Page 234 of 288
Downloaded from www.Manualslib.com manuals search engine , 1 6 3 ( & 7 , 2 1 $ 1 ' 0 $ , 1 7 ( 1 $ 1 & (
0 6 (
If the coolant level is below the “LOW”
mark, more coolant should be added.
When the engine is cool, remove the
degassing tank cap by turning it anticlock-
wise slowly to release any pressure. And
add coolant until the degassing tank level
reaches the “FULL” mark. Never fill the
degassing tank above the “FULL” mark. & R R O D Q W 5 H S O D F H P H Q WSince special procedures are required, we
recommend you take your vehicle to your
D X W K R U L V H G 0 D U X W L 6 X ] X N L Z R U N V K R S for
coolant replacement.
$ L U & O H D Q H UIf the air cleaner is clogged with dust, there
will be greater intake resistance, resulting
in decreased power output and increased
fuel consumption.
61MM0A126
Unclamp the side clamps and remove the
element from the air cleaner case. If it
appears to be dirty, replace it with a new
one.
Clamp the side clamps securely.
* H D U 2 L O 0 D Q X D O 7 U D Q V D [ O H 2 L OWhen adding gear oil, use gear oil with the
appropriate viscosity and grade as shown
in the chart below.
We highly recommend you use:
“MARUTI * ( 1 8 , 1 ( GEAR OIL : ”
for manual transaxle gear oil.
0 D Q X D O W U D Q V D [ O H R L O
68LM728
* H D U 2 L O / H Y H O & K H F N V S H H G P D Q X D O W U D Q V D [ O H
52LM021
: $ 5 1 , 1 *
, W L V K D ] D U G R X V W R U H P R Y H W K H U H V H U
Y R L U W D Q N F D S G H J D V V L Q J W D Q N F D S I R U
D G L H V H O H Q J L Q H Z K H Q W K H Z D W H U W H P
S H U D W X U H L V K L J K E H F D X V H V F D O G L Q J
I O X L G D Q G V W H D P P D \ E H E O R Z Q R X W
X Q G H U S U H V V X U H : D L W X Q W L O W K H F R R O D Q W
W H P S H U D W X U H K D V O R Z H U H G E H I R U H
U H P R Y L Q J W K H F D S
( ; $ 0 3 / (
C
Fo o-30
-22-20
-4-10
14 32 50 68 86 104010203040
75W-80
(1) ( ; $ 0 3 / (
Page 249 of 288
Downloaded from www.Manualslib.com manuals search engine
, 1 6 3 ( & 7 , 2 1 $ 1 ' 0 $ , 1 7 ( 1 $ 1 & (
0 6 (
6 L G H 7 X U Q 6 L J Q D O / L J K W L I H T X L S S H G
76MH0A006
1) Remove the light housing (1) by sliding
to left with your finger.
76MH0A007
2) Turn the bulb holder (2) clockwise and
pull it out from the light housing.
76MH0A008
(4) Removal
(5) Install
3) To remove and install the bulb of the
turn signal light (3), simply pull out or
push in the bulb.
) U R Q W 7 X U Q 6 L J Q D O / L J K W
) U R Q W 3 R V L W L R Q / L J K W (Vehicle with the halogen headlights)
61MM0A030
(1)
(2)
(3)
(4)
(5)
(2)
(1)
Page 250 of 288
Downloaded from www.Manualslib.com manuals search engine , 1 6 3 ( & 7 , 2 1 $ 1 ' 0 $ , 1 7 ( 1 $ 1 & (
0 6 (
61MM0B077
1) Open the engine hood. To remove the
bulb holder of the front turn signal light
(1) or the front position light (2) from the
light housing, turn the holder counter-
clockwise and pull it out.
61MM0B078
(3) Removal
(4) Install
2) To remove the bulb of the front turn sig-
nal light (1) from the bulb holder, push in
the bulb and turn it counterclockwise. To
install a new bulb, push it in and turn it
clockwise.
To remove and install the bulb of the
front position light (2), simply pull out or
push in the bulb.
9 H K L F O H Z L W K W K H G L V F K D U J H K H D G O L J K W V
61MM0A091
To replace the bulb of the front turn signal
light (1), follow the procedure for the front
turn signal light bulb replacement of the
vehicle with the halogen headlights.NOTE:
Position function in discharge headlamp is
LED type, which is non replaceable.
(2)(1)
(2)
(1) (3)
(4)
( ; $ 0 3 / (
(1)
Page 251 of 288
Downloaded from www.Manualslib.com manuals search engine
, 1 6 3 ( & 7 , 2 1 $ 1 ' 0 $ , 1 7 ( 1 $ 1 & (
0 6 (
) U R Q W ) R J / L J K W L I H T X L S S H G 1) Start the engine. Turn the steering wheel
to rotate the tires to the opposite side of
the fog light that requires replacement.
