2016 Citroen C1 RHD low oil pressure

10
Limit the causes of excess consumption
Spread loads throughout the vehicle; place the heaviest items in the bottom   of   the   boot,   as   close   as   possible   to   the   rear   seats.
Limit
  the   loads   carried   in   the   vehicle   and   reduce   wind   resistance  
(roof
  bars,   roof   rack...).   Use   a   roof   box   in   preference.
Remove
  roof   bars   and   roof   racks   after   use.
At
  the   end   of   winter,   remove   snow   tyres   and   refit   your   summer   tyres.
Observe the recommendations on
maintenance
Check the tyre pressures regularly, when cold, referring to the label in the   door   aperture,   driver's   side.
Carry
  out   this   check   in   particular:
-
 
b
efore   a   long   journey,
-
 
a
t   each   change   of   season,
-
 
a
fter   a   long   period   out   of   use.
Don't
  forget   the   spare   wheel   and   the   tyres   on   any   trailer   or   caravan.
Have
  your   vehicle   serviced   regularly   (engine   oil,   oil   filter,   air   filter,  
p

assenger   compartment   filter...)   and   observe   the   schedule   of  
o

perations   recommended   in   the   maintenance   and   warranty   guide.
When
  refuelling,   do   not   continue   after   the   third   cut-off   of   the   nozzle   to  
a

void   any   over flow.
At
  the   wheel   of   your   new   vehicle,   it   is   only   after   the   first   1   800   miles  
(

3 000   kilometres)   that   you   will   see   the   fuel   consumption   settle   down   to  
a

  consistent   average.
Eco-driving

16
Brakingfixed. The   braking   system   fluid   level   has  d
ropped s ignificantly.Top
  up   with   brake   fluid   recommended   by   CITROËN.
If   the   problem   persists,   have   the   system   checked   by   a  
C

ITROËN   dealer   or   a   qualified   workshop.
The
  braking   system   has   a   fault. Stop   as   soon   as   it   is   safe   to   do   so.
Park,
  switch   off   the   ignition   and   contact   a   CITROËN  
d

ealer   or   a   qualified   workshop.
Warning


/ indicator lamp
State Cause Action

/ Observations
Engine oil
pressure fixed,
  associated   with  
t

he   STOP   warning  
lam

p.The
  engine   oil   pressure   is   too   low. Stop   as   soon   it   is   safe   to   do   so.
Park,
  switch   off   the   ignition   and   contact   a   CITROËN  
d

ealer   or   a   qualified   workshop.
Coolant
temperature flashing
 
(

VTi   68   engine   only).The
  temperature   of   the   engine  
c

oolant
 i
s
 inc
reasing.Drive
  gently.
fixed. The
  temperature   of   the   engine  
c

oolant   is   too   high.Stop
  as   soon   as   it   is   safe   to   do   so.
Wait
  until   the   engine   has   cooled   down   before  
c

hecking   up   the   level;   top   up   if   necessary.
If
  the   problem   persists,   contact   a   CITROËN   dealer   or  
q

ualified
 w
orkshop.
Anti-lock
Braking System
(ABS) fixed.
The
  anti-lock   braking   system   has   a  
f

ault.The
  vehicle   retains   conventional   braking.
Drive
  carefully   at   reduced   speed   and   contact   a  
C

ITROËN   dealer   or   a   qualified   workshop   without  
d

e l ay.
Instruments

149
Topping-up the engine oil
Oil grade
The  oil   must   be   the   correct   grade   for   your  
e

ngine   and   conform   to   the   manufacturer's  
r

ecommendations.
Refer
  to   the   under-bonnet   view   for   the   location  
o

f   the   oil   filler   cap   on   your   vehicle.
F

U
nscrew the filler cap for access to the
filler
  orifice.
F
 
P
our   in   the   oil   in   small   quantities,   avoiding  
s

pills   onto   the   engine   (risk   of   fire).
F
 
W
ait   a   few   minutes   before   checking   the  
l

evel   again   using   the   dipstick.
F
 
T
op-up   again   if   necessary.
F
 
A
fter   checking   and   topping   up,   carefully  
r

efit   the   oil   filler   cap   and   the   dipstick   to   its  
h

ousing.
Engine oil change
Refer to the manufacturer's service schedule for   details   of   the   interval   for   this   operation.
In
  order   to   maintain   the   reliability   of   the   engine  
a

nd   emissions   control   system,   never   use  
a

dditives   in   the   engine   oil.
Coolant level
The coolant level must be:
-  b etween   the   "FULL " or "F"
  and  
"LO

W" or " L"
  marks   for   VTi   68  
a

nd   VTi   68   S&S   engines,
In
 
addition,   as   the   cooling   system   is   pressurised,
 w

ait
 
at
 
least   one   hour   after   switching   off   the
 e

ngine
 
before   carrying   out   any   work.
To
 
avoid
 
any   risk   of   scalding,   unscrew   the   cap
 b

y
 
two
 
turns   to   allow   the   pressure   to   drop.   When
 t

he
 
pressure   has   dropped,   remove   the   cap   and
 t

op
 
up
 
the
  level.
Fluid specification
The coolant must conform to the ma nufacturer's r ecommendations.
The cooling fan may star t after switching
off the engine: take care with ar ticles and
clothing that might be caught by the fan
blades. -  
b
etween   the   "
MIN "   and   "
MAX "   marks   for  
t

he   PureTech   82   engine.
When   the   engine   is   warm,   the   temperature   of  
t

he   coolant   is   regulated   by   the   fan.
7
Practical information

155
F Check  that   the   compressor   switch   is   at   the  "O "
  position.
F
 
U
ncoil   fully   the   electric   cable,   stowed   under  
t

he   compressor.
F
 
C
onnect   the   compressor's   plug   to   the  
v

ehicle's   12   V   socket.
F
 
S
witch   on   the   ignition. Take
  care,   the   sealant   product   is  h
armful   if   swallowed   and   causes  i
rritation   to   the   eyes.
Keep
  this   product   out   of   the   reach   of  
c

hildren.
The
  use-by   date   is   marked   on   the  
c

artridge.
After
  use,   do   not   discard   the  
c

artridge   by   the   roadside,   take   it   to  
a

  CITROËN dealer   or   an   authorised  
w

aste   disposal   site.
Don't
  forget   to   obtain   a   new   sealant  
c

artridge,   available   from   a   CITROËN  
d

ealer   or   a   qualified   workshop.
If
  after   around   5   to   7   minutes   the  
p

ressure   is   not   attained,   this   indicates  
t

hat   the   tyre   is   not   repairable;   contact  
a

  CITROËN   dealer   or   a   qualified  
w

orkshop   for   assistance.
F  S tart   the   compressor   by   placing   the   switch  a
t the "I"
  position   and   leave   it   running   until  
t

he   tyre   pressure   reaches   2.0   bar.
 T

he   sealant   product   is   injected   into   the   tyre  
u

nder   pressure;   do   not   disconnect   the   pipe  
f

rom   the   valve   during   this   operation   (risk   of  
sp

lashing
 an
d
 s
tains).
8
In the event of a breakdown