2016 CHRYSLER 200 transmission

Under normal operating conditions, the catalytic con-
verter will not require maintenance. However, it is im-
portant to keep the engine properly tuned to assure
proper catalyst operation and prevent possible catalyst
damage.
NOTE:Intentional tampering with emissions control
systems can result in civil penalties being assessed
against you.
In unusual situations involving grossly malfunctioning
engine operation, a scorching odor may suggest severe
and abnormal catalyst overheating. If this occurs, stop
the vehicle, turn off the engine and allow it to cool.
Service, including a tune-up to manufacturer’s specifica-
tions, should be obtained immediately. To minimize the possibility of catalytic converter dam-
age:
•
Do not shut off the engine or interrupt the ignition,
when the transmission is in gear and the vehicle is in
motion.
• Do not try to start the engine by pushing or towing the
vehicle.
• Do not idle the engine with any spark plug wires
disconnected or removed, such as when diagnostic
testing, or for prolonged periods during very rough
idle or malfunctioning operating conditions.
608 MAINTAINING YOUR VEHICLE

WARNING!(Continued)
can severely damage your brake system and/or
impair its performance. The proper type of brake
fluid for your vehicle is also identified on the
original factory installed hydraulic master cylinder
reservoir.
• To avoid contamination from foreign matter or
moisture, use only new brake fluid or fluid that has
been in a tightly closed container. Keep the master
cylinder reservoir cap secured at all times. Brake
fluid in a open container absorbs moisture from the
air resulting in a lower boiling point. This may
cause it to boil unexpectedly during hard or pro-
longed braking, resulting in sudden brake failure.
This could result in a collision.
• Overfilling the brake fluid reservoir can result in
spilling brake fluid on hot engine parts, causing
(Continued)
WARNING! (Continued)
the brake fluid to catch fire. Brake fluid can also
damage painted and vinyl surfaces, care should be
taken to avoid its contact with these surfaces.
• Do not allow petroleum based fluid to contaminate
the brake fluid. Brake seal components could be
damaged, causing partial or complete brake failure.
This could result in a collision.
Automatic Transmission
Selection Of Lubricant
It is important to use the proper transmission fluid to
ensure optimum transmission performance and life. Use
only the manufacturer’s specified transmission fluid.
Refer to “Fluids, Lubricants, And Genuine Parts” in this
section for fluid specifications. It is important to maintain
the transmission fluid at the correct level using the
recommended fluid.
616 MAINTAINING YOUR VEHICLE

NOTE:No chemical flushes should be used in any
transmission; only the approved lubricant should be
used.
CAUTION!
Using a transmission fluid other than the manufac-
turer ’s recommended fluid may cause deterioration
in transmission shift quality and/or torque converter
shudder. Refer to “Fluids, Lubricants, And Genuine
Parts” in this section for fluid specifications.
Special Additives
The manufacturer strongly recommends against using
any special additives in the transmission. Automatic
Transmission Fluid (ATF) is an engineered product and
its performance may be impaired by supplemental addi-
tives. Therefore, do not add any fluid additives to the transmission. Avoid using transmission sealers as they
may adversely affect seals.
CAUTION!
Do not use chemical flushes in your transmission as
the chemicals can damage your transmission compo-
nents. Such damage is not covered by the New
Vehicle Limited Warranty.
Fluid Level Check
The fluid level is preset at the factory and does not
require adjustment under normal operating conditions.
Routine fluid level checks are not required, therefore the
transmission has no dipstick. Your authorized dealer can
check your transmission fluid level using special service
tools. If you notice fluid leakage or transmission malfunc-
tion, visit your authorized dealer immediately to have7
MAINTAINING YOUR VEHICLE 617

the transmission fluid level checked. Operating the ve-
hicle with an improper fluid level can cause severe
transmission damage.
CAUTION!
If a transmission fluid leak occurs, visit your autho-
rized dealer immediately. Severe transmission dam-
age may occur. Your authorized dealer has the proper
tools to adjust the fluid level accurately.
Fluid And Filter Changes
Under normal operating conditions, the fluid installed at
the factory will provide satisfactory lubrication for the
life of the vehicle.
Routine fluid and filter changes are not required. How-
ever, change the fluid and filter if the fluid becomes
contaminated (with water, etc.), or if the transmission is
disassembled for any reason.
Appearance Care And Protection From Corrosion
Protection Of Body And Paint From Corrosion
Vehicle body care requirements vary according to geo-
graphic locations and usage. Chemicals that make roads
passable in snow and ice and those that are sprayed on
trees and road surfaces during other seasons are highly
corrosive to the metal in your vehicle. Outside parking,
which exposes your vehicle to airborne contaminants,
road surfaces on which the vehicle is operated, extreme
hot or cold weather and other extreme conditions will
have an adverse effect on paint, metal trim, and under-
body protection.
The following maintenance recommendations will enable
you to obtain maximum benefit from the corrosion
resistance built into your vehicle.
618 MAINTAINING YOUR VEHICLE

