2015 SUZUKI NEXA light
[x] Cancel search: lightPage 261 of 288
Downloaded from www.Manualslib.com manuals search engine
, 1 6 3 ( & 7 , 2 1 $ 1 ' 0 $ , 1 7 ( 1 $ 1 & (
0 6 (
$ L U & R Q G L W L R Q L Q J 6 \ V W H PIf you do not use the air conditioner for a
long period, such as during winter, it may
not give the best performance when you
start using it again. To help maintain opti-
mum performance and durability of your air
conditioner, it needs to be run periodically.
Operate the air conditioner at least once a
month for one minute with the engine
idling. This circulates the refrigerant and oil
and helps protect the internal components. 5 H S O D F H P H Q W R I W K H $ L U & R Q G L W L R Q H U
) L O W H U L I H T X L S S H G Since special procedures are required, we
recommend you take your vehicle to your
D X W K R U L V H G 0 D U X W L 6 X ] X N L Z R U N V K R S for the
air conditioner filter replacement.
1) To access the air conditioner filter,
remove the glove box. Refer to the pro-
cedure for the bulb replacement of the
“Glove Box Light” in this section.
79MH0761
2) Remove the cover (1) and pull out the
air conditioner filter (2).
NOTE:
When you install a new filter, make sure
the UP mark (3) faces upward.
(1)
(2)
(3)
Page 268 of 288
Downloaded from www.Manualslib.com manuals search engine ( 0 ( 5 * ( 1 & < 6 ( 5 9 , & (
0 6 (
- X P S V W D U W L Q J L Q V W U X F W L R Q V
: K H Q - X P S 6 W D U W L Q J < R X U 9 H K L F O H
8 V H W K H ) R O O R Z L Q J 3 U R F H G X U H 1) Use only a 12-volt battery to jump start
your vehicle. Position the good 12-volt
battery close to your vehicle so that the
jump leads will reach both batteries.
When using a battery installed on
another vehicle, DO NOT LET THE
VEHICLES TOUCH. Set the parking
brakes fully on both vehicles.
2) Turn off all vehicle accessories, except
those necessary for safety reasons (for
example, headlights or hazard lights).
54MN259
3) Make jump lead connections as follows:
1. Connect one end of the first jump
lead to the positive (+) terminal of the
flat battery (1).
2. Connect the other end to the positive
(+) terminal of the booster battery (2).
3. Connect one end of the second jump
lead to the negative (–) terminal of the
booster battery (2).
4. Make the final connection to an
unpainted, heavy metal part (i.e.
engine mount bracket (3)) of the
engine of the vehicle with the flat bat-
tery (1).
: $ 5 1 , 1 *
Page 270 of 288
Downloaded from www.Manualslib.com manuals search engine ( 0 ( 5 * ( 1 & < 6 ( 5 9 , & (
0 6 (
, I W K H 6 W D U W H U ' R H V 1 R W 2 S H U D W H1) Try turning the ignition switch to the
“START” position or try pressing the
engine switch to change the ignition
mode to START with the headlights
turned on to determine the battery condi-
tion. If the headlights go excessively dim
or go off, it usually means that either the
battery is flat or the battery terminal con-
tact is poor. Recharge the battery or cor-
rect battery terminal contact as
necessary.
, I W K H ( Q J L Q H L V ) O R R G H GIf the engine is flooded with the fuel, it may
be hard to start. If this happens, press the
accelerator pedal all the way to the floor
and hold it there while cranking the engine.
• For petrol engine model, do not operate
the starter motor for more than 12 sec-
onds.
• For diesel engine model, do not operate
the starter motor for more than 30 sec-
onds.
, I W K H ( Q J L Q H 2 Y H U K H D W VThe engine could overheat temporarily
under severe driving conditions. If the high
engine coolant temperature warning light
comes on as overheating during driving:
1) Turn off the air conditioner, if equipped.
2) Take the vehicle to a safe place and
park.
3) Let the engine run at the normal idle
speed for a few minutes until the high
engine coolant temperature warning
light goes off.
: $ 5 1 , 1 *
, I \ R X V H H R U K H D U H V F D S L Q J V W H D P
V W R S W K H Y H K L F O H L Q D V D I H S O D F H D Q G
L P P H G L D W H O \ W X U Q R I I W K H H Q J L Q H W R O H W
L W F R R O ' R Q R W R S H Q W K H K R R G Z K H Q
V W H D P L V S U H V H Q W : K H Q W K H V W H D P
F D Q Q R O R Q J H U E H V H H Q R U K H D U G R S H Q
W K H K R R G W R V H H L I W K H F R R O D Q W L V V W L O O
E R L O L Q J , I L W L V \ R X P X V W Z D L W X Q W L O L W
V W R S V E R L O L Q J E H I R U H \ R X S U R F H H G
Page 271 of 288
Downloaded from www.Manualslib.com manuals search engine
( 0 ( 5 * ( 1 & < 6 ( 5 9 , & (
0 6 (
If the high engine coolant temperature
warning light does not go off:
1) Turn off the engine and check that the
water pump belt and pulleys are not
damaged or slipping. If any abnormality
is found, correct it.
2) Check the coolant level in the reservoir.
If it is found to be lower than the “LOW”
line, look for leaks at the radiator, water
pump, and radiator and heater hoses. If
you locate any leaks that may have
caused the overheating, do not run the
engine until these problems have been
corrected.
3) If you do not find a leak, carefully add
coolant to the reservoir and then the
radiator, if necessary. (Refer to “Engine
Coolant” in the “INSPECTION AND
MAINTENANCE” section.)
