2016 Citroen C4 PICASSO Beam

217
C4-Picasso-II_en_Chap05_eclairage-visibilite_ed01-2016
Directional lighting
When the dipped or main beam headlamps are
on,
  this   system   allows   the   light   beams   to   better  
f

ollow   the   road.
Associated
  with   xenon   headlamps,   this   system  
i

mproves   the   quality   of   lighting   when   cornering.
with directional lighting
without directional lightingOperating fault
This system is inactive:
- w hen stationary or at low speeds,
-
 w

hen
 r
everse
 is enga
ged. If
  a   fault   occurs,   these   warning   lamps  
c

ome on in the instrument panel,
accompanied   by   an   audible   signal  
a

nd   a   message.
Contact a CITROËN dealer or a qualified
workshop.
The   directional   lighting   can   be   activated   or  
d

eactivated   in   the   touch   screen   tablet.
In the Driving menu, select the " Settings"
tab, then " Lighting" and select " Directional
headlamps ".
5
Lighting and visibility

220
C4-Picasso-II_en_Chap05_eclairage-visibilite_ed01-2016
Screenwash and washer jets
Windscreen wash and headlamp wash
Adjusting the jets
The f ront  w ashers  i nclude  a n  a djustment  f or  t he  
h

eight   of   delivery   from   the   jets.
If
  you   want   to   modify   the   factory   setting,   turn  
t

he   screw   on   each   jet   anti-clockwise,   towards  
t

he   "+"   to   raise   the   jet   or   clockwise,   towards  
t

he "-"   to   lower   it.
Headlamp wash
F Pull  the   windscreen   wiper   stalk   towards  y
ou.   The   windscreen   wash   then   the  
w

indscreen   wipers   operate   for   a   fixed  
p

eriod.
A
  few   moments   after   releasing   the   wiper   stalk,  
t

here is a last wipe to clear any runs from the
screen. The headlamps operate when the vehicle is
moving
  and   when   the   dipped   beam   headlamps  
a

re   on.   However,   to   reduce   the   consumption  
o

f screenwash fluid, the headlamp wash only
operates with every 7th use of the screenwash
or
  once   every   25   miles   (40   km),   during   a   given  
j

o u r n ey.
Lighting and visibility

265
C4-Picasso-II_en_Chap07_info-pratiques_ed01-2016
Exiting economy mode
These functions are reactivated automatically
next  time   the   vehicle   is   driven.
In order to restore the use of these functions
immediately,
  start   the   engine   and   let   it   run:
-

f
or less than ten minutes, to use the
equipment
  for   approximately   five   minutes,
-

f
or more than ten minutes, to use the
equipment
  for   up   to   approximately  
t

hirty minutes.
Let
  the   engine   run   for   the   duration   specified   to  
e

nsure   that   the   battery   charge   is   sufficient.
Do not repeatedly and continuously restart the
engine
  in   order   to   charge   the   battery.
A
  flat   battery   prevents   the   engine   from   starting.
For more information on the 12 V batter y , refer
to
  the   corresponding   section.
Load reduction mode
System which manages the use of certain functions   according   to   the   level   of   charge  
r

emaining   in   the   battery.
When
  the   vehicle   is   being   driven,   the   load  
r

eduction function temporarily deactivates
certain
  functions,   such   as   the   air   conditioning,  
t

he   heated   rear   screen...
The deactivated functions are reactivated
automatically
  as   soon   as   conditions   permit.
Energy economy mode
Switching to economy
mode
A message appears in the instrument panel s
creen   indicating   that   the   vehicle   has   switched  
t

o economy mode and the active functions are
put
  on   standby.
If
  a   telephone   call   is   being   made   at   this   time,   it  
w

ill be maintained for around 10 minutes with
the Bluetooth hands-free system of your audio
system. System   which   manages   the   duration   of   use   of   certain   functions   to   conserve   a   sufficient   level   of  
c

harge   in   the   battery.
After   the   engine   has   stopped,   you   can   still   use   functions   such   as   the   audio   and   telematics  
s

ystem, windscreen   wipers,   dipped   beam   headlamps, courtesy   lamps,   etc.   for   a   maximum  
c

ombined   duration   of   about   forty   minutes.
7
Practical information

301
C4-Picasso-II_en_Chap08_en-cas-panne_ed01-2016
Changing a bulb
For H7 type bulbs with lugs... take care to observe their correct installation
so
  as   to   ensure   the   best   lighting  
p

erformance.
Risk of electrocution
Xenon bulbs (D5S-25W) must be
replaced by a CITROËN dealer or a
qualified
 w
orkshop.
Front lamps
Model with xenon headlamps
1. Directional dipped beam headlamps (D5S-25W).
2.
 M

ain   beam   headlamps   (H7-55W).
3.
 D

aytime   running   lamps   /   sidelamps
 (

6   light   emitting   diodes   -   LEDs).
4.
D

irection indicators
 (

6   light   emittng   diodes   -   LEDs).
5.
 F

ront   foglamps   (H11-55W).
Model with halogen headlamps
1. Dipped  beam   headlamps   (H7-55W).
2. M ain   beam   headlamps   (H7-55W).
3.
 D

aytime
 r
unning
 lam
ps/sidelamps
 (

4   light   emitting   diodes   -   LEDs).
4.
 D

irection   indicators   (PW Y24W).
5.
 F

oglamps
 (
H11-55W). In
  some   weather   conditions   (e.g.   low  
t

emperature or humidity), the presence
of   misting   on   the   internal   sur face   of   the  
g

lass   of   the   headlamps   and   rear   lamps  
i

s   normal;   it   disappears   after   the   lamps  
h

ave   been   on   for   a   few   minutes.
Light- emitting diodes - LEDs
For replacement, contact a CITROËN dealer or
qualified w
orkshop.
8
In the event of a breakdown

