2015 VOLKSWAGEN BEETLE CONVERTIBLE light

The windows can freeze to the seals at low outside temperatures and prevent the windows from going down when the vehicle is unlocked or the door is opened. Do not open the door if the window does
not go down slightly ⇒ .
x Lock the vehicle again.
x Remove the ice with deicing spray.
x Unlock the vehicle and retry the function.
x If necessary, repeat until the windows are fully operational.
One-touch opening and closing
The one-touch feature automatically opens/closes a power window all the way. The window switch does not have to be held down/up.
For one-touch opening: Press the switch for the window down briefly as far as it goes.
For one-touch closing: Pull the switch for the window up briefly as far as it goes.
Stopping automatic movement: Pull/press the switch again.
Reactivating the one-touch feature
If the vehicle battery is disconnected or dead and the windows are not completely closed, the one-touch feature will not work and must be reactivated:
x Switch on the ignition.
x Close all windows and doors.
x Pull the - switch up and hold it for at least 2 seconds in this position.
x Release the - switch, pull up and hold again. The one-touch feature is now reactivated.
The one-touch feature can be reactivated for one or more windows at the same time.
WARNING
Improper use of power windows can result in serious personal injury.
x Never let anyone get in the way of a power window when closing it.
x When locking the vehicle from the outside, make sure that no one, especially children, remains in the vehicle. The windows will not open in case of an emergency.
x Always take the key with you when you leave the vehicle. You can still use the power win-dows for several minutes after the ignition is switched off as long as the driver or passenger door has not been opened.
NOTICE
The windows must go down slightly when you unlock the vehicle. Otherwise the windows and seals could be damaged when opening the doors.
If the power windows malfunction, the one-touch feature, as well as pinch protection may not work properly. See an authorized Volkswagen dealer or authorized Volkswagen Service Facility right away.
Power window pinch protection

x Only open and close the convertible top when it is clean.
NOTICE
If the convertible top is opened frequently when it is damp or it is left open for several weeks at a time, it may develop creases and pressure marks and could be damaged.
x Do not leave the convertible top open for long periods of time.
x Only open the convertible top when it is completely dry.
When parking the vehicle with the convertible top open, the vehicle interior is not protected against unauthorized access.
x Always close the convertible top and lock the doors and luggage compartment before leaving the vehicle.
x Always store objects left in the vehicle in the locked luggage compartment.
The convertible top will only open or close when the luggage compartment lid is completely closed. Do not open the luggage compartment lid when the convertible top is opening or closing.
Indicator light

Lights up Possible cause Proper response
Convertible top is opening or closing. Wait until the convertible top has fully opened or fully closed.


Flashes Possible cause Proper response
The convertible top opening or closing process is not finished or there is a con-vertible top malfunction.
Check if the opening or closing process has finished. If necessary, end the process using the convertible top button
Check if all technical requirements are met. If not, take the necessary steps to meet the technical requirements
Check if there is a convertible top malfunc-tion. If necessary, correct the malfunction or have the system checked by your authorized Volkswagen dealer or authorized Volkswagen Service Facility

Messages in the instrument cluster display
When the ignition is switched on, the indicator lights come on briefly for a function check. They go out after a few seconds.

Display text Proper response
Convertible top operation
This text message indicates the convertible top is currently opening or
closing. Press and hold the button ⇒ fig. 35 again until the opening or closing process has finished.

The instrument cluster displays and their arrangement may vary depending on the vehicle model and engine. For displays without warning and information messages, malfunctions are only signaled with indicator lights.
General information
Checklist
Perform the following preliminary requirements each time before opening or closing the con-vertible top:
1. Park the vehicle a safe distance from moving traffic.
2. Park the vehicle so that it is as level as possible. The vehicle must not be on a hoist, it must not have one side parked on a curb, and it must not be raised on a vehicle jack.
3. Remove all objects from the convertible top.
4. Remove all objects from the area of the convertible top compartment.
5. Remove ice and snow from the convertible top before opening.
6. Do not operate the convertible top in temperatures below 15 °F (-10 °C).
7. Allow the convertible top to dry completely before opening.
Checklist
The following technical requirements must be met to open or close the convertible top:
d The ignition must be switched on ⇒  Starting and stopping the engine.
d The vehicle speed must be no more than 30 mph (50 km/h).
d The outside temperature must be above +15 °F (-10 °C).
d The battery must have enough charge.
If any changes have been made in the operation of the convertible top compared with its original factory condition, Volkswagen strongly urges you to take the vehicle to an authorized Volkswagen dealer or other authorized Volkswagen Service Facility to have the top restored to its original condi-tion. Mechanical changes and changes to the vehicle software must be entered in the
⇒ Booklet Warranty and Maintenance.
WARNING
Disregarding the safety-related checklist may lead to accidents and serious personal injuries.
x Always review and follow the checklist. Follow accepted safety practices and use common sense.

