166
Steering mounted controls
1. Select cruise control mode.
2. U se the current speed as the speed
s
etting / Lower the speed setting.
3.
U
se the current speed as the speed
s
etting / Raise the speed setting.
4.
P
ause / Resume cruise control.
5.
U
se the speed suggested by the speed
l
imit recognition system.
6.
D
isplay and adjust the inter-vehicle
d
istance
s
etting.
For
more information on Speed limit
recognition
and its memorisation, refer to the
c
orresponding
s
ection.
Displays in the instrument panel
7. Indication of the presence / absence of a t
arget vehicle.
8.
I
ndication of cruise control activation /
d
eactivation.
9.
Spe
ed
s
etting.
10.
I
ndication that vehicle is held stationary.
11.
S
peed suggested by the speed limit
r
ecognition system.
If
a vehicle is detected, the symbol 7 is filled
w
ith the colour associated with the cruise
c
ontrol mode. By default, the symbol 7 is
e m pt y.
In
cruise control activated mode, the symbol 8
appears
in green. By default, the symbol 8
appears
in grey. 12 . I
nter-vehicle d istance se tting.
13. P osition of the vehicle detected by the radar.
This
information is visible in the instrument
p
anel in "Driving" display mode.
Driving
168
When the cruise control is paused, it can only be reactivated when all of
t
he safety conditions are met. The
m
essage "Activation not possible,
c
onditions
u
nsuitable"
i
s
d
isplayed
w
hile
r
eactivation is not possible.
Wait
until the speed of the vehicle
i
s close to the speed setting before
r
eactivating the system - by pressing
b
utton 2 or 3 - in order to set your
c
urrent speed as the new speed setting.
Modification of the speed setting
Modification from the speed limit
recognition system
F The speed to be memorised is displayed in t
he instrument panel.
F
M
ake an initial press on button 5;
a
m
essage is displayed to confirm the
m
emorisation
r
equest.
F
P
ress button 5 again to save the suggested
s
peed.
The
speed is then displayed in the instrument
p
anel as the new speed setting.
As
a precaution, it is recommended that
y
ou select a cruise speed setting close
t
o the current speed of your vehicle, so
a
s to avoid any sudden acceleration or
d
eceleration of the vehicle.
For
more information on Speed limit
recognition
and its memorisation, refer to the
c
orresponding
s
ection.
Engine
running
and
cruise
control
on
(green),
y
ou
can
modify
the
speed
setting.
Modification from the current
speed
F By successive short presses on button 2 or 3,
to raise or lower the setting in steps
of
+ or - 1 mph (km/h),
F
B
y a maintained press on button 2 or 3,
to
raise or lower the setting in steps
of
+ or - 5 mph (km/h).
Take
care: a prolonged press on
b
utton 2 or 3 will cause a very quick
c
hange in the speed of your vehicle.
Driving
170
70
70
Driving situations and associated alerts
To benefit from all of the information available in the instrument panel, you must first select the "DRIVING" display mode.
T he following table describes the alerts and the messages displayed for the different driving situations.
The
display of these alerts is not sequential.
Indicator Display Associated messageComment
according
to the inter-vehicle
d
istance
s
elected"Cruise
control paused" System paused.
No
vehicle detected.
according
to the inter-vehicle
d
istance
s
elected"Cruise
control paused" System paused.
A
vehicle has been detected.
according
to the inter-vehicle
d
istance
s
elected"Cruise control on"
System
a
ctivated.
No
vehicle detected.
according
to the inter-vehicle
d
istance
s
elected"Cruise control on"
System
a
ctivated.
A
vehicle has been detected.
or "Cruise
control suspended"System
a
ctivated.
The
driver has temporarily taken control of the vehicle by
a
ccelerating.
Driving
178
Driving situations and associated alerts
To benefit from all of the information needed in the instrument panel, you must first select the "Driving" display mode.
T he table below describes the alerts and messages displayed according to the driving situation.
The
display of these alerts is not sequential.
State of
the systemWarning
lamp Associated display
and message
Comment
OFF System
d
eactivated.
ON System
active, conditions not met:
-
s
peed below 40 mph (65 km/h),
-
n
o lane marking recognised,
-
ES
C deactivated or operation triggered,
-
"
sporty" driving.
ON Automatic
deactivation / standby of the system (for example: detection of a trailer, use of the
"
space-saver" spare wheel provided with the vehicle).
ON Detection
of lane markings.
Speed
above 40 mph (65 km/h).
ON The
system corrects the trajectory on the side of the lane marking detected.
ON "Take
back the wheel".-
I
f, during correction, the system detects that the driver has not held the wheel for a few
s
econds, it interrupts the correction and returns control to the driver.
-
D
uring correction of the trajectory, the system determines that the correction will not be
e
nough and a solid line is crossed: the driver is warned that they must complete the correction
o
f trajectory.
Driving
179
Limits of operation
The system goes into standby automatically in the following cases:
-
ES
C deactivated or operation
t
riggered,
-
s
peed below 40 mph (65 km/h) or
a
bove 112 mph (180 km/h),
-
c
onnected electrically to a trailer,
-
u
se of the "space-saver" spare
w
heel detected (as detection is
n
ot immediate, deactivation of the
s
ystem is recommended),
-
d
ynamic driving style detected,
p
ressure on the brake or
a
ccelerator
ped
al,
-
d
riving where there are no lane
ma
rkings,
-
ope
ration
o
f
t
he
d
irection
i
ndicators,
-
d
riving in a tight corner,
-
i
nactivity by the driver detected
d
uring
c
orrection. The
system may not operate correctly o
r at all in the following situations:
-
c
onditions of poor visibility
(
inadequate street lighting,
s
nowfall, rain, fog),
-
d
azzle (headlamps of on oncoming
v
ehicle, low sun, reflections on a
wet
road sur face, leaving a tunnel,
a
lternating light and shade),
-
a
rea of the windscreen in front of
t
he camera dirty, misted, frosted,
s
now-covered, damaged or
c
overed by a sticker,
-
r
oad markings absent, worn,
h
idden (snow, mud) or multiple
(
roadworks),
-
r
unning close to the vehicle in front
(
the lane markings may not be
d
etected),
-
n
arrow, twisty roads.Risk of undesirable operation
Deactivation of the system is recommended in the following situations:
-
d
riving on a road sur face in poor condition,
-
u
nfavorable weather conditions,
-
d
riving on slippery sur faces (black ice).