302
C4-Picasso-II_en_Chap08_en-cas-panne_ed01-2016
Directional dipped beam
headlamps (xenon model)Main beam headlamps (xenon model)
F Remove the protective plastic cover by pulling   the   tab.
F
 
P
ush   the   connector.
F
 
R
emove   the   bulb   and   change   it.
For reassembly, carry out these operations in
reverse
 o

rder.
D5S
 
xenon
 
bulbs
 
must
 
be
 
changed
 
b

y a CITROËN dealer or a qualified
workshop,
 
as
 
there
 
is
 
a
 
risk
 
of
 
el

ectrocution.
In the event of failure of one
of the D5S bulbs, it is recommended
that the bulb on the other side be
changed
 
at
 
the
 
same
 
time.
The headlamps have polycarbonate
lenses
 
with
 
a
 
protective
 
coating:
F

d

o not clean them using a dr y
or abrasive cloth, nor with a
detergent or solvent product,
F
 
u

se
 
a
 
sponge
 
and
 
soapy
 
water
 
or
 
a
 
p

H neutral product,
F
 
w

hen
 
using
 
a
 
high
 
pressure
 
washer
 
o

n
 
persistent
 
marks,
 
do
 
not
 
keep
 
t

he lance directed towards the
lamps
 
or
 
their
 
edges
 
for
 
too
 
long,
 
s

o
 
as
 
not
 
to
 
damage
 
their
 
protective
 
c

oating
 a

nd
 sea

ls.
Changing
 
a
 
bulb
 
should
 
only
 
be
 
done
 
a

fter the headlamp has been switched
off
 
for
 
several
 
minutes
 
(risk
 
of
 
serious
 
b

urns).
F

D

o not touch the bulb directly with
your
 
fingers,
 
use
 
a
 
lint-free
 
cloth.
It is imperative to use only anti-
ultraviolet (UV) type bulbs to avoid
damaging
 t

he
 h

eadlamp.
Always replace a failed bulb with a
new bulb with the same type and
specification.
In the event of a breakdown

303
C4-Picasso-II_en_Chap08_en-cas-panne_ed01-2016
Dipped beam headlamps
(halogen model)
F Remove the protective plastic cover by pulling   the   tab.
F
 
P
ush   the   connector.
F
 
R
emove   the   bulb   and   change   it.
For reassembly, carry out these operations in
reverse
 o

rder.
Main beam headlamps
(halogen model)
F Turn the protective plastic cover to remove   it.
F
 
D
isconnect   the   connector.
F
 
R
elease   the   clips.
F
 
R
emove   the   bulb   and   change   it.
For reassembly, carry out these operations in
reverse
 o

rder.
8
In the event of a breakdown

313
C4-Picasso-II_en_Chap08_en-cas-panne_ed01-2016
Fusebox 2Fuse N° Rating Functions
F7 10 ABoot
  12   V   socket,   rear   multimedia.
F8 20 ARear
  wiper.
F10 30 ALocks.
F17 5 AInstrument
  panel.
F18 5 AAutomatic
  gearbox   gear   selector.
F21 3 ASTART/STOP
  button.
F22 3 ARain
  and   sunshine   sensor,   windscreen   camera.
F24 5 AParking
  sensors,   panoramic   visual   aid.
F27 5 AAutomatic
  gearbox.
F29 20 AAudio
  and   telematic   systems.
F32 15 A12
  V   sockets.
F35 5 AHeadlamp
  beam   height   adjustment,   heated   rear   screen,   radar.
F36 5 AInterior
  lighting:   glove   box,   central   storage,   reading   lamps,  
c

ourtesy   lamps.
8
In the event of a breakdown

314
C4-Picasso-II_en_Chap08_en-cas-panne_ed01-2016
Engine compartment fuses
The fusebox is placed in the engine compartment   near   the   battery.
Fuse N°Rating Functions
F16 20 AHeadlamp
 w

ash.
F18 10 ARight
  hand   main   beam.
F19 10 ALeft
  hand   main   beam.
F29 40 AWipers.Fuse table
Access to the fuses
F Unclip   the   cover,   by   pushing   the   two   red  l
atches   towards   the   rear   of   the   vehicle.
F
 
C
hange   the   fuse.
F

W
hen you have finished, close the cover
carefully
  to   ensure   correct   sealing   of   the  
f

usebox.
In the event of a breakdown