On vehicles with Climatronic, you can set different heating and air conditioning temperatures for
operation with the convertible top up and down ⇒  Climatronic controls
Opening or closing the convertible top

Fig. 35 In the roof console: convertible top button.
You can open or close the convertible top at speeds up to 30 mph (50 km/h). If the convertible top has already begun opening or closing, it will stop if you exceed that speed. You can only continue opening or closing the convertible top once the vehicle speed drops below about 30 mph (50 km/h).
For safety reasons, Volkswagen recommends opening or closing the convertible top only when the
vehicle is stationary and parked at a safe distance from moving traffic ⇒ .
Opening the convertible top
x Please note and follow the steps described in the checklists ⇒ page 74, General information.
x Switch on the ignition, if necessary ⇒  Starting and stopping the engine.
x Press and hold the button ⇒ fig. 35 in the roof console until all windows go down and the con-
vertible top is completely open ⇒ . A chime sounds and the indicator light in the instrument cluster goes out when the process is complete. A message may also appear in the instrument cluster display.
x Secure the convertible top cover (boot), if necessary ⇒  Installing and removing the convertible top cover (boot).
Closing the convertible top
x Please note and follow the steps described in the checklists ⇒  General information.
x Switch on the ignition, if necessary ⇒  Starting and stopping the engine.
x Remove the convertible top cover (boot), if necessary ⇒Installing and removing the convertible top cover (boot).
x Pull and hold the button ⇒ fig. 35 until the convertible top and all windows close completely
⇒ : a chime sounds and the indicator light in the instrument cluster goes out. A message may also appear in the instrument cluster display.
Interrupting convertible top operation
Releasing the button interrupts convertible top operation ⇒ .

Installing and removing the wind blocker

Fig. 38 Unfolding the wind blocker.

Fig. 39 A: Sliding in the bars on the wind blocker. B: Sliding in the locking pins.
The wind blocker, if equipped, is in a storage compartment in the vehicle's luggage compartment.
You can close the convertible top even when the wind blocker is installed.
Unfolding the wind blocker
Folding the wind blocker outward before installing it is the easiest way to get it into the correct position for installation.
x Remove the wind blocker from the luggage compartment ⇒  Removing the wind blocker from the luggage compartment and storing.
x Fold both side sections outward in the direction of the arrows ⇒ fig. 38 until they lock into place.
Installing the wind blocker
The wind blocker is installed correctly when the longer side faces toward the front and the wind block-er frame is on top.
x Insert both pins on the driver side of the wind blocker into the holes in the side trim panel above the
rear seats ⇒ fig. 39 A (1) (magnified area).
x Fold the handle ⇒ fig. 39 B (4) at the front center of the wind blocker upward in the direction of the arrow and hold it in place.
x Pull the section of the wind blocker that is facing the front passenger side upward slightly.

x Insert both pins on the wind blocker on the front passenger side into the holes in the side trim
panel above the rear seats ⇒ fig. 39 B (2) (magnified area).
x Press down lightly on the center of the wind blocker ⇒ fig. 39 B (3) until it locks into place.
x Pull the top section of the wind blocker upward so it contacts the stops and snaps into place.
Removing the wind blocker
x Fold the upper section of the wind blocker down toward the rear of the vehicle.
x Fold the handle ⇒ fig. 39 B (4) at the front center of the wind blocker upward in the direction of the arrow and hold it in place.
x Pull the center of the wind blocker upward opposite the direction of the arrow ⇒ fig. 39 B (3).
x Remove both wind blocker retaining pins on the front passenger side from the holes in the side trim
panel opposite the direction of the arrows ⇒ fig. 39 B (2).
x Remove both wind blocker retaining pins on the driver side from the holes in the side trim panel
opposite the direction of the arrows ⇒ fig. 39 A (1).
Closing the wind blocker
x Fold the handle ⇒ fig. 39 B (4) at the front center of the wind blocker upward in the direction of the arrow and hold it in place.
x Fold both side sections inward opposite the direction of the arrow ⇒ fig. 38.
x Store the wind blocker in the luggage compartment ⇒  Removing the wind blocker from the lug-gage compartment and storing.
WARNING
Installing or removing the wind blocker by the side of the road near moving traffic can cause accidents and serious personal injuries.
x Always park the vehicle a safe distance from moving traffic when installing or removing the wind blocker.
x Never install or remove the wind blocker while driving.
WARNING
Incorrect seating positions in the vehicle increase the risk of serious of fatal injuries in the event of an accident or sudden driving and braking maneuvers.
x Never let anyone sit on the rear seats when the wind blocker is installed.
WARNING
Unsecured or improperly secured objects can cause severe injuries during sudden braking maneuvers or if the vehicle is involved in an accident while driving.
x Never place unsecured objects underneath the wind blocker.
x Never use the wind blocker as a storage shelf. Items on the wind blocker can be thrown around inside the vehicle by the wind and cause injuries.
x Never use the wind blocker to secure objects.

