2016 AUDI Q3 wiper fluid

Instruments and indicator lights
Drive to your authorized Audi dea ler immediately
to have the ma lfunction corrected .
c:> Windshield washer fluid level
Ill Please refill washer fluid.
If the symbol ill uminates, add w indshield was her
fluid to the w indshield washer system .
~ Engine start system
€·I ~ngine start system: Malfunction! Plea se
con tact dealer.
If th e indicator light t urns on and the message
appears, do
not switch the ign ition off because
you may not be ab le to sw itch it on again.
Drive to yo ur a uthorized Aud i dea le r i mmediately
to have the ma lf u nct ion corrected .
Engine start sy stem: Malfunction . Plea se con­
tact dealer .
There is a malfunction in the eng ine start system .
Drive to you r authori zed Aud i dea ler immediately
to have the malfunct ion corrected.
~ Defective light bulb warning
If the rtl i ndicato r light turns on, a bulb has
fa iled. The message ind icates the location of the
bu lb.
V ehicle lights: Sy stem f ault!
If the message appears, there is a ma lfunction in
the headlights or light switch.
Drive to yo ur autho rized Audi dea le r i mmedia tely
to have the malf unction corrected .
A WARNING
-Light bu lbs are p ressurized and could ex­
plode while they a re being changed caus ing
serious persona l injury.
- Work with due ca re when handling the high­
vo ltage section of gas discharge (xenon)
lights* . Failure to do so could result in death
or serious injury.
18
(D Tips
Have the bu lb replaced or the connection re­
paired by your authorized A udi Se rvice depart­
ment.
i,0 Headlight range control
fl H ea dlight range control: Sy stem fault!
If the symbol II ill uminates, the dynamic head­
li ght range contro l is no longer working properly.
Have the system checked and repaired at your au­
thorized Audi dea ler .
~O Audi Adaptive Light
App lies to vehicles: wit h Audi adapt ive light
rlJ Audi adaptive light : System fault!
If the indicator light turns on and this message
appears, there is a ma lfunction in the adaptive
li ght system . The headlights still function .
Go to an authorized dealership to have the head­
li ghts or the contro l unit for the adapt ive light re­
paired.
@:) Light/rain sensor
App lies to vehicles : wit h lig ht/ ra in sensor
£1 Automat ic headlights /wipers: System fault!
If the indicator light turns on and this message
appears, the light/rain sensor is not functioning
correctly.
For safety reasons the low beams are turned on
permanently with the switch in
AUTO . However,
you can continue to turn the lights on and off us­
i ng the lig ht switch . You can still contro l all func­
tions that are independent of the rain sensor
through the windsh ield wiper lever .
Contact your authori zed Aud i dea ler as soon as
possible to have the problem corrected.
g Adaptive dampers
App lies to vehicles: wit h Audi drive se lect and a daptive damp ­
ers
R Suspension : System f ault!
The re is an adaptive dampe r mal func tion.

Lights and Vi sion
function . Check your windshield wiper
blades regularly.
- The washer fluid nozzles of the windshield
washer system are heated at low tempera­
tures when the ignition is on.
- When stopping temporarily, such as at a
traffic light, the speed of the windshie ld
wipers automatically reduces by one level.
Cleaning windshield wiper blades
Clean the wiper blades when you see wiper
streaks. Use a sof t cloth and a glass cleaner .
Windshield wiper
~ Place the windshield wiper arms in the service
position ¢
page 46.
~ Fold the windshield wiper arm away from the
windshield.
Rear window wiper
~ Fold the windshield wiper arm away from the
rear window .
A WARNING
Dirty windshield wiper blades can impair vi­
sion, which increases the risk of an accident .
Replacing front windshield wiper blades
Fig. 47 Remov ing w inds hield w iper b lades
Wiper service position/blade replacement
position
~ Switc h the windshield wipers off (position @
¢ page 45, fig. 45).
-
~ Switch off the ignition and hold the w indshield
wiper lever in pos ition @¢
page 45, fig. 45 un-
46
til the windshield wiper moves into the service
position .
~ To bring the wiper b lades back into the origina l
position, switch the ignition on and operate the
w indshield wiper lever.
Removing the wiper blade
~ Fold the windshie ld wiper arm away from the
windshield.
~ Press the locking knob(!)¢ fig. 47 on the wiper
blade. Hold the wiper blade firmly.
~ Remove the wiper blade in the direction of the
arrow.
Installing the wipe r blade
~ Insert the new wiper blade into the mount on
the wiper arm @until you hear it latch into
place .
~ Place the wiper arm back on the windsh ield.
~ To bring the wiper blades back into the original
position, switch the ignition on and operate the
w indshield w iper lever.
.&_ WARNING
-
For safety reasons, the windshield wipe r
blades should be replaced once or twice each
year.
(UJ Note
- Th e windshie ld wiper blades must only be
replaced when in the service position! Oth­
erwise, you ris k damaging the paint on the
hood or the windshield wiper moto r.
- You should not move your vehicle or press
the windsh ield wiper lever when the wiper
arms are folded away from the windshie ld.
The windshie ld wipers would move back in­
to their original position and could damage
the hood and windshie ld.
- To help prevent damage to the wiper sys­
tem, always loosen blades which are frozen
to the windshield before operating wipers.
- To help prevent damage to wiper blades, do
not use gasoline, kerosene, paint thinner, or
other so lvents on or near the wiper blades.
- To help prevent damage to the wiper arms
or other components, do not attempt to
move the wipers by hand .

