2015 TOYOTA SIENNA check engine

[x] Cancel search: check engine

Page 228 of 664

TOYOTA SIENNA 2015 XL30 / 3.G Owners Manual 228
SIENNA_OM_01999-08001_(U)
4-2. Driving procedures
If  the engine  is stopped with the  shift lever in a  position other than P,
the  engine  switch  will  not  be  turned  off  but  instead  be  t

Page 230 of 664

TOYOTA SIENNA 2015 XL30 / 3.G Owners Manual 230
SIENNA_OM_01999-08001_(U)
4-2. Driving procedures
WARNING
■When starting the engine
Always start the engine while sitting in the driver’s seat. Do not depress the
accelerator pedal while start

Page 235 of 664

TOYOTA SIENNA 2015 XL30 / 3.G Owners Manual 235
SIENNA_OM_01999-08001_(U)
4-2. Driving procedures
4
Driving
Turn signal lever
Right turn
Left turn
Lane change to the right (move
the  lever  partway  and  release
it)
The  right  hand  signals  w

Page 250 of 664

TOYOTA SIENNA 2015 XL30 / 3.G Owners Manual 250
SIENNA_OM_01999-08001_(U)
4-3. Operating the lights and wipers
The sensor sensitivity can be adjusted when “AUTO” is selected.Increases the sensitivity
Decreases the sensitivity
Washer/wiper d

Page 252 of 664

TOYOTA SIENNA 2015 XL30 / 3.G Owners Manual 252
SIENNA_OM_01999-08001_(U)
4-3. Operating the lights and wipers
Rear window wiper and washer 
Turning  the  end  of  the  lever  turns  on  the  rear  window  wiper  and
washer.
The illustration is

Page 311 of 664

TOYOTA SIENNA 2015 XL30 / 3.G Owners Manual 311
SIENNA_OM_01999-08001_(U)
4-6. Driving tips
4
Driving
Winter driving tips
●Use  fluids  that  are  appropriate  to  the  prevailing  outside  tempera-
tures.
• Engine oil
• Engine coolant

Page 459 of 664

TOYOTA SIENNA 2015 XL30 / 3.G Owners Manual 459
SIENNA_OM_01999-08001_(U)
7Maintenance and care
7-1. Maintenance and careCleaning and protecting the vehicle exterior .......... 460
Cleaning and protecting  the vehicle interior ........... 463 7

Page 469 of 664

TOYOTA SIENNA 2015 XL30 / 3.G Owners Manual 469
SIENNA_OM_01999-08001_(U)
7-2. Maintenance
7
Maintenance and care
General maintenance
Listed below are the general maintenance items that should be
performed at the intervals specified in the “O