Page 19 of 523
17
Monochrome digital instrument panel (type 1)
1. Rev counter (x 1 000 rpm or tr/min), g
raduation according to engine (petrol or
D
iesel).
2.
G
ear efficiency indicator, selector position
a
nd gear for an automatic gearbox.
3.
D
igital speedometer (mph or km/h).
4.
C
ruise control or speed limiter settings.
Dials and screens
5. Fuel gauge.
6. S ervice indicator, then total mileage
r
ecorder (miles or km).
T
hese functions are displayed in turn when
t
he ignition is switched on.
7.
T
rip mileage recorder (miles or km).
8.
R
epeat of air conditioning settings.A. M
ain lighting dimmer buttons.
B. R ecall servicing information.
R
eset the function selected to zero (service
i
ndicator or trip recorder).
Control buttons
1
Instruments
Page 24 of 523
22
Operation indicator lamps
If one of the following indicator lamps comes on in the instrument panel, this confirms that the corresponding system has come into operation.
W arning / indicator lamp StateCause Action / Observations
Left-hand
direction indicatorflashing with buzzer.The lighting stalk has been pushed d
own.
Right-hand
direction indicatorflashing with buzzer.The lighting stalk has been pushed u
p.
Sidelamps fixed. The
lighting stalk is in the
"
Sidelamps"
p
osition.
Dipped beam
headlamps fixed.
The
lighting stalk is in the "Dipped
b
eam headlamps" position.
Main beam
headlamps fixed.
The
lighting stalk has been pulled
t
owards you.Pull
the stalk to return to dipped beam headlamps.
Instruments
Page 25 of 523

23
Automatic
headlamp
dippingfixed.
The lighting control stalk is in the "
AUTO" position, pulled towards you,
a
nd the function is activated (Driving
m e n u).
The
system is in dipped beam mode
a
s there is sufficient ambient light
a
nd/or the traffic conditions do not
a
llow illumination of main beam.The
camera, located at the top of the windscreen, m
anages the operation of main beam, depending on
t
he ambient lighting and driving conditions.
Pull
the lighting stalk again to deactivate.
For
more information on Automatic headlamp
dipping ,
refer to the corresponding section.
fixed. The
lighting control stalk is in the
"
AUTO" position, pulled towards you,
a
nd the function is activated (Driving
m e n u).
The
system is in main beam mode
a
s the ambient lighting and traffic
c
onditions allow it.
Warning / indicator lamp
StateCause Action / Observations
Rear foglamps fixed. The
rear foglamps are on.Turn
the ring on the stalk rear ward to switch off the
r
ear
fo
glamps.
Front foglamps
fixed. The
front foglamps are switched on
u
sing the ring on the lighting control
st
alk.Turn
the ring on the lighting control stalk rear ward
o
nce to switch off the front foglamps.
For
more information on the Lighting control stalk,
refer to the corresponding section.
1
Instruments
Page 27 of 523

