2015 SUZUKI NEXA window
[x] Cancel search: windowPage 37 of 288
Downloaded from www.Manualslib.com manuals search engine
% ( ) 2 5 ( ' 5 , 9 , 1 *
0 6 (
then push the unlock end (6) (backward
end). Repeat this operation 3 times.
Every time you perform the series of the
above steps, the state of the security sys-
tem changes from the currently selected
one to the other. You can check whether
the system is enabled or disabled by the
number of interior buzzer beeps at the end
of the procedure as follows.
• If you cannot complete the operations in
step 3) and 4) within 15 seconds cor-
rectly, the state of the security system
will not change and the interior buzzer
does not beep. Perform the procedure
again from the beginning.
NOTE:
You can also switch the security system
from the enabled state to the disabled
state, and vice versa, via the setting mode
of the information display. For details on
how to use the information display, refer to
“Information Display” in this section.
: L Q G R Z V ( O H F W U L F : L Q G R Z & R Q W U R O VThe electric windows can only be operated
when the ignition switch is in the “ON”
position or the ignition mode is ON.
' U L Y H U
Page 38 of 288
Downloaded from www.Manualslib.com manuals search engine % ( ) 2 5 ( ' 5 , 9 , 1 *
0 6 (
The driver’s window has auto-down and
auto-up features for added convenience
(at toll booths or drive-through restaurants,
for example). This means the driver can
open or close the window without holding
the window switch in the down or up posi-
tion. Press down or lift up the driver’s win-
dow switch completely and release it. To
stop the window before it reaches the full-
down or full-up position, pull up or push
down the switch briefly.
/ R F N V Z L W F K
64MS027
The driver’s door also has a lock switch for
the passenger’s window(s). When you
push in the lock switch, the passenger’s
window(s) cannot be raised or lowered by
operating any of the switches (2), (3), (4)
or (5). To restore normal operation, release
the lock switch by pushing again.NOTE:
If you drive with one of the rear windows
open, you may hear a loud sound caused
by air vibration. To reduce the sound, open
the driver’s or front passenger’s window, or
narrow the rear window opening.
3 L Q F K L Q J 3 U H Y H Q W L R Q ) X Q F W L R QThe driver’s window is equipped with the
pinching prevention function. The function
detects a foreign object caught in the win-
dow while being closed by the “auto-up”
feature, which you can close the window
without holding the window switch in the
“UP” position, and stops the window clos-
ing to prevent damage.
( ; $ 0 3 / (
: $ 5 1 , 1 *
Page 39 of 288
Downloaded from www.Manualslib.com manuals search engine
% ( ) 2 5 ( ' 5 , 9 , 1 *
0 6 (
NOTE:
Even if you cannot close the window by the
auto-up feature because there may be
something wrong with the pinching preven-
tion function, you can close the window by
holding the window switch in the up posi-
tion.If you drive in extreme off-road condition,
the pinching prevention function may oper-
ate accidentally because the window react
to vehicle jolting. 7 K H 3 L Q F K L Q J 3 U H Y H Q W L R Q ) X Q F W L R Q , Q L
W L D O L ] D W L R QWhen you disconnect and re-connect the
battery or replace the fuse, the function will
be deactivated. In this condition, the auto-
down feature will be deactivated, while the
auto-up feature may remain being activated.
The pinching prevention function needs to
be initialized.To initialize the pinching prevention func-
tion, use the following procedure:
1) Turn the ignition switch to the “ON”
position or press the engine switch to
change the ignition mode to “ON”.
2) Open the driver’s window fully by hold-
ing the window switch in the “DOWN”
position.3) Close the driver’s window by holding the
switch in the “UP” position, and keep
holding the switch for 2 seconds after the
window fully closed.4) Check the driver’s window if the auto-
down/up feature work.If the auto-down/up feature would not work
after initialization, there might be some-
thing wrong with the pinching prevention
function. Have your vehicle inspected by
an D X W K R U L V H G 0 D U X W L 6 X ] X N L Z R U N V K R S.