The
system is not designed for the following
d
riving
s
ituations:
-
d
riving on a speed circuit,
-
d
riving with a trailer,
-
d
riving on a rolling road,
-
d
riving on unstable sur faces.
In
the event of a fault with the system, you are
a
lerted by the illumination of these warning
l
amps in the instrument panel, accompanied by
t
he display of a message and an audible signal.
Have
the system checked by a CITROËN
d
ealer or a qualified workshop.
Operating fault
4
Driving
182
In the event of a fault, this warning lamp flashes for a few moments in
t
he instrument panel, accompanied
b
y a message.
Operating fault
Have it checked by a CITROËN dealer or a qualified w orkshop. The
system may suffer temporary
i
nterference in certain weather
conditions (rain, hail...).
In particular, driving on a wet sur face o
r moving from a dry area to a wet area c
an cause false alerts (for example, the
p
resence of a fog of water droplets in
t
he blind spot angle is interpreted as a
v
ehicle).
In
bad or wintry weather, ensure that
t
he sensors are not covered by mud, ice
o
r snow.
Take
care not to cover the warning zone
i
n the door mirrors or the detection
z
ones on the front and rear bumpers
w
ith adhesive labels or other objects;
t
hey may hamper the correct operation
o
f the system.
High pressure jet wash
When
washing your vehicle, direct the
l
ance at least 30 cm away from the
sen
sors.In
addition to the fixed warning lamp in the door
m
irror on the side in question, a correction of
t
rajectory will be felt if you cross a lane marking w
ith the direction indicators on, to help you a
void a collision.
Conditions for operation
The following systems must be activated:
- b lind spot monitoring,
-
a
ssisted lane departure warning.
Active blind spot
monitoring system
For more information on the Blind spot
mo nitoring system and the Assisted lane
departure warning system , refer to the
corresponding
s
ections.
Driving
187
Reversing camera
Clean the reversing camera regularly u
sing a soft, dry cloth.
The
reversing
camera
is
activated
automatically
w
hen
r
everse
g
ear
i
s
enga
ged.
Depending
on
version,
the
image
is
displayed
in
t
he
touch
screen
tablet
or
the
instrument
panel. The
superimposed
representation
of
guide
l
ines
helps
with
the
manoeuvre. The
blue lines represent the general direction
o
f
the
vehicle (the difference corresponds to
t
he
width of your vehicle without the mirrors).
The
red lines represent a distance of about
3
0
cm
beyond the edge of your vehicle's rear
b
u m p e r.
The
green lines represent distances of about 1
a
nd
2
metres beyond the edge of your vehicle's
r
ear
bumper.
The turquoise blue curves represent the
maximum turning circle.
The
reversing
camera
cannot
in
any
c
ircumstances
replace
the
need
for
v
igilance
on
the
part
of
the
driver. Opening
the tailgate causes the display
t
o disappear.
The
reversing
camera
function
may
be
c
ompleted
with
parking
sensors.
High pressure jet washing
When
washing
your
vehicle,
do
not
d
irect
the
lance
within
30
cm
of
the
c
amera
lens. They
are
represented
by
lines
marked
"
on
the
ground"
and
do
not
allow
the p
osition
of
the
vehicle
to
be
determined r
elative
to
tall
obstacles
(for
example:
o
ther
vehicles, ...).
Some
d
eformation
o
f
t
he
i
mage
i
s
n
ormal.
It
is
normal
to
be
able
to
see
part
of
t
he
number
plate
at
the
bottom
of
the
sc
reen.
4
Driving
188
360 Vision
This system provides a view in the instrument panel of the near surroundings of your vehicle,
u
sing cameras mounted at the front and rear of
y
our vehicle and under the door mirrors.
Depending
on the angle of view chosen (front
v
iew, rear view or 360° panoramic view),
3
60 Vision provides special visual assistance
i
n particular driving conditions such as when
e
ntering a blind junction or manoeuvring in
a
reas of reduced visibility.
Once
activated, this function operates up to
9 m
ph (15 km/h). Above 18 mph (30 km/h), the
f
unction is deactivated automatically. This
system is a visual aid which in no
c
ircumstances can replace the need for
v
igilance on the part of the driver.
The images provided by the cameras
m
ay be deformed by the relief. The
p
resence of areas in shade, in sunny
c
onditions, or of low ambient light may
d
arken the image and reduce contrast.Forward vision
The camera located in the front bumper is a
ctivated and views of the areas located at
f
ront left and front right appear simultaneously
i
n the instrument panel.
Rear vision
The camera located in the tailgate is activated and the view of the area behind your vehicle is
d
isplayed in the instrument panel and behaves
l
ike a reversing camera, whatever the position
o
f the gear selector lever.
The
blue lines represent the width of your
v
ehicle (excluding mirrors): they move
a
ccording to the position of the steering wheel.
The
red line represents a distance of 30 cm
f
rom the rear bumper, and the two green
l
ines, 1 m and 2 m from the rear bumper,
r
espectively. Rear
vision is displayed automatically
w
hen engaging reverse, regardless of
t
he state of the system.
Driving