2015 TOYOTA HILUX engine

4827-2. Steps to take in an emergency
HILUX_OM_OM0K219E_(EE)
If your vehicle overheats
Stop the vehicle in a safe place and turn off the air conditioning sys-
tem, and then stop the engine.
If you see steam:
Carefully lift the hood after the steam subsides.
If you do not see steam:
Carefully lift the hood.
After the engine has cooled down sufficiently, inspect the hoses and
radiator core (radiator) for any leaks.Radiator
Cooling fan
If a large amount of coolant
leaks, immediately contact any
authorized Toyota dealer or
repairer, or another duly quali-
fied and equipped professional.
The following may indicate that your vehicle is overheating.● The needle of the engine coolant temperature gauge ( →P. 100)
enters the red zone or a loss of engine power is experienced.
(For example, the vehicle speed does not increase.)
● Steam comes out from under the hood.
Correction procedures
1
2
3
1
2
HILUX_OM_OM0K219E_(EE).book Page 482 Wednesday, May 14, 2014 3:06 PM

4837-2. Steps to take in an emergency
7
When trouble arises
HILUX_OM_OM0K219E_(EE)
The coolant level is satisfactory if it is between the upper and lower
lines on the reservoir.Reservoir
Upper line
Lower line
Radiator cap (if equipped)
Add engine coolant if necessary. ( →P. 508)
Water can be used in an emergency if engine coolant is unavailable.
4
1
2
3
4
XGasoline engineXDiesel engine
5
XGasoline engineXDiesel engine
HILUX_OM_OM0K219E_(EE).book Page 483 Wednesday, May 14, 2014 3:06 PM

4847-2. Steps to take in an emergency
HILUX_OM_OM0K219E_(EE)
Start the engine to check that the radiator cooling fan operates and
to check for coolant leaks from the radiator or hoses.
If the fan is not operating:
Stop the engine immediately and contact any authorized Toyota
dealer or repairer, or another duly qualified and equipped profes-
sional.
If the fan is operating:
Have the vehicle inspected at the nearest authorized Toyota dealer
or repairer, or another duly qualified and equipped professional.
CAUTION
■When inspecting under the hood of your vehicle
Observe the following precautions.
Failure to do so may result in serious injury such as burns.
● If steam is seen coming from under the hood, do not open the hood until
the steam has subsided. The engine compartment may be very hot.
● Keep hands and clothing (especially a tie, a scarf or a muffler) away from
the fans and belts. Failure to do so may cause the hands or clothing to be
caught, resulting in serious injury.
● Do not loosen the radiator cap or the coolant reservoir cap while the
engine and radiator are hot. High tem perature steam or coolant could
spray out.
NOTICE
■ When adding engine coolant
Add coolant slowly after the engine has cooled down sufficiently. Adding
cool coolant to a hot engine too quickly can cause damage to the engine.
■
To prevent damage to the cooling system
Observe the following precautions:
● Avoid contaminating the coolant with foreign matter (such as sand or dust
etc.).
● Do not use any coolant additive.
6
7
HILUX_OM_OM0K219E_(EE).book Page 484 Wednesday, May 14, 2014 3:06 PM

485
7
7-2. Steps to take in an emergency
When trouble arises
HILUX_OM_OM0K219E_(EE)
If you run out of fuel and the engine stalls
(diesel engine only)
If you run out of fuel and the engine stalls:Refuel your vehicle.
To bleed the fuel system, oper-
ate the priming pump until you
feel more resistance.
Start the engine. ( →P. 183)
If the engine does not start after the above steps have been performed,
wait for 10 seconds and try steps and again. If the engine still does
not start, contact any authorized Toyota dealer or repairer, or another duly
qualified and equipped professional.
After starting the engine, depress the accelerator pedal lightly until the
engine runs smoothly.
1
2
NOTICE
■When restarting the engine
● Do not crank the engine before refueling and operating the priming pump.
This may damage the engine and fuel system.
● Do not crank the engine for more than 30 seconds at a time. This may
overheat the starter and wiring system.
3
23
HILUX_OM_OM0K219E_(EE).book Page 485 Wednesday, May 14, 2014 3:06 PM

