2016 Abarth 500 lights

Warning lights on
displayWhat it means What to do
flashing red or
constantly yellow (for
versions/markets,
where provided)ENGINE OIL DETERIORATED
The symbol lights up and a specific message is shown on the display.
The symbol may flash in the following ways, depending on the versions:
- for 1 minute every two hours;
- for 3 minute cycles with the warning light off for intervals of 5 seconds
until oil is changed.
After the first indication, each time the engine is started the symbol will
continue to flash as described above until the oil is changed. In addition
to the symbol, the display will show a dedicated message. If the symbol
flashes, this does not mean that there is a fault, but simply informs that it
is now necessary to change the oil as a result of regular use of the car. If
the oil is not changed, when a second degradation threshold is reached,
the warning light
also switches on in the instrument panel and the
engine operation is limited to 3000 rpm. If the oil is still not changed,
when a third deterioration threshold is reached, the engine is limited to
1500 rpm to avoid damage. Engine oil deterioration is accelerated by:
- mainly town use of the car which makes the DPF regeneration process
more frequent;
- use of the vehicle for short drives, in which the engine does not have
time to reach its regular operating temperature;
- repeated interruptions of the regeneration process, signalled by the DPF
warning light switching on.Contact an Abarth
Dealership as soon as
possible.64)
14)
93

Warning lights on
displayWhat it means What to do
redENGINE COOLANT TEMPERATURE
TOO HIGH
This symbol comes on when the ignition
key is turned to MAR-ON, but it should
switch off after a few seconds. The symbol
on the display lights up when the engine
has overheated.
The display shows the dedicated message.If the symbol on the display switches on when driving,
proceed as follows:
When driving normally: stop the car, switch off the
engine and check that the water level in the reservoir is
not below the MIN mark. If it is, wait for the engine to
cool down, then slowly and carefully open the cap, top
up with coolant and check that the level is between the
MIN and MAX marks on the reservoir. Also check
visually for any fluid leaks. Contact an Abarth
Dealership if the symbol comes on when the engine is
started again.
If the car is used under demanding conditions
(e.g. high-performance driving or towing trailers):
slow down and, if the symbol stays on, stop the car.
Wait for 2 or 3 minutes with the engine running and
slightly accelerated to further favour the coolant
circulation. Then stop the engine. Check the correct
coolant level as described above.
IMPORTANT Over demanding routes, it is advisable to
keep the engine on and slightly accelerated for a few
minutes before switching it off.
94
KNOWING THE INSTRUMENT PANEL

Warning lights on
displayWhat it means What to do
redLOW BATTERY CHARGE
The symbol comes on when the ignition key is
turned to MAR-ON, but it should go out as soon
as the engine has started (with the engine running
at idle speed a brief delay before going out is
acceptable).
The display shows the dedicated message.If the symbol on the display stays on when
driving, contact an Abarth Dealership as soon as
possible.
amberHILL HOLDER FAILURE
The symbol is shown on the display when a fault
in the Hill Holder system is detected.Contact an Abarth Dealership as soon as
possible.
amberFIAT CODE SYSTEM FAILURE
(for versions/markets, where provided)
If, with the ignition key at MAR-ON, the symbol
on the display stays on constantly, this indicates a
possible failure (see the "Fiat CODE system"
paragraph in the "Knowing your car" chapter).
If, with the engine running, the symbol in the
displayis flashing, this means that the vehicle
is not protected by the engine immobilizer device
(see "Fiat CODE system" in the "Knowing your
car" chapter).
The display shows the dedicated message.Contact an Abarth Dealership as soon as
possible.
95

Warning lights on
displayWhat it means What to do
amberFUEL RESERVE/LIMITED RANGE
This symbol comes on when the ignition key is
turned to MAR-ON, but it should switch off after a
few seconds.
The symbol switches on in the display when
about 5 litres of fuel are left in the tank.
The triangle on the right side of thesymbol
indicates the side of the car with the fuel filler.IMPORTANT If the symbol flashes or is constantly
on, depending on the version, there is a fault in
the system. If this is the case, go to an Abarth
Dealership to have the system checked.
amberFUEL CUT-OFF
The display will show the symbol and a dedicated
message if the fuel cut-off system intervenes.For the fuel cut-off system reactivation procedure,
refer to the "Fuel cut-off system" section of the
"Controls" paragraph, in the "Knowing your car"
chapter. If it is still not possible to restore the fuel
supply, contact an Abarth Dealership.
amberFUEL CUT-OFF SYSTEM FAILURE
The display will show the symbol and a dedicated
message if the fuel cut-off system is faulty.See the "Fuel cut-off system" paragraph, in the
"Knowing your car" chapter.
red
red
redINCOMPLETE DOOR LOCKING
The symbol on the display switches on, together
with a dedicated message, when one or more
doors, the tailgate or the bonnet (for versions/
markets where provided) are not properly closed.
An acoustic signal is activated with the doors
open and the car moving.
96
KNOWING THE INSTRUMENT PANEL

