17
C4-2_en_Chap01_instruments-de-bord_ed02-2015
Engine oil
pressurefixed.
There is a fault with the engine l
ubrication system.You
must stop as soon it is safe to do so.
Park, switch off the ignition and contact a CITROËN
d
ealer or a qualified workshop.
Warning
/indicator lampis on Cause Action/Observations
Battery charge fixed. The
battery charging circuit has a
f
ault (dirty or loose terminals, slack or
c
ut alternator belt, ...).The
warning lamp should go off when the engine is
s
tarted.
If
it does not go off, contact a CITROËN dealer or a
q
ualified
w
orkshop.
Braking fixed,
associated with
t
he STOP warning
lam
p.The
braking system fluid level has
d
ropped
s
ignificantly.You
must stop as soon as it is safe to do so.
Top
up with brake fluid recommended by CITROËN.
If
the problem persists, have the system checked by a
C
ITROËN dealer or a qualified workshop.
+
fixed, associated with the e lectric parking brake m
alfunction
w
arning
l
amp, if the parking brake
i
s
r
eleased.The braking system has a fault. Y ou must stop as soon as it is safe to do so.
Park, switch off the ignition and contact a CITROËN
d
ealer or a qualified workshop.
+ fixed,
associated
with
t
he STOP and ABS
warning
lam
ps. The
e
lectronic
b
rake
f
orce
d
istribution
(
EBFD) system has a fault.You
must stop as soon as it is safe to do so.
Have
it checked by a CITROËN dealer or a qualified
w
orkshop.
1
Instruments
20
C4-2_en_Chap01_instruments-de-bord_ed02-2015
Warning/indicator lampis on Cause Action/Observations
Anti-lock
Braking System
(ABS) fixed.
The
anti-lock braking system has a
f
ault.The
vehicle retains conventional braking.
Drive carefully at reduced speed and contact a
CITROËN
dealer or a qualified workshop without
d
e l ay.
Engine
autodiagnosis
system
flashing.
The
engine management system has
a
fault.Risk
of destruction of the catalytic converter.
Have
it checked by a CITROËN dealer or a qualified
w
orkshop.
fixed. The
emission control system has a
f
ault.
The warning lamp should go off when the engine is started.
I f it does not go off, contact a CITROËN dealer or qualified w
orkshop without delay.
Low fuel level fixed, accompanied by a
nd audible signal and
a
message. When
it first comes on there remains a
pproximately 6 litres of fuel in the
tank.
At
this point, you begin to use the fuel
r
eserve.Refuel
as soon as possible to avoid running out of f
uel.
Until
sufficient fuel is added, this warning lamp will
c
ome on every time the ignition is switched on,
a
ccompanied by an audible signal and a message.
T
his audible signal and message are repeated
with
increasing frequency as the fuel level drops
tow
ards "0".
Fuel
tank capacity: approximately 60 litres.
Never continue to drive until you run out of fuel, as
this
could damage the emission control and injection
s
ystems.
Instruments
49
C4-2_en_Chap01_instruments-de-bord_ed02-2015
"Driving" menu
ButtonCorresponding function Comments
Speed settings Memorisation
of speeds for use with the speed limiter or cruise control.
Vehicle settings Access
to other functions with settings that can be adjusted. The functions are grouped
t
ogether under three tabs:
-
"Driving assistance "
-
"
Automatic parking brake" (Automatic electric parking brake; refer to the "Driving"
s
ection),
-
"
Automatic rear wiper in reverse" (Activation of rear wiper coupled to reverse gear; refer
t
o the "Lighting and visibility" section).
-
"Lighting "
-
"
Guide-me-home lighting" (Automatic guide me home lighting; refer to the "Lighting and
v
isibility"section),
-
"
Welcome lighting" (Exterior welcome lighting; refer to the "Lighting and
v
isibility"section),
-
"
Adaptive lighting" (Main / additional directional lighting; refer to the "Lighting and
v
isibility"
s
ection).
-
"Vehicle access "
-
"
Driver plip action" (Selective unlocking of the driver's door; refer to the "Access"
s
ection).
-
"
Unlocking boot" (Selective unlocking of the boot; refer to the "Access" section).
Select
or deselect the tabs at the bottom of the screen to display the functions required.
Diagnostic List
of current alerts.
The
systems with settings that can be adjusted are detailed in the table below.
1
Instruments
53
C4-2_en_Chap01_instruments-de-bord_ed02-2015
Monochrome screen C
Information displays
You can choose between two types of display
by pressing button A:
-
t
he trip computer information appears
t
emporarily above the audio information,
d
isplayed permanently in full screen,
or
-
t
he trip computer and audio information
b
oth appear permanently in a shared
sc
reen. -
t
he current information tab with:
●
t
he range,
●
t
he current fuel consumption,
● t he Stop & Start time counter,
-
t
he trip "1"
tab with:
●
t
he distance travelled,
●
t
he average fuel consumption,
●
t
he average speed,
f
or the first trip.-
t
he trip "2"
tab with:
●
t
he distance travelled,
●
t
he average fuel consumption,
●
t
he average speed,
f
or the second trip.
F
P
ress the button, located at the end of
the wiper stalk , to display the various trip
computer tabs in succession.Trip zero reset
F When
the trip required is displayed, press the b
utton on the end of the wiper stalk for more t
han two seconds.
Tr i p s "1" and "2" are independent but their use
is
identical.