4867-2. Steps to take in an emergency
HILUX_OM_OM0K219E_(EE)
If the vehicle becomes stuck
Stop the engine. Set the parking brake and shift the shift lever to P
(automatic transmission) or N (manual transmission).
Remove the mud, snow or sand from around the stuck tire.
Place wood, stones or some other material under the tires to help
provide traction.
Restart the engine.
Vehicles with rear differential lock system: Lock the rear differential.
(→ P. 230)
Shift the shift lever to the D or R position (automatic transmission)
or 1 or R position (manual transmission) and carefully apply the
accelerator to free the vehicle.
For vehicles with VSC system, turn off TRC and VSC if these functions are
hampering your attempts to free the vehicle. ( →P. 234)
Carry out the following procedures if the tires spin or the vehicle
becomes stuck in mud, dirt or snow:
1
2
3
4
5
6
HILUX_OM_OM0K219E_(EE).book Page 486 Wednesday, May 14, 2014 3:06 PM

4928-1. Specifications
HILUX_OM_OM0K219E_(EE)
XDouble-cab models
Gross
vehicle
mass4WD
models
1KD-FTV
engine
Left-hand
drive
vehicles2730 kg (6019 lb.)
Right-hand
drive
vehicles3080 kg (6790 lb.)
2KD-FTV
engine
Left-hand
drive
vehicles2705 kg (5964 lb.)*1
2690 kg (5930 lb.)*2
Right-hand
drive
vehicles
3040 kg (6702 lb.)
Pre Runner 2600 kg (5732 lb.)
Maximum
permissible
axle
capacity
1KD-FTV
engine
Left-hand
drive
vehiclesFront 1340 kg (2954 lb.)
Rear 1600 kg (3527 lb.)
Right-hand
drive
vehiclesFront 1340 kg (2954 lb.)
Rear 1900 kg (4189 lb.)
2KD-FTV
engine
Left-hand
drive
vehiclesFront 1280 kg (2822 lb.)
Rear 1600 kg (3527 lb.)
Right-hand
drive
vehiclesFront 1280 kg (2822 lb.)
Rear 1900 kg (4189 lb.)
Drawbar load
80 kg (176 lb.)*1
115 kg (254 lb.)*2
To w i n g
capacity
Without brake 750 kg (1653 lb.)
With brake1500 kg (3307 lb.)
*1
2790 kg (6151 lb.)*3
2800 kg (6173 lb.)*4
HILUX_OM_OM0K219E_(EE).book Page 492 Wednesday, May 14, 2014
3:06 PM

495
8
8-1. Specifications
Vehicle specifications
HILUX_OM_OM0K219E_(EE)
Models made in Thailand*:
This number is also on the
manufacturer’s plate.
*: See “Checking your vehicle’s model” if you are not sure of which model your vehicle is. ( →P. 12)
■
Engine number
The engine number is stamped on the engine block as shown.
XGasoline engineXDiesel engine
HILUX_OM_OM0K219E_(EE).book Page 495 Wednesday, May 14, 2014 3:06 PM

4968-1. Specifications
HILUX_OM_OM0K219E_(EE)
X2TR-FE engine
X1KD-FTV engine
X2KD-FTV engine
Engine
Model2TR-FE
Ty p e4 cylinder in line, 4 cycle, gasoline
Bore and stroke95.0 × 95.0 mm (3.74 × 3.74 in.)
Displacement2694 cm3 (164.4 cu.in.)
Valve clearance
(engine cold)Automatic adjustment
Drive belt tensionAutomatic adjustment
Model1KD-FTV
Ty p e4 cylinder in line, 4 cycle, diesel
(with turbocharger)
Bore and stroke96.0 × 103.0 mm (3.78 × 4.06 in.)
Displacement2982 cm3 (182.0 cu.in.)
Valve clearance
(engine cold)Intake: 0.20  0.30 mm (0.008  0.012 in.)
Exhaust: 0.35  0.45 mm (0.014  0.018 in.)
Drive belt tensionAutomatic adjustment
Model2KD-FTV
Ty p e4 cylinder in line, 4 cycle, diesel
(with turbocharger)
Bore and stroke92.0 × 93.8 mm (3.62 × 3.69 in.)
Displacement2494 cm3 (152.2 cu.in.)
Valve clearance
(engine cold)Intake: 0.20  0.30 mm (0.008  0.012 in.)
Exhaust: 0.35  0.45 mm (0.014  0.018 in.)
Drive belt tensionAutomatic adjustment
HILUX_OM_OM0K219E_(EE).book Page 496 Wednesday, May 14, 2014 3:06 PM