2016 Citroen DS3 RHD ignition

141
The temporary illumination of the dipped beam headlamps   after   the   vehicle's   ignition   has   been  
s

witched   off   makes   the   driver's   exit   easier  
w

hen   the   light   is   poor.
Switching on
F With  the   ignition   off,   "flash"   the   headlamps  u
sing   the   lighting   stalk.
F
 
A
  further   "headlamp   flash"   switches   the  
f

unction   off.
Switching off
The manual guide-me-home lighting switches off   automatically   after   a   set   time.
Manual guide-me-home
lighting
The sidelamps and dipped beam headlamps are   switched   on   automatically,   without   any  
a

ction   on   the   part   of   the   driver,   when   a   low   level  
o

f   external   light   is   detected   or   in   certain   cases  
o

f   activation   of   the   windscreen   wipers.
As
  soon   as   the   brightness   returns   to   an  
a

dequate   level   or   after   the   windscreen   wipers  
a

re   switched   off,   these   lamps   are   switched   off  
a

utomatically   and   the   daytime   running   lamps  
c

ome   on.
Automatic illumination of
headlamps
Activation
F Turn   ring   to   the   "AUTO"  position.   The  a
ctivation   of   the   function   is   confirmed   by  
t

he   display   of   a   message.
deactivation
F Turn  ring   to   a   position   other   than   "AUTO".  T
he   deactivation   of   the   function   is  
c

onfirmed   by   the   display   of   a   message.
Operating fault
In the event of a fault with the
sunshine  sensor,   the   lighting   come  
o

n,   this   warning   lamp   is   displayed  
o

n   the   instrument   panel   and/or   a  
m

essage   appears   in   the   screen,  
a

ccompanied   by   an   audible   signal.
Contact
 
a
 
CITROËN   or   a   qualified   workshop  
w

orkshop.
Visibility

LED daytime running lampsThis daytime lighting, a signature of the vehicle, comprises   two   sets   of   light-emitting   diodes  
(

LEDs),   located   in   vertical   housings   below   each  
h

eadlamp.
On
  starting   the   vehicle,   in   daylight   the   daytime  
r

unning   lamps   come   on   automatically,   if   the  
l

ighting   stalk   is   in   position   "0" or "AUTO" .
If
  the   sidelamps   and   headlamps   are   switched  
o

n   manually   or   automatically,   the   daytime  
r

unning   lamps   go   off.
In
 
fog
 
or
 
snow,
 
the
 
sunshine
 
sensor
 
m

ay
 
detect
 
sufficient
 
light.
 
Therefore,
 
t

he
 
lighting
 
will
 
not
 
come
 
on
 
au

tomatically.
Do
 
not
 
cover
 
the
 
sunshine
 
sensor,
 
c

oupled
 
with
 
the
 
rain
 
sensor
 
and
 
l

ocated
 
in
 
the
 
centre
 
of
 
the
 
windscreen
 
b

ehind
 
the
 
rear
 
view
 
mirror;
 
the
 
a

ssociated
 
functions
 
would
 
no
 
longer
 
be c

ontrolled.
Automatic
guide-me-home
lighting
When the automatic illumination of headlamps f
unctions   is   activated,   if   the   ambient   light   level  
i

s   low   the   dipped   beam   headlamps   remain   on  
w

hen   switching   off   the   ignition.
Settings
Activation and deactivation, as well as the duration   of   the   guide-me-home   lighting   can  
b

e   set   in   the   vehicle   configuration   or   settings  
m

enu   (except   for   the   monochrome   screen   A,  
f

or   which   the   duration   is   fixed   at   60   seconds).

Automatic rain sensitive
windscreen wipers
The windscreen wipers operate automatically, without   any   action   on   the   part   of   the   driver,   if  
r

ain   is   detected   (sensor   behind   the   rear   view  
m

irror),   adapting   their   speed   to   the   intensity   of  
t

he   rainfall.
Activation
This is controlled manually by the driver by pushing s talk A to the "AUTO" p osition.
It is accompanied by the illumination of this indicator   lamp   in   the   instrument   panel   and a

  message   in   the   multifunction   screen.
Switching off
This is controlled manually by the driver by   moving   stalk   A   upwards,   returning   it   to  
p

osition

"0".
It
  is   accompanied   by   the   indicator   lamp
 i

n   the   instrument   panel   going   off   and   a
 m

essage   in   the   multifunction   screen.The
  automatic   wiping   must   be  r
eactivated   if   the   ignition   has   been   off  
f

or   more   than   one   minute,   by   pushing  
s

talk   A   downwards.

147
Operating fault
If an automatic wiping fault occurs, the wipers will   operate   in   intermittent   mode.
Have
  it   checked   by   a   CITROËN   dealer   or   a  
q

ualified
 w
orkshop.
To retain the effectiveness of the flat
wiper
  blades,   it   is   advisable   to:
-
 
h
andle   them   with   care,
-
 
c
lean   them   regularly   using   soapy  
w

ater,
-
 
n
ot   use   them   to   hold   a   sheet   of  
c

ardboard   against   the   windscreen,
-
 
r
eplace   them   at   the   first   signs   of  
w

e a r.
Do
  not   cover   the   rain   sensor,   linked  
w

ith   the   sunshine   sensor   and   located   in  
t

he   centre   of   the   windscreen   behind   the  
r

ear   view   mirror.
Switch
  off   the   automatic   wiping   when  
u

sing   an   automatic   car   wash.
In
  winter,   it   is   advisable   to   wait   until   the  
w

indscreen   is   completely   clear   of   ice  
b

efore   activating   the   automatic   wiping.This
  position   allows   the   wiper   blades   to  
b

e   lifted   for   winter   parking,   cleaning   or  
r

eplacement   without   damaging   the   bonnet.
In
  the   minute   following   switching   off   of   the  
i

gnition,   any   action   on   the   wiper   stalk   positions  
t

he   wipers   vertically.
To
  park   the   wipers   after   this   has   been   done,
 s

witch   on   the   ignition   and   operate   the   wiper   stalk.
Vertical windscreen wiper
position
Visibility

