Page 455 of 540
4557-2. Steps to take in an emergency
7
When trouble arises
HILUX_OM_OM0K219E_(EE)
CAUTION
■If both the ABS and the brake system warning lights remain on (vehi-
cles with VSC system)
Stop your vehicle in a safe place immediately and contact any authorized
Toyota dealer or repairer, or another duly qualified and equipped profes-
sional. The vehicle will become extremely unstable during braking, and the
ABS system may fail, which could cause an accident resulting in death or
serious injury.
NOTICE
■If the malfunction indicator lamp comes on when the boost pressure in
the turbocharger is abnormally high (diesel engine)
Never drive at high speed or race the engine even after the lamp goes off.
■
If the fuel system warning light flashes (diesel engine)
Never drive the vehicle with the warn ing light flashing. Continued driving
with water accumulated in the fuel filter will damage the fuel injection pump.
HILUX_OM_OM0K219E_(EE).book Page 455 Wednesday, May 14, 2014 3:06 PM
Page 456 of 540
4567-2. Steps to take in an emergency
HILUX_OM_OM0K219E_(EE)
If you have a flat tire
●Stop the vehicle on a hard, flat surface.
● Set the parking brake.
● Shift the shift lever to P (automatic transmission) or R (manual
transmission).
● Stop the engine.
● Turn on the emergency flashers. ( →P. 438)
Your vehicle is equipped with a spare tire. The flat tire can be
replaced with the spare tire.
For details about tires: →P. 3 9 7
CAUTION
■If you have a flat tire
Do not continue driving with a flat tire.
Driving even a short distance with a flat tire can damage the tire and the
wheel beyond repair, which could result in an accident.
Before jacking up the vehicle
Location of the spare tire
HILUX_OM_OM0K219E_(EE).book Page 456 Wednesday, May 14, 2014 3:06 PM
Page 459 of 540

4597-2. Steps to take in an emergency
7
When trouble arises
HILUX_OM_OM0K219E_(EE)
CAUTION
■Using the tire jack
Improper use of the tire jack may cause the vehicle to suddenly fall off the
jack, leading to death or serious injury.
● Do not use the tire jack for any purpose other than replacing tires or install-
ing and removing tire chains.
● Only use the tire jack that comes with this vehicle for replacing a flat tire.
Do not use it on other vehicles, and do not use other tire jacks for replac-
ing tires on this vehicle.
● Always check that the tire jack is securely set to the correct jack up point.
● Do not put any part of your body under the vehicle while it is supported by
the jack.
● Do not start or run the engine while your vehicle is supported by the jack.
● Do not raise the vehicle while someone is inside.
● When raising the vehicle, do not put an object on or under the jack.
● Do not raise the vehicle to a height greater than that required to replace
the tire.
● Use a jack stand if it is necessary to get under the vehicle.
Take particular care when lowering the vehicle to ensure that no one work-
ing on or near the vehicle may be injured.
■
Using the jack handle
Tighten all the jack handle bolts securely using a Phillips-head screwdriver
or your hand, to prevent the extens ion parts from coming apart unexpect-
edly.
● Do not continue jacking up once the yel-
low caution line has appeared.Ye l l o w
caution line
HILUX_OM_OM0K219E_(EE).book Page 459 Wednesday, May 14, 2014 3:06 PM
Page 476 of 540

4767-2. Steps to take in an emergency
HILUX_OM_OM0K219E_(EE)
If the engine will not star t
One of the following may be the cause of the problem:
●There may not be sufficient fuel in the vehicle’s tank.
Gasoline engine: Refuel the vehicle.
Diesel engine: →P. 4 8 5
● The engine may be flooded. (gasoline engine)
Try to restart the engine again following correct starting procedures.
(→ P. 183)
● There may be a malfunction in the engine immobilizer system.
(→ P. 8 5 )
One of the following may be the cause of the problem:
● The battery may be discharged. ( →P. 478)
● The battery terminal connections may be loose or corroded.
One of the following may be the cause of the problem:
● One or both of the battery terminals may be disconnected.
● The battery may be discharged. ( →P. 478)
Contact any authorized Toyota dealer or repairer, or another duly qualified
and equipped professional if the problem cannot be repaired, or if repair
procedures are unknown.
If the engine will not start even though correct starting proce-
dures are being followed (
→P. 183), consider each of the follow-
ing points:
The engine will not start even though the starter motor operates
normally.
The starter motor turns over slowly, the interior lights and head-
lights are dim, or the horn does not sound or sounds at a low
volume.
The starter motor does not turn over, the interior lights and head-
lights do not turn on, or the horn does not sound.
HILUX_OM_OM0K219E_(EE).book Page 476 Wednesday, May 14, 2014 3:06 PM
Page 477 of 540
477
7
7-2. Steps to take in an emergency
When trouble arises
HILUX_OM_OM0K219E_(EE)
If the shift lever cannot be shifted from P∗
Set the parking brake.
Turn the engine switch to the “ACC” position.
Depress the brake pedal.
Press the shift lock override
button.
The shift lever can be shifted while
the button is pressed.
∗: If equipped
If the shift lever cannot be shifted with your foot on the brake
pedal, there may be a problem with the shift lock system (a sys-
tem to prevent accidental operation of the shift lever). Have the
vehicle inspected by any authorized Toyota dealer or repairer, or
another duly qualified and equipped professional immediately.
The following steps may be used as an emergency measure to
ensure that the shift lever can be shifted:
1
2
3
4
HILUX_OM_OM0K219E_(EE).book Page 477 Wednesday, May 14, 2014 3:06 PM
Page 478 of 540

4787-2. Steps to take in an emergency
HILUX_OM_OM0K219E_(EE)
If the vehicle batter y is discharged
If you have a set of jumper (or booster) cables and a second vehicle
with a 12-volt battery, you can jump start your vehicle by following the
steps below.Open the hood. ( →P. 378)
Connect the jumper cables according to the following procedure: Connect a positive jumper cable clamp to the positive (+) battery
terminal on your vehicle.
Connect the clamp on the other end of the positive cable to the
positive (+) battery terminal on the second vehicle.
Connect a negative cable clamp to the negative (-) battery termi-
nal on the second vehicle.
Connect the clamp at the other end of the negative cable to a
solid, stationary, unpainted metallic point away from the battery
and any moving parts, as shown in the illustration.
X2TR-FE engine
The following procedures may be used to start the engine if the
vehicle’s battery is discharged.
You can also call any authorized Toyota dealer or repairer, or
another duly qualified and equipped professional or a qualified
repair shop.
1
2
1
2
3
4
HILUX_OM_OM0K219E_(EE).book Page 478 Wednesday, May 14, 2014 3:06 PM
Page 479 of 540