Page 130 of 500
DS5_en_Chap04_conduite_ed02-2015
Memorising speeds
Activating the function
Modifying a speed setting
With your Audio system
"MEM" button
F Press this button to display the list of
memorised speed settings.
By offering preset speed settings, this function facilitates the programming of a speed setting for both the speed limiter and the cruise
control.
The system includes up to 5 or 6 speeds, depending on equipment, that you can modify.
As a safety measure, the driver must
only modify the speed settings when
stationary.
F
Go t
o the main menu by pressing the
"MENU" button:
F Selec
t the"Personalisation-configuration"
menu and confirm.
F
Se
lect " Vehicle parameters" menu and
confirm.
F
Se
lect the "Driving assistance" line and
conform.
F
Se
lect "Speeds memorised" line and
confirm.
F
Se
lect "Activation" to activate the function. F
Se
lect the speed setting to be modified and
confirm.
F Mo
dify the speed setting.
F
Selec
t " OK " and confirm to save the
modifications.
Page 228 of 500

DS5_en_Chap08_info-pratiques_ed02-2015
disconnecting the battery
In order to maintain an adequate state
of charge for starting the engine, it is
recommended that the battery be disconnected
if the vehicle is taken out of service for a long
period.
Wait 2 minutes after switching off the ignition
before disconnecting the battery.
F
cl
ose the windows and the doors before
disconnecting the battery,
F
sw
itch off all electrical consumers (audio
system, wipers, lighting, ...),
F
sw
itch off the ignition and wait for
four
mi
nutes.
Having exposed the battery, it is only
necessary to disconnect the (+) terminal.
Quick release terminal
dis
connecting the (+) terminal
F Raise the lever A fully to release the
c lamp B.
Following reconnection of the battery
Reconnecting the (+) terminal
F Position the open clamp B of the cable on
t
he positive post (+) of the battery.
F
Pr
ess down on the clamp to position it
correctly on the battery post.
F
Lo
ck the clamp by lowering the lever A .
Do not force the lever as locking will
not be possible if the clamp is not
positioned correctly; start the procedure
again. The Stop & Start system may not be
operational during the trip following the
first engine start.
In this case, the system will only be
available again after a continuous
period of immobilisation of the vehicle,
a period which depends on the ambient
temperature and the state of charge of
the battery (up to about 8 hours).
After reconnecting the battery, switch on the
ignition and wait 1 minute before starting to
allow initialisation of the electronic systems.
However, if minor problems persist following
this operation, contact a CITROËN dealer or a
qualified workshop.
Referring to the corresponding section, you
must yourself reinitialise or reset certain
systems, such as:
-
th
e remote control or electronic key
(depending on version),
-
th
e electric blind(s),
-
th
e electric windows
-
th
e date and time,
-
th
e radio preset stations.
Page 284 of 500

DS5_en_Chap11d_RD5_ed02-2015
First steps
On / Off.
Vo lume adjustment.
Select preset radio station.
Long press: store a station. Display the list of stations received,
CD/MP3 t
racks or folders.
Long press: managing the
classification of MP3/ WMA files
/
u
pdate the list of stations received.
Audio settings:
audio ambiences, treble, bass,
loudness, distribution, left /right
balance, front /rear fader, automatic
volume. TA (Traffic Announcement) function
On
/ O
ff.
Long press: access to type of
information. Automatic search up
/ d
own for radio
frequencies.
Select previous / n ext CD, USB,
streaming track.
Navigation in a list.
Access to main menu. Abandon the current operation.
Up one level (menu or folder). Confirmation or display of contextual
menu.
Manual step by step search up
/
d
own for radio frequencies.
Select previous
/ n
ext MP3
f
older.
Select previous
/ n
ext folder
/ g
enre
/
a
rtist
/ p
laylist in the USB device.
Navigation in a list.
Select AM / FM wavebands.
Select source:
Radio, CD, AUX, USB, Streaming.
Accept an incoming call. Select screen display between modes:
Full screen: Audio (or telephone if call
in progress)
/
I
n a window: Audio (or telephone
if call in progress)
- T
ime or Trip
computer.
Long press: black screen (DARK).
Page 352 of 500

2
3
3
1
Press on " Radio Media
" to display
the primary page.
Press on Radio Media
to display the
primary page.
Select " Save
".
If necessary, select change of
source.
Press on Radio Media
to display the
primary page.
Select change source.
" AM Radio
".
By automatic frequency search
Select " FM Radio
".
" AM Radio
".
Or
Select a preset radio station
in the list.
Select " FM Radio
".
Select a radio station from
the list offered.
Select " Update list
" to refresh the
list.
Press on Radio Media
to display the
primary page.
Press on the secondary page.
Select " List
" in the primary page.
Radio
Changing a radio frequency
Selecting a station
To select a preset radio station.
THEN
Radio reception may be affected by
the use of electrical equipment not
approved by CITROËN, such as a USB
charger connected to the 12 V socket.
The exterior environment (hills,
buildings, tunnel, car park, below
ground...) may prevent reception,
even in RDS station tracking mode.
This phenomenon is normal in the
propagation of radio waves and is in no
way indicative of a fault with the audio
system.
Select " Radio list
" in the secondary
page.
Or
Press
or
to move the cursor for an
automatic search down or up for a radio
frequency.
Or
Page 353 of 500