Then turn off the engine.
61MM0B079
2) Remove the screws (1).
61MM0B080
3) Remove the clips (2) by prying it off with
a flat blade screwdriver as shown in the
illustration.
61MM0B081
4) Open the end of the cover inside the
fender.
80JM071
5) Disconnect the coupler by pushing the
lock release. Turn the bulb holder coun-
terclockwise and remove it.
(1)
( ; $ 0 3 / (
(2)
( ; $ 0 3 / ( ( ; $ 0 3 / (
( ; $ 0 3 / (
Page 252 of 288
Downloaded from www.Manualslib.com manuals search engine , 1 6 3 ( & 7 , 2 1 $ 1 ' 0 $ , 1 7 ( 1 $ 1 & (
0 6 (
5 H D U & R P E L Q D W L R Q / L J K W
61MM0B082
1) Remove the bolts (1) and pull the light
housing (2) straight.
61MM0B083
2) To remove the bulb holder of the rear
turn signal light (3) or the tail/brake light
(4) from the light housing, turn the
holder counterclockwise and pull it out.
61MM0B084
(5) Removal
(6) Install3) To remove the bulb of the rear turn sig-
nal light (3) or the tail/brake light (4) from
bulb holder, push in the bulb and turn it
counterclockwise. To install a new bulb,
push it in and turn it clockwise.
(2)(1)
(3)(4)
(3) / (4)
(5)
(6)
( ; $ 0 3 / (
Page 253 of 288
Downloaded from www.Manualslib.com manuals search engine
, 1 6 3 ( & 7 , 2 1 $ 1 ' 0 $ , 1 7 ( 1 $ 1 & (
0 6 (
61MM0B085
NOTE:
When reinstalling the light housing, make
sure the clips are properly attached.
5 H Y H U V L Q J / L J K W
61MM0B088
1) Open the tailgate. Remove the clips (1)
by prying it off with a flat blade screw-
driver as shown in the illustration. Then,
pull out the trim (2).
61MM0B089
2) Disconnect the coupler (3) by pushing
the lock release. Turn the bulb holder ofthe reversing light (4) counterclockwise
and remove it.
61MM0B090
(5) Removal
(6) Install3) To remove and install the bulb of the
reversing light (4), simply pull out or
push in the bulb.
(2)
(1)
(3)
(4)
(4)
(5)
(6)
( ; $ 0 3 / (
Page 254 of 288
Downloaded from www.Manualslib.com manuals search engine , 1 6 3 ( & 7 , 2 1 $ 1 ' 0 $ , 1 7 ( 1 $ 1 & (
0 6 (
/ L F H Q V H 3 O D W H / L J K W
61MM0B086
1) Turn the cover (1) counterclockwise to
remove it.
61MM0B087
2) To remove and install the bulb of the
license plate light (2), simply pull out or
push in the bulb.
+ L J K P R X Q W 6 W R S / L J K W
80J100
1) Open the tailgate, and remove the nuts
(1) as shown in the illustration.
(1)
(2)
(1)
( ; $ 0 3 / (
Page 264 of 288
Downloaded from www.Manualslib.com manuals search engine ( 0 ( 5 * ( 1 & < 6 ( 5 9 , & (
0 6 (
7 L U H & K D Q J L Q J 7 R R O
61MM0B100
(1) Spare tire
(2) Jack
(3) Jack handle
(4) Wheel Brace
(5) Luggage Compartment Board
The tire changing tools are stowed in the luggage compartment.
(3) (4) (2)
(5)
(1)
( ; $ 0 3 / (
64MS142
To remove the spare tire, turn its bolt (1)
counterclockwise and remove it.
: $ 5 1 , 1 *
$ I W H U X V L Q J W K H W L U H F K D Q J L Q J W R R O V E H
V X U H W R V W R Z W K H P V H F X U H O \ R U W K H \
F D Q F D X V H L Q M X U \ L I D Q D F F L G H Q W
R F F X U V
& $ 8 7 , 2 1
7 K H M D F N V K R X O G E H X V H G R Q O \ W R
F K D Q J H Z K H H O V , W L V L P S R U W D Q W W R U H D G
W K H M D F N L Q J L Q V W U X F W L R Q V L Q W K L V V H F
W L R Q E H I R U H D W W H P S W L Q J W R X V H W K H
M D F N
(1)
( ; $ 0 3 / (
