2015 VAUXHALL COMBO headlights

12In briefExterior lighting
Turn light switch:
§=off / daytime running lights9=sidelights / headlights
Lighting 3 89, Daytime running
lights 3 90.
Fog lights
Press light switch:
>=front fog lightsr=rear fog lightHeadlight flash, high beam and
low beamheadlight flash=pull leverhigh beam=push leverlow beam=pull lever
High beam 3 89, Headlight flash
3 89.

Lighting89LightingExterior lighting............................ 89
Interior lighting ............................. 92
Lighting features ..........................95Exterior lighting
Light switch
Turn light switch:
§=off / daytime running lights9=sidelights / headlights
Control indicator 8 3 80.
Tail lights
Tail lights are illuminated together
with headlights and sidelights.
High beam
To switch from low to high beam,
push lever.
To switch to low beam, pull lever.
Headlight flash
To activate the headlight flash, pull
lever.

90LightingHeadlight range
adjustment
Manual headlight range
adjustment
To adapt headlight range to the
vehicle load to prevent dazzling of
other road users: Press À or Á
buttons until the required setting is displayed in the Driver Information
Centre 3 80.
0=Front seats occupied1=All seats occupied2=All seats occupied and load
compartment laden3=Driver's seat occupied and load
compartment laden
Headlights when driving
abroad
The asymmetrical headlight beam
extends visibility at the edge of the
road at the passenger side.
However, when driving in countries
where traffic drives on the opposite
side of the road, adjust the headlights
to prevent dazzling of oncoming
traffic.
Have the headlights adjusted by a
workshop.
Daytime running lights
Daytime running lights increase
visibility of the vehicle during daylight.
When the function is activated and
the ignition is switched on, the
headlights come on automatically and
instrument illumination is subdued.
The light switch must be in position
§ . The daytime running lights switch
off when the ignition is switched off.
Notice
The driver remains responsible for
switching on the low beam when
required, e.g. when driving through
a tunnel or at night.
When the function is deactivated, the
headlights do not come on
automatically when the ignition is
switched on and the light switch is in
position §.
The daytime running lights function is activated/deactivated via a menu in
the Driver Information Centre 3 80.

92LightingRear fog lights
Operated by pressing the r button.
The rear fog light can only be
switched on when both the ignition
and headlights or sidelights (with front
fog lights) are on.
Press the button again to turn the rear fog light off, or turn off the headlights
and/or the front fog lights.
Reversing lights The reversing lights come on when
the ignition is on and reverse gear is
selected.
Misted light covers
The inside of the light covers may mist
up briefly in poor, wet and cold
weather conditions, in heavy rain or
after washing. The mist disappears
quickly by itself; to help, switch on the headlights.Interior lighting
Instrument panel
illumination control When driving at night with the
headlights on, adjust the brightness
of the vehicle's interior lighting
(including instrument panel, climate
control display etc.) via the settings
menu of the Driver Information Centre
3 80.
To adjust brightness:
Standard version of Driver
Information Centre
1. Press the SETq button once to
access the settings menu.
2. Scroll through the menu options using the R or S buttons until
menu option ILLU appears in the
display.

134Vehicle careHalogen headlights
Headlights have separate systems forlow beam/sidelight 1 (outer bulb),
high beam/daytime running light 2
(inner bulb).
To access bulbs, pull off protective
covers.
Low beam 1. Remove protective cover.
2. Detach connector from bulb.
3. Disengage wire clip and remove bulb from reflector.
4.Insert new bulb in reflector so that
the locating tab of the bulb aligns
with the reflector recess.
5. Attach connector to bulb.
6. Engage wire clip.
7. Install protective cover.
High beam 1. Remove protective cover.
2. Detach connector from bulb.
3. Disengage wire clip and remove bulb from reflector.4.Insert new bulb in reflector so that
the bulb aligns with the reflector
recess.
5. Engage wire clip and attach connector onto bulb.
6. Install protective cover.
Sidelight 1. Remove protective cover. Withdraw bulb holder from
reflector by turning anticlockwise.

156Vehicle care
3. Connect the black lead to thenegative terminal of the booster
battery.
4. Connect the other end of the black
lead to a vehicle grounding point,
such as the engine block or an
engine mounting bolt. Connect as far away from the discharged
battery as possible, however at
least 60 cm.
Route the leads so that they cannot
catch on rotating parts in the engine
compartment.
To start the engine: 1. Start the engine of the vehicle providing the jump.
2. After 5 minutes, start the other engine. Start attempts should be
made for no longer than
15 seconds at an interval of 1 minute.
3. Allow both engines to idle for approx. 3 minutes with the leads
connected.4. Switch on electrical consumers (e.g. headlights, heated rear
window) of the vehicle receiving
the jump start.
5. Reverse above sequence exactly when removing leads.Towing
Towing the vehicle
Release the cap by carefully lifting
with a screwdriver. To prevent
damage, it is recommended to place
a cloth between the screwdriver and
the frame.
The towing eye is stowed with the vehicle tools 3 143.
Screw in the towing eye as far as it will
go until it stops in a horizontal
position.
Attach a tow rope – or better still a tow
rod – to the towing eye.

178
HHalogen headlights ....................134
Hand brake ................................. 114
Hazard warning flashers ..............91
Headlight flash ............................. 89
Headlight range adjustment ........90
Headlights..................................... 89
Headlights when driving abroad ..90
Head restraint adjustment .............8
Head restraints ............................ 32
Heated mirrors ............................. 28
Heated rear window ..................... 31
Heating ........................................ 35
Heating and ventilation system ...96
High beam ............................. 80, 89
Hill start assist ...................... 76, 115
Horn ....................................... 13, 63
I
Identification plate .....................164
Ignition switch positions .............103
Immobiliser ............................ 26, 79
Indicators ...................................... 67
Information displays...................... 80
Initial drive information.................... 6 Instrument cluster ........................67
Instrument panel fuse box .........142
Instrument panel illumination .....139Instrument panel illumination
control ...................................... 92
Instrument panel overview ........... 10
Instrument panel storage ..............53
Interior care ............................... 159
Interior lighting ........................ 80, 92
Interior lights ........................ 93, 138
Interior mirrors .............................. 28
Introduction .................................... 3
ISOFIX child restraint systems ....52
J
Jump starting ............................. 155
K Kerb weight................................... 60Keys ............................................. 19
Keys, locks ................................... 19
L
Language ..................................... 80
Lashing eyes ......................... 59, 60
Light switch .................................. 89
Load compartment ................25, 55
Load compartment cover .............56
Load compartment lighting ...........94
Loading ......................................... 55
Loading information .....................60
Low engine oil level .....................79
Low fuel ....................................... 79M
Malfunction indicator light ............75
Manual adjustment ......................27
Manual anti-dazzle ......................28
Manual mode ............................. 112
Manual transmission .................. 109
Manual transmission automated 110
Manual windows ..........................29
Mirror adjustment ........................... 8
Misted light covers .......................92
Multifunction display .....................80
N New vehicle running-in ..............103
Number plate light .....................137
O Object detection systems ...........118
Odometer ..................................... 68
Oil, engine .......................... 162, 165
Operating windows from outside ..29
Outside temperature ....................64
Overhead console .......................54
Overrun cut-off ........................... 105
P Parking ................................ 18, 107
Parking assist ............................ 118
Parking brake ............................ 114
Particulate filter ........................... 108