25
Warning / indicator lampStateCause Action / Observations
Automatic
wiping fixed.
The
wiper control has been pushed
d
own.Automatic
front wiping is activated.
To
deactivate automatic wiping, operate the control
s
talk downwards or put the stalk into another position.
Passenger 's
airbag system fixed.
The
control switch, located at the
p
assenger's end of the dashboard, is
a
t the "ON"
p
osition.
The passenger's front airbag is activated.In this case, do not install a rear ward facing child seat on the front passenger sea
t.
Turn the control switch to the "OFF " position to
deactivate the passenger's front airbag.
You
can install a rear ward facing child seat, unless there
i
s a fault with the airbags (airbag warning lamp on).
Stop & Star t fixed. When
the
vehicle
stops
(red
lights,
t
raffic
jams,
...)
the
Stop
&
Start
system
h
as
put
the
engine
into
STOP
mode. The
warning lamp goes off and the engine restarts
a
utomatically in START mode, as soon as you want to
m
ove off.
flashes for a few
seconds,
then
goes
off. STOP
mode
is
temporarily
u
navailable,
or
START
mode
is
invoked
au
tomatically. For
more information on Stop & Star t, refer to the
corresponding
s
ection.
1
Instruments
Page 42 of 523
40
* Only with the type 2 instrument panel.
Coolant temperature gauge*
After driving for a few minutes, the temperature and pressure in the cooling system increase.
To
top-up the level:
F
w
ait for the engine to cool,
F
u
nscrew the cap slightly to allow the
p
ressure to drop,
F
w
hen the pressure has dropped, remove
t
he cap,
F
t
op-up the level to the "MA X" mark.
With
the
engine
running,
when
the
needle
is:
-
i
n
zone
A ,
the
temperature
is
correct,
-
i
n
zone
B,
the
temperature
is
too
high;
t
he
maximum
temperature
and
the
c
entral STOP
warning
lamps
come
on,
a
ccompanied
by
an
audible
signal
and
a
w
arning
m
essage. Be
aware of the risk of burns when
t
opping-up the cooling system. Do not
f
ill above the maximum level (indicated
o
n the header tank).
You MUST stop as soon as it is safe
to do so.
Wait
a
few
minutes
before
switching
off
t
he engine.
Contact
a
CITROËN
dealer
or
a
qualified
w
orkshop.
Instruments
Page 48 of 523
46
Lighting dimmer control
Allows the manual adjustment of the brightness of the instrument panel and touch screen tablet to suit the ambient light level.
Operates
only when the vehicle lighting is on, with the exception of the daytime running lamps.
Tw o b u t t o n s
With the exterior lighting on, press button A
t o increase the brightness of the instruments
a
nd controls and the interior mood lighting or
b
utton B to reduce it.
As
soon as the lighting reaches the required
l
evel of brightness, release the button.
Touch screen tablet
F In the Configuration menu, select "B
rightness ".
F
A
djust the brightness using the arrows or
b
y moving the cursor.
Instruments
Page 49 of 523
47
When driving at night, this function allows certain displays in the instrument panel to be s
witched off to avoid visual fatigue for the driver.
The
essential information, such as the speed of
t
he vehicle or the cruise control or speed limiter
i
ndications remains displayed in the instrument
pan
el.
Using the steering mounted
control
F With the vehicle lighting on, press this b
utton again to activate the black panel.
F
P
ress this button again to deactivate it.
Black screen (touch screen
tablet)
Black panel (comfortable
night driving display)
F In the Configuration
menu, select "Dark ". T
he screen of the touch screen tablet goes off.
F Press the screen again (anywhere on its s
ur face) to switch it on again.
1
Instruments
Page 54 of 523

52
Deadlocking renders the interior door controls i noperative.
It
also deactivates the manual central
l
ocking button.
Therefore,
never leave anyone inside
t
he vehicle when it is deadlocked.
Deadlocking
F With the vehicle unlocked, press t
his button.
F
W
ithin five seconds, press this button
a
gain
to deadlock the vehicle.
This
function allows you to identify your vehicle
f
rom
a
distance, particularly in poor light. Your
v
ehicle
must be locked.
Locating your vehicle
F Press this button.
This
will
switch on the courtesy lamps and
t
he
direction indicators will flash for about
1
0 seconds.
F
P
ress
this
button.
H
olding
the
button
allows
the
w
indows
to
be
raised
to
the
de
sired
p
osition.
Normal locking
If one of the doors or the boot is not p
roperly closed, locking does not take
p
lace.
Nevertheless,
the alarm (if fitted) will be
f
ully activated after around 45 seconds.
If
the vehicle is unlocked by mistake
a
nd no action is taken on the doors or
b
oot, the vehicle will lock itself again
a
utomatically after about thirty seconds.
If
fitted to your vehicle and the alarm is
r
eactivated
a
utomatically.
The
direction
indicators
come
on
for
a
f
ew
seconds.
Depending
on
your
version,
the
door
m
irrors
fold
and
the
alarm
is
activated.
Locking the vehicle
Ensure that nothing could prevent the c orrect closing of the windows.
Be
aware of children when operating
t
he
w
indows.
The
automatic folding and unfolding
o
f the door mirrors can be deactivated
b
y a CITROËN dealer or a qualified
w
orkshop.
Access