Removing the convertible top cover
x Press the release buttons on each side of the cover ⇒ fig. 40 A (1) and lift the convertible top cover at the inner side (arrows).
x Pull the convertible top cover out by the loop in area ⇒ fig. 40 A (2) (slide your other hand under the cover and lift area (2) up while pulling on the loop, if necessary).
x Pull the left and right sides of the cover out of the retainer ⇒ fig. 40 B (4).
x Pull the rear area of the convertible top cover ⇒ fig. 40 B (3) next to the seal above the luggage compartment lid.
x Remove the convertible top cover from the vehicle and fold it up. Clean the cover before folding, if necessary.
x Store the convertible top cover securely in the luggage compartment.
NOTICE
Dirt particles with sharp edges can cause abrasions and damage to the convertible top cover when it is folded.
x Clean the convertible top cover before folding it up.
The convertible top button does not work when the convertible top cover is installed. If the button is pressed anyway, the convertible top indicator light will blink as long as the button is pressed.
Convertible top troubleshooting

Description Possible solution
The convertible top will not open or will not close.
– Check to make sure all the preliminary and technical requirements for convertible top operation are met – If the convertible top still will not operate, use the emergency procedure to close the convertible top, if necessary – Have the system checked by an authorized Volkswagen dealer or an authorized Volkswagen Service Facility.
The convertible top stops when opening or closing.
– Check the instrument cluster display for information on what to do ⇒ table
– Pull the button ⇒ fig. 35 to completely close and latch the convertible top. – If the convertible top does not close completely and latch, try to close and
latch it using the emergency closing procedure ⇒  – Get professional help if necessary and have the system checked by an authorized Volkswagen dealer, an authorized Volkswagen Service Facility, or another qualified workshop.

Automatic Rollover Support System

Fig. 41 Behind the rear bench seat backrest: Automatic Rollover Support System.
The Automatic Rollover Support System® works with the reinforced windshield frame, properly worn safety belts, and the airbag system, to help protect vehicle occupants in a rollover accident.
If the Automatic Rollover Support System is triggered, 2 supports behind the rear seat backrest deploy upwards in a fraction of a second.
The Automatic Rollover Support System works only when the ignition is switched on. It deploys when the convertible top is open as well as when it is closed.
The Automatic Rollover Support System is electronically controlled together with the airbag system. A malfunction in the rollover support system is indicated by the airbag indicator light T in the instrument
cluster ⇒  Airbag system.
The Automatic Rollover Support System can only deploy one time. After the Automatic Rollover Sup-port System has deployed, you cannot slide it back into its original position. It must be replaced by an authorized Volkswagen dealer or an authorized Volkswagen Service Facility.
The Automatic Rollover Support System may deploy in the following situations:
x In driving situations in which the vehicle tips sharply to one side, consistent with the values pro-grammed into the electronic control module.
x In certain frontal, side, and rear-end collisions.
x In rollovers.
x If the vehicle briefly leaves the ground, for example when cresting a hill at a comparatively high speed.
WARNING
The Automatic Rollover Support System can cause serious injuries if persons or objects are in the way when it deploys.
x Never use accessory seat covers or protective covers that block the rollover protection deployment area.
x Every rear seat passenger must be properly seated on a seat of his or her own and must stay in a proper seating position at all times.
x Always keep the area around the supports free of anything that could interfere with their deployment or fly about and injure occupants when the supports deploy.
x Never take the covers off the Automatic Rollover Support System.
x Never attach a child seat, child restraints, straps, or anything else to the rollover protec-tion supports.