Warning lights on
displayWhat it means What to do
amberEXTERIOR LIGHTS FAILURE
On some versions, the display will show the
symbol and a dedicated message if a fault is
detected in one of the following lights:
❒daytime running lights (DRL)
❒side lights
❒direction indicators
❒rear fog light
❒number plate lights.The fault may be caused by a blown bulb, a
blown protective fuse or a break in the electrical
connection.
amberASR SYSTEM
The symbol on the display flashes to indicate the
intervention of the ASR system.
amberPOSSIBLE ICE ON ROAD
The symbol is displayed when the outside
temperature falls to or below 3°C.
The display shows the dedicated message.
amberBRAKE LIGHT FAILURE
The display will show the symbol together with a
dedicated message if there is a fault in the brake
lights.
amberPARKING SENSOR FAILURE
The symbol is shown on the display together with
a dedicated message if there is a fault in the
parking sensors.
97

Warning lights on
displayWhat it means What to do
amberiTPMS
(for versions/markets, where provided)
When the key is turned to MAR-ON, the warning
light switches on but it should switch off after a
few seconds.IMPORTANT Do not continue driving with one or
more flat tyres as handling may be compromised.
Stop the vehicle, avoiding sharp braking and
steering.
Low tyre pressure
The warning light switches to indicate that the
pressure of one or more tyres is lower than the
recommended value, in order to guarantee long
tyre life and low fuel consumption, or to indicate a
slow loss of pressure.
In this way the iTPMS warns the driver that one or
more tyres may be flat and probably punctured.In this case it is advisable to restore the correct
pressure value (see the "Wheels" paragraph in the
"Technical specifications" section).
Once the normal operating conditions of the
vehicle are restored, carry out the Reset
procedure.
iTPMS failure/iTPMS temporarily deactivated
The warning light flashes for about 75 seconds
and then stays on constantly (together with a
message on the display) (see “Operating
conditions” paragraph) to indicate that the system
is temporarily deactivated or faulty.
The system goes back to normal operation when
the operating conditions allow it. If this is not the
case, carry out the Reset procedure after
restoring the normal operating conditions.If the malfunction warning persists, contact an
Abarth Dealership as soon as possible.
98
KNOWING THE INSTRUMENT PANEL

Warning lights on
displayWhat it means What to do
amberSERVICE (SCHEDULED SERVICING)
The symbol is shown on the display together with
a dedicated message, with key at MAR-ON,
2,000 km (or equivalent value in miles) before the
following scheduled servicing interval and is
activated again every 200 km (or equivalent value
in miles).Go to an Abarth Dealership, where the operations
of the "Scheduled Servicing Plan" will be
performed and the message will be reset.
whiteSPEED LIMIT EXCEEDED
(for versions/markets, where provided)
When the car exceeds the speed limit set in the
Setup menu (e.g. 120 km/h), a message and a
dedicated symbol are shown on the display.
ENGAGEMENT OF SPORT FUNCTION
The SPORT indication is shown on the analogue
pressure gauge and the instrument panel shows
a dedicated screen when the "SPORT" function is
engaged by pressing the relevant button on the
dashboard (see the "Controls" paragraph in the
"Knowing your car" chapter). The indication
SPORT will switch off when the button is pressed
again.
99

SAVING FUEL
GENERAL
CONSIDERATIONS
Car maintenance
Checks and adjustments should be
carried out in accordance with the
"Scheduled Servicing Plan" (see
chapter "Maintenance and care").
Tyres
Check the tyre pressures at least once
every four weeks: if the pressure is
too low, consumption levels increase as
resistance to rolling is higher.
Unnecessary loads
Do not travel with an overloaded
luggage compartment. The weight of
the car and its arrangement greatly
affect fuel consumption and stability.
When transporting particularly large
objects, use a trailer if possible.
Roof rack/ski rack
Remove the roof rack or the ski rack
from the roof after use. These
accessories lower aerodynamic
penetration and adversely affect
consumption levels.Electrical devices
Use electrical devices only for the
amount of time needed. The heated
rear window, additional headlights,
screen wipers and heater fan require a
considerable amount of energy;
increasing the current uptake increases
fuel consumption (by up to +25% in
an urban cycle).
Climate control system
Using the climate control system will
increase consumption: use the air vents
when the temperature outside permits.
Devices for
aerodynamic control
The use of non-certified devices for
aerodynamic control may adversely
affect air drag and consumption levels.
DRIVING STYLE
Cranking
Do not warm up the engine at low or
high revs when the car is stationary;
this causes the engine to warm up
more slowly, thereby increasing fuel
consumption and emissions. It is
therefore advisable to move off
immediately, slowly, avoiding high
speeds: in this way the engine will
warm up more quickly.Unnecessary actions
Avoid accelerating when stopped at
traffic lights or before switching off the
engine. The latter action, as well as
double-declutching, is unnecessary and
causes increased fuel consumption
and pollution.
Gear selection
Use a high gear when traffic and road
conditions allow it. Using a low gear for
faster acceleration will increase
consumption. In the same way
improper use of a high gear increases
consumption, emissions and engine
wear.
Max. speed
Fuel consumption considerably
increases as speed increases. Maintain
a constant speed, avoiding
unnecessary braking and acceleration,
which cost in terms of both fuel
consumption and emissions.
Acceleration
Accelerating violently severely affects
consumption and emissions:
acceleration should be gradual and
should not exceed the maximum
torque.
125