2015 TOYOTA RAV4 change time

6197-2. Steps to take in an emergency
RAV4_OM_OM42A78U_(U)
7
When trouble arises
After taking the specified steps to correct the suspected problem,
check that the warning light goes off.
Follow the correction procedures. (vehicles with a smart key
system)
InteriorbuzzerExterior
buzzer
Warning lightWarning light/DetailsCorrection procedure
Continuous Continuous(Flashes
in yellow) Smart key system indi-
cator light
The electronic key was
carried outside the
vehicle and the
driver’s door was
opened and closed
while any shift posi-
tion other than P was
selected without turn-
ing off the engine
switch. • Change the
shift position to
P.
• Bring the elec- tronic key back
into the vehicle.
Once3 times(Flashes
in yellow)
Smart key system indi-
cator light
The electronic key was
carried outside the
vehicle and the
driver’s door was
opened and closed
while the shift position
P was selected without
turning off the engine
switch.
Turn the engine
switch off or bring
the electronic key
back into the vehi-
cle.

6487-2. Steps to take in an emergency
RAV4_OM_OM42A78U_(U)
■Stopping the engine
Shift the shift lever to P and press the engine switch as you normally do when
stopping the engine.
■ Replacing the key battery
As the above procedure is a temporary measure, it is recommended that the
electronic key battery be replaced immediately when the battery is depleted.
(P. 570)
■ Changing engine switch modes
Release the brake pedal and press the engine switch in step above.
The engine does not start and modes will be changed each time the switch is
pressed.( P. 201)
■ When the electronic key does not work properly
●Make sure that the smart key system has not been deactivated in the cus-
tomization setting. If it is off, turn the function on.
(Customizable features: P. 687)
● Check if battery-saving mode is set. If it is set, cancel the function.
(P. 106)
3

RAV4_OM_OM42A78U_(U)
6918-2. Customization
8
Vehicle specifications
Automatic
light control
system
( P. 217)
Light sensor sensitivity*1Standard-2 to 2OO
Time elapsed before the
headlights automatically
turn off after the doors are
closed
30
seconds
Off
OO
60
seconds
90
seconds
Automatic High Beam*1OnOff—O
Lights
(  P. 217)Daytime running lights*4OnOffOO
Turn signal
lever
( P. 214)Time of flashing of the
lane change signal flash-
ers
3Off—O
Instrument
cluster
( P. 9 0 )Eco Driving Indicator
Light
*5
(Enable/disable the opera-
tion)OnOff—O
Multi-
information
display
( P. 8 7 )Switching the display
when the average fuel
consumption is displayedEngine
coolant
tempera-
ture gaugeEco Driving Indicator Zone
Display
—O
Automatic
air condition-
ing system
*1
(  P. 306)
A/C Auto switch operationOnOffOO
Switching between out-
side air and recirculated
air mode linked to “AUTO”
switch operation
OnOff—O
ItemFunctionDefault
settingCustom-
ized setting12