
 
operating
 
t

he
 
wipers.
Do
 
not
 
operate
 
the
 
wipers
 
on
 
a
 
dry
 
w

indscreen.
 
Under
 
extremely
 
hot
 
or
 
c

old
 
conditions,
 
ensure
 
that
 
the
 
wiper
 b
lades
 
are
 
not
 
stuck
 
to
 
the
 
windscreen
 b
efore
 
operating
 
the
 
wipers. The
  front   wiper   system   includes   a  
s

afety   device   which   can   temporarily  
i

nhibit   operation   if   it   detects   obstacles  
s

uch   as   ice   or   snow.
Lighting and visibility

217
Rear wiper
Park.
If
 
a
 
significant
 
accumulation
 
of
 
snow
 
or
 
i

ce
 
is
 
present,
 
deactivate
 
the
 
automatic
 
r

ear
 
wiper. Intermittent
  wipe.
Wash-wipe
  (set   duration).
Rear
 
wiper   selection   ring:
Reverse gear
When reverse gear is engaged, the rear wiper w
ill   come   into   operation   if   the   windscreen  
w

ipers   are   operating.
This
  function   can   be   deactivated   in   the   Driving
menu.
Select the " Settings" tab, then " Driving aids"
and
  "Rear wiper in reverse ".
5
Lighting and visibility

218
Windscreen wash and washer jets
Windscreen wash
Adjusting the jets
The f ront  w ashers  i nclude  a n  a djustment  f or  t he  
h

eight   of   delivery   from   the   jets.
If
  you   want   to   modify   the   factory   setting,   turn  
t

he   screw   on   each   jet   anti-clockwise,   towards  
t

he   "+"   to   raise   the   jet   or   clockwise,   towards  
t

he "-"   to   lower   it.
F
 P
ull
 
the
 
windscreen
 
wiper
 
stalk
 
towards
 
y

ou.
 
The
 
windscreen
 
wash
 
then
 
the
 
w

indscreen
 
wipers
 
operate
 
for
 
a
 
fixed
 
p

eriod.
A
 
few
 
moments
 
after
 
releasing
 
the
 
wiper
 
stalk,
 
t

here
 
is
 
a
 
last
 
wipe
 
to
 
clear
 
any
 
runs
 
from
 
the
 
sc

reen.
Lighting and visibility

219
Do not cover the rain sensor, linked with the   sunshine   sensor   and   located   in   the c

entre   of   the   windscreen   behind   the   rear
 v

iew   mirror.
Switch
  off   the   automatic   rain   sensitive
 w

ipers   when   using   an   automatic   car   wash.
In
  winter,   it   is   advisable   to   wait   until   the
 w

indscreen   is   completely   clear   of   ice
 b

efore   activating   the   automatic   rain
 sen

sitive
 w
ipers.
Operating fault
If a fault occurs with the automatic rain sensitive wipers, the wipers will operate in
intermittent
  mode.
Have
  it   checked   by   CITROËN   dealer   or   a  
q

ualified
 w
orkshop.
The
 
windscreen
 
wipers
 
operate
 
automatically,
 
without
 
any
 
action
 
on
 
the
 
part
 
of
 
the
 
driver,
 
if
 
rain
 
is
 
d

etected
 
(sensor
 
behind
 
the
 
rear
 
view
 
mirror),
 
adapting
 
their
 
speed
 
to
 
the
 
intensity
 
of
 
the
 
rainfall.
Switching on Switching off
The automatic r
ain sen sitive w indscreen w
ipers   must   be   reactivated   by   pushing  
t

he   control   stalk   downwards,   if   the  
i

gnition   has   been   off   for   more   than  
o

ne minute.
Briefly
 
push
 
the
 
control
 
stalk
 
d

ownwards.
A
 
wiping
 
cycle
 
confirms
 
that
 
the
 
i

nstruction
 
has
 
been
 
accepted.
This
 
warning
 
lamp
 
comes
 
on
 
in
 
the
 
i

nstrument
 
panel
 
and
 
a
 
message
 
is
 
d

isplayed. Briefly
  push   the   control   stalk  
d

ownwards   again,   or   place  
t

he   control   stalk   in   another  
p

osition (Int, 1 or   2).
Automatic rain sensitive windscreen wipers
This warning lamp goes off in the instrument p
anel   and   a   message   is   displayed.
5
Lighting and visibility