Engine compartment fuse assignment
The fuse number is stamped into the plastic be­
low or above each fuse.
No. Equipment
1 Transmiss ion supply
2 ESC
3 Horn
4 DC/DC
converter
5 BCM, battery data module
6 BCM (right)
7 Washer fluid pump
8 BCM (left)
9 Seat adjustment lumbar support
10 Heat oxygen sensor
11 Steering
column lever, multifunction
steering wheel contro ls
1 2 Cell phone adapter
13 Engine control
module
14 Engine control module
15 Gateway
16 Heated oxygen sensor, fuel pump,
engine
components
17 Engine components
18 Fue l pump control module
19 Sound
amplifier, DC/DC converter
20 Clutch pedal sensor, brake light sensor
22 Windshield wipers
23 Water circu
lation pump, auxiliary heater
24 Ignition coils
25 Driver's door
control module (central lock-
ing, window regu lators)
26 Front
passenger's door control module
(centra l locki ng, window reg ulators)
27 Terminal 15 supply
29 Powe r seat adjustment
30 ESC
Fuses an d bulb s
Bulbs
Replacing light bulbs
For your safety, we recommend that you have
your authorized Audi dealer replace any bulbs for
you .
It is becoming increasingly more and more diffi­
cult to replace vehicle light bulbs since in many
cases, other parts of the car m ust first be re­
moved before you are able to get to the bulb .
T his applies especially to the light bulbs in the
front of your car which you can only reach
through the engine compartment .
Sheet metal and bu lb holders can have sharp
edges that can cause serious cuts, pa rts must be
correctly taken apart and then properly put back
together to help prevent breakage o f parts and
long term damage from water that can enter
housings that have not been properly resealed.
For your safety, we recommend t hat you have
your authorized Aud i dea le r rep lace any bulbs fo r
you, since your dealer has the proper tools, the
correct bulbs and the expertise.
Gas di schar ge la mps (Xe no n light s):
Due to the high electr ical voltage, have the bulbs
rep laced by a qualified technician. Headlights
with Xenon light are identified by the hig h volt­
age st icker.
LED headlights* require no maintenance . Please
contact your authorized Audi dea ler if a bulb
needs to be replaced.
_&. WARNING
Changing Xenon lamps wi thout the necessary
equipment can cause serious personal injury .
- Bulbs are pressu rized and can explode when
be ing changed. Potent ial ris k of injury!
- On veh icles equipped with gas disc harge
bu lbs (Xenon light) life-threatening injuries
can resu lt from improper handling of the
high-vo ltage portions of such lamps!
- Only your authorized A udi dealer or quali­
fied workshop sho uld change the bulbs in
gas discharge lamps. There are parts with
sharp edges on the openings and on the
221

When must a safety belt be replaced? . . . . 106
When must the airbag system be inspected?
l22
Where are lower anchorages located? . . . . 145
W indow regulators . . . . . . . . . . . . . . . . . . . . . 36
Child safety lock . . . . . . . . . . . . . . . . . . . . . . 36
Windows Cleaning/remov ing ice ...... ...... ... . 170
Defrost ing (manual climate contro l system) .64
Windshield cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45
Defrost ing (automat ic climate control sys-
tem) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 65
Defrost ing (manual climate contro l system) .64
Windshield washer fluid level . . . . . . . . . . . . 18
Windshield washer system
W indshield wipers 45,190
C leaning wipe r blades . . . . . . . . . . . . . . . . . 46
Folding up . . . . . . . . . . . . . . . . . . . . . . . . . . 46
Replac ing windsh ield wiper blades . . . . . . . 46
Replacing wiper blades . . . . . . . . . . . . . . . . 47
Sw itching on and
off . . . . . . . . . . . . . . . . . . 45
Winter driving
Snow chains . . . . . . . . . . . . . . . . . . . . . . . .
206
Tires . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 206
Winter operation
Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . 187
Coolant system . . . . . . . . . . . . . . . . . . . . . 183
Defrost ing the windshield (automatic cli-
mate control system) . . . . . . . . . . . . . . . . . 65
Windshield washer system . . . . . . . . . . . . 190
W inter tires . . . . . . . . . . . . . . . . . . . . . . . . . .
206
Winter use
Car washes . . . . . . . . . . . . . . . . . . . . . . . . . 168
Removing ice from windows 170
X
Xenon headlights . . . . . . . . . . . . . . . . . . . . . 221
Ind ex
247