1
1
20
5
4
2
7
27 Audio and Telematics
Select a radio station or frequency (refer to the
corresponding section).
Press on Radio Media
to display the
primary page.
Press on the secondary page.
Select " Settings
".
Select " Radio
".
Activate/deactivate " RDS
options
".
Press on Radio Media
to display the
primary page.
Press on the secondary page.
Press on " Save
" (preset).
Select a number in the list to preset the
previously chosen radio station.
A long press on a number presets (memorises)
the station.
Press on Frequency
.
Enter the frequency in full
(e.g.: 92.10 MHz) using the keypad
then " Confirm
".
Changing radio station
Pressing the name of the current radio station
brings up a list.
To change radio station press the name of the
desired station.
Or
Press on Radio Media
to display the
primary page.
Select " Save
" (preset).
Preset a station
Activate/ Deactivate RDS
OR
THEN
A press on this button presets all of
the stations one after the other.
Recall pre-set stations
RDS, if activated, allows you to continue
listening to the same station by automatic
retuning to alternative frequencies.
However, in certain conditions, coverage
of an RDS station may not be assured
throughout the entire country as radio
stations do not cover 100 % of the
territory. This explains the loss of
reception of the station during a journey.
Page 354 of 500

Display of options:
if active but not available, the display will be greyed out,
if active and available, the display will be blank.
Display of "Radiotext" for
the current station.
Manage the Jukebox.
Display current action.
Select the audio source.
Display the "DAB" band.
Display of the name of the
current station.
Short-cut: access to the choice of audio
source and the list of stations (or titles,
depending on the source).
Select the radio station.
Any thumbnail broadcast by
the station.
Preset stations, buttons 1
to 15.
Short press: select the
preset radio station.
Long press: preset a radio
station.
Next "Multiplex".
Next radio station.
Secondary page.
Display the name and
number of the multiplex
ser vice being used.
Previous "Multiplex".
Previous radio station.
DAB (Digital Audio Broadcasting) radio
If the "DAB" radio station being listened to is not
available on "FM", the "DAB FM" option is greyed out.
Journaline ®
is a text-based information ser vice designed for digital radio systems.
It provides text-based information structured around topics and sub-topics.
This ser vice is available from the "LIST OF DAB STATIONS" page.
Page 371 of 500
1
1
1
2
3
4
5
6
7
8
9
10
11
45 Audio and Telematics
Level 1
Level 2
Comments
Connected services
Secondary page
Bluetooth
Connection
Search
Start the search for a device to connect.
Connect
/Disconnect
Start or end the Bluetooth connection to the
selected device.
Update
Import contacts from the selected telephone to
save them in the audio system.
Delete
Deletethe selected telephone.
Confirm
Save the settings.
Connected services
Secondary page
Tr a n s f e r r a t e
Reset
Reset the usage monitor, them confirm.
Confirm
Connected services
Secondary page
Wi-Fi connection
All
Display all Wi-Fi networks.
Secure
Display secure Wi-Fi networks.
Stored
Memorise the selected Wi-Fi network(s).
Add
Add a new Wi-Finetwork.
Off
/On
Activate or deactivate a Wi-Fi network.
Connect
Select a Wi-Fi network found by the system and
connect to it.
Page 405 of 500

3 Audio and Telematics
Select the audio source (depending on
version):
- FM / DAB * / AM * stations.
- Smartphone via MirrorLink
TM
or CarPlay ®
.
- USB memory stick.
- CD player (located in front panel).
- Media player connected to the auxiliary
socket ( jack, cable not supplied).
- BluetoothTelephone connected by
Bluetooth * and using*
audio streaming.
* Depending on equipment.
Short-cuts: using the virtual buttons in the
upper band of touch screen, it is possible to
go directly to the selection of audio source,
the list of stations (or titles, depending on
the source), message notifications, emails,
mapping updates and, depending on services,
navigation notifications.
In very hot conditions, the volume may
be limited to protect the system. It may
go into standby (screen and sound off)
for at least 5 minutes.
The return to normal takes place when
the temperature in the passenger
compartment drops.
In the "Settings" menu you can create
a profile for just one person or a group
of people with common points, with
the possibility of entering a multitude of
settings (radio presets, audio sttings,
navigation history, contact favourites, ...);
these settings are taken into account
automatically.