Cavity Cartridge FuseBlade FuseDescription
F20 –10 Amp Red A/C Compressor Clutch
F21 – – Not Used
F22 – 5 Amp Tan Radiator Fan Enable
F23 – 70 Amp Tan Body Controller Module (BCM) –
Feed 2
F23 –50 Amp Red Voltage Stability Module (VSM) #2 –
If Equipped With Engine Stop/Start Option
F24 – – Not Used
F25B –20 Amp Yellow Front Washer Pump – If Equipped with
Engine Stop/Start Option
F26 – – Not Used
F27 – – Not Used
F28 –15 Amp Blue Transmission Control Module (TCM)
F29 – – Not Used
628 MAINTAINING YOUR VEHICLE

Chassis
ComponentFluid, Lubricant, or Genuine Part
Automatic Transmission Use only MOPAR ZF 8&9 Speed ATF Automatic Trans-
mission Fluid, or equivalent.
Failure to use the correct fluid may affect the function or
performance of your transmission.
Brake Master Cylinder We recommend you use MOPAR DOT 3 Brake Fluid,
SAE J1703 should be used. If DOT 3, SAE J1703 brake
fluid is not available, then DOT 4 is acceptable. Use only
recommended brake fluids.
7
MAINTAINING YOUR VEHICLE 657

AlarmArm The System ........................19
Disarm The System .......................20
Rearming The System .....................19
Tamper Alert ...........................21
Vehicle Security Alarm ....................19
Alarm, Panic .............................24
Alarm (Security Alarm) .....................325
All Wheel Drive (AWD) .....................464
Alterations/Modifications, Vehicle ...............7
Antifreeze (Engine Coolant) ...............610, 653
Disposal ............................. .613
Anti-Lock Brake System (ABS) ................475
Anti-Lock Warning Light ....................341
Appearance Care ........................ .618
Assist, Hill Start ......................... .478
Auto Down Power Windows ..................42
Automatic Door Locks ......................34
Automatic Headlights ..................... .160Automatic High Beams
.....................161
Automatic Temperature Control (ATC) ..........416
Automatic Transaxle ...................... .451
Automatic Transmission .................453, 618
Adding Fluid ...................... .618, 657
Fluid And Filter Changes ..................618
Fluid Change ......................... .618
Fluid Level Check ...................616, 617
Fluid Type ........................ .616, 657
Special Additives ...................... .617
Autostick .............................. .461
Auto Unlock, Doors ........................34
Auto Up Power Windows ....................43
Axle Lubrication ......................... .657
Battery ............................ .327, 599
Charging System Light ...................327
Keyless Transmitter Replacement (RKE) ........25
Remote Battery Replacement ................25
10
INDEX 679

Transmitter Battery Replacement.............25
Belts, Seat ...............................110
Body Mechanism Lubrication .................605
B-Pillar Location ......................... .495
Brake Assist System ...................... .478
Brake Control System, Electronic ..............475
Brake Fluid ............................ .657
Brake System ........................ .474, 615
Anti-Lock (ABS) ....................... .474
Fluid Check ....................... .615, 657
Master Cylinder ....................... .615
Warning Light ........................ .323
Brake/Transmission Interlock .................453
Brightness, Interior Lights ...................167
Bulb Replacement ..................639, 641, 646
Bulbs, Light .......................112, 639, 646
Camera, Rear ........................... .268
Capacities, Fluid ......................... .653Caps, Filler
Fuel ................................ .532
Oil (Engine) ....................589, 590, 597
Radiator (Coolant Pressure) ................612
Carbon Monoxide Warning ...............109, 528
Cargo Area Features ...................... .304
Cargo Compartment ...................... .304
Car Washes ............................ .619
Certification Label ........................ .536
Chains, Tire ............................ .512
Changing A Flat Tire ...................... .558
Chart, Tire Sizing ........................ .489
Check Engine Light (Malfunction Indicator Light) . .592
Checking Your Vehicle For Safety ..............108
Checks, Safety .......................... .108
Child Restraint ............................86
Child Restraints Booster Seats ...........................90
Center Seat LATCH ......................99
680 INDEX