0 L U U R U V , Q V L G H 5 H D U Y L H Z 0 L U U R U
68LMT0205
68LMT0206
(2) Day driving
(3) Night driving
You can adjust the inside rearview mirror
by hand so as to see the rear of your vehi-
cle in the mirror. To adjust the mirror, set
the selector tab (1) to the day position,
then move the mirror up, down or sideways
by hand to obtain the best view.
: $ 5 1 , 1 *
: K H Q H Y H U \ R X G L V F R Q Q H F W D Q G U H F R Q
Q H F W W K H E D W W H U \ R U U H S O D F H W K H I X V H
W K H S L Q F K L Q J S U H Y H Q W L R Q I X Q F W L R Q
Q H H G V W R E H L Q L W L D O L ] H G
7 K H S L Q F K L Q J S U H Y H Q W L R Q I X Q F W L R Q Z L O O
Q R W E H D F W L Y D W H G X Q W L O W K H L Q L W L D O L ] D W L R Q
F R P S O H W H
(1)
(2)(3)
Page 55 of 288
Downloaded from www.Manualslib.com manuals search engine
% ( ) 2 5 ( ' 5 , 9 , 1 *
0 6 (
& K L O G 5 H V W U D L Q W 6 \ V W H P I R U , Q G L D & K L O G 5 H V W U D L Q WThe suitability of each passenger’s seat position for carriage of children and fitting of child restraint system is shown in the table below.
Whenever you carry children up to 12 years of age, properly use the child restraints which conform to AIS 072, the standard for child
restraints, referring to the table.
MASS GROUPSeating position (or other site)
Front
PassengerRear
OutboardRear
CentreIntermediate
OutboardIntermediate
Centre
Group 0
Up to 10 kgXUXN.A.N.A.
Group 0+
Up to 13 kgXUXN.A.N.A.
Group I
9 to 18 kgXUXN.A.N.A.
Group II
15 to 25 kgXUXN.A.N.A.
Group III
22 to 36 kgXUXN.A.N.A.
Key of letters to be inserted in the above table:
U =Suitable for ‘universal’ category restraints approved for use in this mass group
X =Seat position not suitable for children in this mass group
N.A = Seat position not available for children in this mass group.
NOTE: ‘universal’ is the category in the AIS 072.
: ‘Outboard’ indicates window side seat.
Page 97 of 288
Downloaded from www.Manualslib.com manuals search engine
% ( ) 2 5 ( ' 5 , 9 , 1 *
0 6 (
5 H D U : L Q G R Z : L S H U : D V K H U 6 Z L W F K
L I H T X L S S H G
64MS068
To turn the rear wiper on, twist the rear
wiper switch on the end of the lever forward
to the “ON” position. If your vehicle is
equipped the “INT” position, the rear wiper
operates intermittently when you twist the
switch forward to the “INT” position. To turn
the rear wiper off, twist the switch rearward
to the “OFF” position.With the rear wiper in the “OFF” position,
twist the switch rearward and hold it there
to spray window washer fluid.
With the rear wiper in the “ON” position,
turn the switch forward and hold it there to
spray window washer fluid.
7 L O W 7 H O H V F R S L Q J L I H T X L S S H G 6 W H H U
L Q J / R F N / H Y H U
61MM0A085
(1) LOCK
(2) UNLOCK
The lock lever is located under the steering
column. To adjust the steering wheel
height and fore-aft position:
1) Push down the lock lever to unlock the
steering column.
2) Adjust the steering wheel to the desired
height and fore-aft position and lock the
steering column by pulling up the lock
lever.
3) Try moving the steering wheel up and
down and back and forth to make sure
it is securely locked in position.
( ; $ 0 3 / (
Intermittent wiper WasherWiper
NOTICE
& O H D U L F H R U V Q R Z I U R P W K H U H D U Z L Q
G R Z D Q G U H D U Z L S H U E O D G H E H I R U H
X V L Q J W K H U H D U Z L S H U $ F F X P X O D W H G
L F H R U V Q R Z F R X O G S U H Y H Q W W K H Z L S H U
E O D G H I U R P P R Y L Q J F D X V L Q J G D P D J H
W R W K H Z L S H U P R W R U
: $ 5 1 , 1 *
1 H Y H U D W W H P S W W R D G M X V W W K H V W H H U L Q J
Z K H H O Z K L O H W K H Y H K L F O H L V P R Y L Q J R U
\ R X F R X O G O R V H F R Q W U R O R I W K H Y H K L F O H
(2) ( ; $ 0 3 / (
( )
Page 98 of 288
Downloaded from www.Manualslib.com manuals search engine % ( ) 2 5 ( ' 5 , 9 , 1 *
0 6 (
+ R U Q
68LM240
Press the horn button of the steering wheel
to sound the horn. The horn will sound with
the ignition switch in any position or any
ignition mode.