For
example, trip "1" can be used for daily
figures,
and trip "2"
for monthly figures.
1
Instruments
54
C4-2_en_Chap01_instruments-de-bord_ed02-2015
Touch screen tablet
Temporary display in a new window:
F P ress the end of the wiper control stalk for
a
ccess to the information and display the
d
ifferent tabs.
Display of information
Permanent display: The current instantaneous fuel
consumption
tab with:
-
t
he range,
-
t
he current fuel consumption,
-
t
he Stop & Start time counter.
The trip "1"
tab with:
-
t
he distance travelled.
- t he average fuel consumption,
- t he average speed,
f
or the first trip.
The trip "2"
tab with:
-
t
he distance travelled.
-
t
he average fuel consumption,
-
t
he average speed,
f
or the second trip.
Trip reset
The trip computer information is displayed in the primary page of the menu.
F
P
ress one of the buttons to display the
desired
t
ab.
F
Sel
ect the "
Driving" menu.
F
W
hen the desired trip is
displayed, press the reset button
or press and hold the end of the
wiper control stalk.
Tr i p s "1" and "2" are independent but their use
is
identical.
For
example, trip "1" can be used for daily
figures,
and trip "2"
for monthly figures.
Instruments
74
C4-2_en_Chap02_ouvertures_ed02-2015
Operating fault
When the ignition is switched on, fixed illumination of the indicator lamp in the button
i
ndicates a fault with the system.
Have
it checked by a CITROËN dealer or a
q
ualified
w
orkshop.
Failure of the remote control
To deactivate the monitoring functions:
F
u
nlock the vehicle using the key (integral to
t
he
remote
control)
in
the
driver's
door
lock,
F
o
pen the door; the alarm is triggered,
F
s
witch on the ignition; the alarm stops; the
i
ndicator lamp in the button goes off.
Locking the vehicle without
activating the alarm
F Lock or deadlock the vehicle using the k
ey(integral to the remote control) in the
d
river's door lock.
Triggering of the alarm
This is indicated by sounding of the siren and flashing of the direction indicators for
t
hirty seconds.
The
monitoring functions remain active until
t
he alarm has been triggered eleven times in
s
uccession.
When
the vehicle is unlocked using the remote
c
ontrol or the Keyless Entry and Starting
s
ystem, rapid flashing of the indicator lamp
i
n the button informs you that the alarm was
t
riggered during your absence. When the
i
gnition is switched on, this flashing stops
i
mmediately.
Access
140
C4-2_en_Chap05_securite_ed02-2015
Group of supplementary systems which help you to obtain optimum braking in complete
s
afety in emergency situations:
-
a
nti-lock braking system (ABS),
-
e
lectronic brake force distribution (EBFD),
-
e
mergency braking assistance (EBA).
Anti-lock braking system
and electronic brake force
distribution
Linked systems which improve the stability and manoeuvrability of your vehicle when braking, in p
articular on poor or slippery sur faces.
Activation
The anti-lock braking system comes into operation automatically when there is a risk of
w
heel lock.
Normal
operation of the ABS may make itself
f
elt by slight vibration of the brake pedal.
Operating fault
If this warning lamp comes on, accompanied by an audible signal
a
nd a message in the screen, it
i
ndicates a malfunction of the anti-
lock
braking system which could
r
esult in loss of control of the vehicle
when
b
raking.
If
this warning lamp comes on,
t
ogether with the STOP and ABS
warning
lamps, accompanied by an
a
udible signal and a message in the
s
creen, it indicates a malfunction of
t
he electronic brake force distribution
w
hich could result in loss of control of
the
vehicle when braking.
Emergency braking
assistance
System which, in an emergency, enables you to obtain the optimum braking pressure more
q
uickly, thus reducing the stopping distance.
Activation
It is triggered by the speed at which the brake pedal is pressed.
The effect of this is a reduction in the
resistance of the pedal and an increase in
braking
e
fficiency.
You must stop as soon as it is safe to do so.
In either case, contact a CITROËN dealer or a
qualified
w
orkshop.
When
braking
in
an
emergency,
press
v
ery
firmly
without
releasing
the
p
ressure. When
braking in an emergency, press
f
irmly without releasing the pressure.
When
replacing
wheels
(tyres
and
r
ims),
ensure
that
they
conform
to
the
ma
nufacturer's
r
ecommendations.
Braking assistance systems
Safety
258
C4-2_en_Chap08_en-cas-de-panne_ed02-2015
After removing the lamp unit, carry out the following operations to replace the failed bulb:
F
r
emove the two bulb holder fixing screws,
F
s
pread the four tabs and remove the bulb
h
o l d e r,
F
t
urn the bulb a quarter of a turn and change it.
Changing rear lamp bulbs
(t y p e 1)
After removing the lamp unit, carry out the following operations to replace the failed bulb:
F
r
emove the three bulb holder fixing screws,
F
s
pread the three tabs and remove the bulb
h
o l d e r,
F
t
urn the bulb a quarter of a turn and change it.To refit, carry out these operations in reverse
o r d e r.
Changing rear lamp bulbs
(type
2)
Take care to engage the lamp unit in its g
uides, while keeping it in line with the
v
ehicle.
Tighten
sufficiently to ensure sealing,
b
ut without forcing, so as to avoid
d
amaging
t
he
lam
p.
In the event of a breakdown