Page 236 of 288
Downloaded from www.Manualslib.com manuals search engine , 1 6 3 ( & 7 , 2 1 $ 1 ' 0 $ , 1 7 ( 1 $ 1 & (
0 6 (
& O X W F K 3 H G D O ) O X L G & R Q W U R O & O X W F K
64MS141
Check the clutch pedal for smooth opera-
tion and clutch fluid level from time to time.
If clutch dragging is felt with the pedal fully
depressed, have the clutch inspected by
D X W K R U L V H G 0 D U X W L 6 X ] X N L Z R U N V K R S. If the
clutch fluid level is near the “MIN” triangle
mark, fill it up to the “MAX” triangle mark
with MARUTI genuine brake fluid.
) X H O ) L O W H U
64MS175
The fuel filter works as a water sedimentor
as well.
Drain water according to the Periodic
Maintenance Schedule. To drain water:
1) Place a pan or ample rag under the fuel
filter drain nozzle.
2) Loosen the drain screw (1). The water
will be drained.
3) Tighten the drain screw when the water
changes to the diesel fuel.
7 L J K W H Q L Q J W R U T X H I R U G U D L Q V F U H Z
1 P N J P O E I W
% U D N H V % U D N H ) O X L G
64MS141
Check the brake fluid level by looking at
the reservoir in the engine compartment.
Check that the fluid level is between the
“MAX” and “MIN” triangle mark. If the
brake fluid level is near the “MIN” triangle
mark, fill it up to the “MAX” triangle mark
with MARUTI GENUINE BRAKE FLUID.
MAX
MIN
(1)
( ; $ 0 3 / (
MAX
MIN
Page 244 of 288
Downloaded from www.Manualslib.com manuals search engine , 1 6 3 ( & 7 , 2 1 $ 1 ' 0 $ , 1 7 ( 1 $ 1 & (
0 6 (
) X V H V L Q W K H ( Q J L Q H & R P S D U W P H Q W
61MM0B068
64MS177
The main fuse, primary fuses and some of the
individual fuses are located in the engine
compartment. If the main fuse blows, no elec-
trical component will function. If a primary fuse
blows, no electrical component in the corre-
sponding load group will function. When
replacing the main fuse, a primary fuse or an
individual fuse, use a 0 D U X W L * H Q X L Q H 3 D U W To
remove a fuse, use the fuse puller provided in
the fuse box. The amperage of each fuse is
shown in the back of the fuse box cover.
(6)
(7) (1)
(2)
(3)
(4)
(5)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
(15)
(16)
(17)(18)
(19)
(20)
(21)
(22)
(23)(24)
(25)
(26)
(27)
(28)(29)
(30)
(31)
(32)
(33)
(34)
(35)
0 $ , 1 ) 8 6 ( 3 5 , 0 $ 5 < ) 8 6 (
(1) 60 A FL7
(2) 80 A FL6
(3)
100 A
FL5
(4)
80 A
FL4
(5)
100 A
FL3
(6)
100 A
FL2
(7)
120 A
FL1
(8) 7.5 AIgnition-1 signal 2 (D16AA)
(9) 30 A Radiator fan 2
(10) 20 A Front fog light
(11) 7.5 A Headlight 2
(12) 25 A ABS control module
(13) 25 A Headlight
(14) 30 A Back up
(15) 40 A Ignition switch
(16) 40 A ABS motor
(17) 30 A Starting motor
(18) 30 A Radiator fan
(19) 30 A FI main
(20) 20 A Fuel pump
(21) 10 A Air compressor
(22) 7.5 A ECM (D13A)
(23) 30 A Blower fan
(24) 10 A FI 2 (D13A)
(25) 20 A INJ DRV (D13A)
(26) 7.5 A Starting signal
(27) 15 A Headlight (Left)
(28) 15 A Headlight high (Left)
(29) 7.5 A FI 2 (D16AA)
(30) 20 A INJ DRV (D16AA)
(31) 15 A FI 3 (D16AA)
(32) 15 A Headlight (Right)
(33) 15 A Headlight high (Right)
(34) 50 A Ignition switch 2
(35) 50 A Battery
Page 270 of 288
Downloaded from www.Manualslib.com manuals search engine ( 0 ( 5 * ( 1 & < 6 ( 5 9 , & (
0 6 (
, I W K H 6 W D U W H U ' R H V 1 R W 2 S H U D W H1) Try turning the ignition switch to the
“START” position or try pressing the
engine switch to change the ignition
mode to START with the headlights
turned on to determine the battery condi-
tion. If the headlights go excessively dim
or go off, it usually means that either the
battery is flat or the battery terminal con-
tact is poor. Recharge the battery or cor-
rect battery terminal contact as
necessary.
, I W K H ( Q J L Q H L V ) O R R G H GIf the engine is flooded with the fuel, it may
be hard to start. If this happens, press the
accelerator pedal all the way to the floor
and hold it there while cranking the engine.
• For petrol engine model, do not operate
the starter motor for more than 12 sec-
onds.
• For diesel engine model, do not operate
the starter motor for more than 30 sec-
onds.
, I W K H ( Q J L Q H 2 Y H U K H D W VThe engine could overheat temporarily
under severe driving conditions. If the high
engine coolant temperature warning light
comes on as overheating during driving:
1) Turn off the air conditioner, if equipped.
2) Take the vehicle to a safe place and
park.
3) Let the engine run at the normal idle
speed for a few minutes until the high
engine coolant temperature warning
light goes off.
: $ 5 1 , 1 *
, I \ R X V H H R U K H D U H V F D S L Q J V W H D P
V W R S W K H Y H K L F O H L Q D V D I H S O D F H D Q G
L P P H G L D W H O \ W X U Q R I I W K H H Q J L Q H W R O H W
L W F R R O ' R Q R W R S H Q W K H K R R G Z K H Q
V W H D P L V S U H V H Q W : K H Q W K H V W H D P
F D Q Q R O R Q J H U E H V H H Q R U K H D U G R S H Q
W K H K R R G W R V H H L I W K H F R R O D Q W L V V W L O O
E R L O L Q J , I L W L V \ R X P X V W Z D L W X Q W L O L W
V W R S V E R L O L Q J E H I R U H \ R X S U R F H H G
Page 286 of 288
Downloaded from www.Manualslib.com manuals search engine 6 3 ( & , ) , & $ 7 , 2 1 6
0 6 (
*1 When tire replacement is necessary and if the specified load index and speed rated tire is not available, then use a tire of higher load
index and speed rating.
*2: The spare wheel provided with alloy wheel variant is steel wheel rim, hence follow 4 tire rotation only.
(Refer: Section
“Inspection and maintenance”)
, 7 ( 0 : K H H O V D Q G 7 L U H V
Tire size, front and rear
205/60R16 92H
*1*2
Tire size, spare
205/60R16 92H
*2 (Steel wheel)
Rim size 205/60R16 tire: 16X6J
Tire pressures For the specified tire pressure, see the Tire Information Label located
on the driver’s door lock pillar.
, 7 ( 0 5 H F R P P H Q G H G ) X H O / X E U L F D Q W V D Q G & D S D F L W L H V D S S U R [
Fuel 48 L
Engine oil D13A 3.2 L (replacement with oil filter)
D16AA 5.25 L (replacement with oil filter)
Engine coolant D13A 6.0 L (including reservoir tank)
D16AA 5.5 L (including reservoir tank)
Manual transaxle oil 5M/T 2.6 L
6M/T 2.1 L
Brake fluid / Clutch fluid Refill to the proper oil level according to the instructions in the “INSPEC-
TION AND MAINTENANCE” section.