+ H D W H G 5 H D U : L Q G R Z 6 Z L W F K L I
H T X L S S H G 7 \ S H
64MS167
7 \ S H
64MS168
When the rear window is misted, push this
switch (1) to clear the mist from the win-
dow.An indicator light will be lit when the defog-
ger is on. The defogger will work only
when the engine is running. To turn off the
defogger, push the switch (1) again.
NOTE:
• The defogger will work only when the
engine is running.
• The defogger will automatically turn off
after the defogger remains on for 15 min-
utes to prevent discharging of the bat-
tery.
REAR
12
3
04A/C
( ; $ 0 3 / (
(1)
( ; $ 0 3 / ( ( ; $ 0 3 / (
NOTICE
7 K H K H D W H G U H D U Z L Q G R Z X V H V D O D U J H
D P R X Q W R I H O H F W U L F L W \ % H V X U H W R W X U Q
R I I D I W H U W K H Z L Q G R Z D Q G P L U U R U V K D Y H
E H F R P H F O H D U
(1)
Page 100 of 288
Downloaded from www.Manualslib.com manuals search engine 2 3 ( 5 $ 7 , 1 * < 2 8 5 9 ( + , & / (
0 6 (
( [ K D X V W * D V : D U Q L Q J
52D334
' D L O \ , Q V S H F W L R Q & K H F N O L V W % H I R U H ' U L Y L Q J
60A187
1) Make sure that windows, mirrors, lights
and reflectors are clean and unob-
structed.
2) Visually check the tires for the following
points:
– the depth of the tread groove
– abnormal wear, cracks and damage
– loose wheel nuts
– existence of foreign material such as
nails, stones, etc.
Refer to “Tires” in
Page 136 of 288
Downloaded from www.Manualslib.com manuals search engine ' 5 , 9 , 1 * 7 , 3 6
0 6 (
2) Don’t use hand-braking unless una-
voidable. It causes the vehicle to skid
and a rearend collision occur. It is espe-
cially dangerous when the tyres are
worn, for they allow a larger skid.
72F-08-012
Use foot brake in three stages
1.Warn the vehicle behind you
2.Gradually apply the brake.
3.Bring the vehicle to a halt.
3) When driving on a downhill, try not to
apply the brake but use the engine
brake effectively. Overuse of the foot
brake may result in total brake failure.
4) Avoid reckless high speed driving and
try to drive at a safe speed suitable for
the road conditions while maintaining a
constant speed.
72F-08-015
5) The higher the speed, the narrower the
driver’s visual range becomes. In such
a state, it is difficult to anticipate any
hazard and the driver feels much
fatigued.
6) Never do sharp handling during high
speed driving. You will lose your control
over your vehicle.
7) When overtaking or changing the lane
while driving at a high speed, keep an
ample vehicle-to-vehicle distance. / R Q J G L V W D Q F H G U L Y L Q J
1) Be sure to perform safety checks before
starting a trip.
2) Take rest at certain intervals to prevent
an accident which may occur when you
are sleepy or tired.
72F-08-020
1 L J K W W L P H G U L Y L Q J
1) Drive more slowly at night than in the
daytime, for the visual range is
restricted at night.
2) Don’t overtake other vehicles at night.
Darkness bothers your sense of speed
and hinders your judgment on the vehi-
cle-to-vehicle distance.
3) Don’t use the high headlight beam
unless its use is inevitable. Its dazzle
may blitz the driver of the oncoming
vehicle, thus causing an accident.
4) Always keep the window glasses clean.
Don’t operate the windshield wiper