A. Courtesy lamp
B. Map reading lamps
Courtesy lam p
In this position, the courtesy lamp c
omes   on   gradually:
Courtesy lamp
- when  the   vehicle   is   unlocked,
-  w hen   the   key   is   removed   from   the   ignition,
-
 
w
hen   a   door   is   opened,
-
 
w
hen   the   remote   control   locking   button   is  
a

ctivated,   in   order   to   locate   your   vehicle.
It
  switches   off   gradually:
-
 
w
hen   the   vehicle   is   locked,
-
 
w
hen   the   ignition   is   switched   on,
-
 
3
0   seconds   after   the   last   door   is   closed.
Permanently
  off.
Permanent
 l

ighting.
With the "permanent lighting" mode, the duration of lighting   varies,   depending   on   the   circumstances:
- with the ignition off, approximately ten minutes,
- in energy economy mode, a pproximately   thirty   seconds,
- with the engine running, unlimited.
Map reading lamps
F With  the   ignition   on,   press   the  c
orresponding s witch.

149
Interior mood lightingThe dimmed passenger compartment lighting improves visibility in the vehicle when the light is p
o o r.
Switching on
At night, the illumination of footwells and the central   dashboard   storage   compartment   comes  
o

n   automatically   when   the   sidelamps   are  
s

witched   on.
Switching off
The interior mood lighting switches off automatically   when   the   sidelamps   are  
switched
  off.
It
  can   be   switched   off   manually   using   the  
i

nstrument   panel   lighting   rheostat   button.
F
 
W
ith   the   lighting   on,   press   several   times   on  
t

he   left   hand   button   of   the   instrument   panel  
t

o   progressively   reduce   the   dashboard  
l

ighting   level.
F
 
P
ress   again   to   reduce   the   lighting   level  
t

o   the   minimum   and   switch   off   the   interior  
m

ood
 l
ighting. This
  comes   on   automatically   when   the   boot   is  
o

pened   and   goes   off   automatically   when   the  
b

oot   is   closed.
Boot lamp
The lighting time varies according to the c ircumstances:
-
 
w
hen   the   ignition   is   off,
 a

pproximately   ten minutes,
-
 
i
n   energy   economy   mode,
 a

pproximately   thirty seconds,
-
 
w
hen   the   engine   is   running,   no   limit.Programming
Switching the function on or off is done using the   vehicle   settings   menu.
Visibility

Direction 
i ndicators
F Left:   lower   the   lighting   stalk   beyond   the  p
oint   of   resistance.
F
 
R
ight:   raise   the   lighting   stalk   beyond   the  
p

oint   of   resistance.
Three flashes of the direction
indicators
F Press  briefly   upwards   or   downwards,  w
ithout   going   beyond   the   point   of  
r

esistance;   the   direction   indicators   will  
f

lash   3   times.
Hazard warning 
lam
ps
Visual warning with of all the direction i
ndicators   flashing   to   alert   other   road   users   to   a  
v

ehicle   breakdown,   towing   or   accident.
F
 
P
ress   this   button,   all   of   the   direction  
in

dicators
 f
lash.
They
  can   operate   with   the   ignition   off.
Automatic operation of
hazard warning lamps
When braking in an emergency, depending on the   deceleration,   the   hazard   warning   lamps  
c

ome   on   automatically.
They
  switch   off   automatically   the   first   time   you  
a

ccelerate.
F
 
Y
ou   can   also   switch   them   off   by   pressing  
t

he   button.

Reinitialisation of the system is done in the vehicle configuration menu, with the vehicle stationary and the ignition on.
Monochrome screen A
F Press the MEn U button for access to the
main   menu.
F

P
ress the " 5" or " 6" button to select
the Veh conf ig
 

menu,   then   confirm   by  
p

ressing   the   OK
 
button.
F

P
ress the " 5" or " 6" button to select the
" Reinit inflat ",
  menu,   then   confirm   by  
p

ressing   the   OK
 
button.
 A

  message   is   displayed   to   confirm   the  
in

struction.
F
 
C
onfirm   by   pressing   the   OK
 
button.
Monochrome screen C
F Press the MEnU button for access to the
main   menu.
F

P
ress the " 5" or " 6" button to select the
" Personalisation-configuration "
  menu,  
t

hen   confirm   by   pressing   the   OK
 
button.
F

P
ress the " 5" or " 6" button to select the
"
def

ine vehicle parameters "
  menu,   then  
c

onfirm   by   pressing   the   OK
 
button.F
P ress the "
5" or " 6" button to select
the " Tyre pressures "
  menu,   then   the  
"R

einitialisation"
  menu,   then   confirming  
b

y   pressing   the   OK
 
button.
 A

  message   confirms   the   reinitialisation.