NOTE:
If your engine overheats and you are
unsure what to do, contact your D X W K R U L V H G
0 D U X W L 6 X ] X N L Z R U N V K R S.
65D350d
: D U Q L Q J 7 U L D Q J O H
MHO-07-001
In case of vehicle break-down or during
emergency stopping, where, your vehicle
could become a potential traffic hazard,
keep the warning triangle, provided with
your vehicle, on the road free from any
obstacles behind your vehicle so as to
warn the approaching traffic, at an approxi-
mate distance of 50-100 m. The reflecting
side of the triangle should face the on com-
ing traffic. Please activate the hazard
warning lamps before alighting the vehicle
to keep the warning triangle.
: $ 5 1 , 1 *
Page 276 of 288
Downloaded from www.Manualslib.com manuals search engine $ 3 3 ( $ 5 $ 1 & ( & $ 5 (
0 6 (
NOTE:
• In order to keep leather upholstery look-
ing good, it should be cleaned at least
twice a year.
• If leather upholstery becomes wet,
immediately wipe it dry with tissue paper
or a soft cloth. Water may cause leather
to harden and shrink if it is not wiped off.
• When parking on sunny days, select a
shady place or use a sunshade. If
leather upholstery is exposed to direct
sunlight for a long time, it may discolor
and shrink.
• As is common with natural materials,
leather is inherently irregular in grain and
cowhide has spots in its natural state.
These do not affect the performance of
the leather in any way.
6 H D W E H O W V
Clean seat belts with a mild soap and
water. Do not use bleach or dye on the
belts. They may weaken the fabric in the
belts.
9 L Q \ O I O R R U P D W V
Ordinary dirt can be removed from vinyl
with water or mild soap. Use a brush to
help loosen dirt. After the dirt is loosened,
rinse the mat thoroughly with water and
dry it in the shade.
& D U S H W V
Remove dirt and soil as much as possible
with a vacuum cleaner. Using a mild soap
solution, rub stained areas with a clean
damp cloth. To remove soap, rub the areasagain with a cloth dampened with water.
Repeat this until the stain is removed, or
use a commercial carpet cleaner for
tougher stains. If you use a carpet cleaner,
carefully follow the manufacturer’s instruc-
tions and precautions.
, Q V W U X P H Q W S D Q H O D Q G F R Q V R O H
Remove loose dirt with a vacuum cleaner.
Gently wipe dirt off with a tightly squeezed
damp clean cloth. Repeat this until the dirt
is removed.
& O H D Q L Q J W K H ( [ W H U L R U & D U L Q J I R U $ O X P L Q X P : K H H O V
NOTE:• Do not use an acidic or alkaline detergent
to wash aluminum wheels. These types of
detergent will cause permanent spots,
discoloration and cracks on finished sur-
faces.
• Do not use a bristle brush and soap con-
taining an abrasive material. These will
damage finished surfaces.
NOTICE
' R Q R W X V H F K H P L F D O S U R G X F W V W K D W
F R Q W D L Q V L O L F R Q W R Z L S H H O H F W U L F D O
F R P S R Q H Q W V V X F K D V W K H D L U F R Q G L
W L R Q L Q J V \ V W H P D X G L R Q D Y L J D W L R Q
V \ V W H P R U R W K H U V Z L W F K H V 7 K H V H Z L O O
F D X V H G D P D J H W R W K H F R P S R Q H Q W V
NOTICE
, W L V L P S R U W D Q W W K D W \ R X U Y H K L F O H E H
N H S W F O H D Q D Q G I U H H I U R P G L U W ) D L O X U H
W R N H H S \ R X U Y H K L F O H F O H D Q P D \ U H V X O W
L Q I D G L Q J R I W K H S D L Q W R U F R U U R V L R Q W R
Y D U L R X V S D U W V R I W K H Y H K L F O H E R G \
Page 277 of 288
Downloaded from www.Manualslib.com manuals search engine
$ 3 3 ( $ 5 $ 1 & ( & $ 5 (
0 6 (
: D V K L Q J
60B212S
When washing the vehicle, park it where
direct sunlight does not fall on it and follow
the instructions below:
1) Flush the underside of body and wheel
housings with pressurized water to
remove mud and debris. Use plenty of
water.
2) Rinse the body to loosen the dirt.
Remove dirt and mud from the body
exterior with running water. You may
use a soft sponge or brush. Do not use
hard materials which can scratch the
paint or plastic. Remember that the
headlight covers or lenses are made of
plastic in many cases.3) Wash the entire exterior with a mild
detergent or car wash soap using a
sponge or soft cloth. The sponge or
cloth should be frequently soaked in the
soap solution.
4) Once the dirt has been completely
removed, rinse off the detergent with
running water.
5) After rinsing, wipe off the vehicle body
with a wet chamois or cloth and allow it
to dry in the shade.
: $ 5 1 , 1 *
Page 278 of 288
Downloaded from www.Manualslib.com manuals search engine $ 3 3 ( $ 5 $ 1 & ( & $ 5 (
0 6 (
6) Check carefully for damage to painted
surfaces. If there is any damage, touch-
up the damage following the procedure
below:
1. Clean all damaged spots and allow
them to dry.
2. Stir the paint and touch-up the dam-
aged spots lightly using a small
brush.
3. Allow the paint to dry completely.
: D [ L Q J
60B211S
After washing the vehicle, waxing and pol-
ishing are recommended to further protect
and beautify the paint.
• Only use waxes and polishes of good
quality.
• When using waxes and polishes,
observe the precautions specified by the
manufacturers.
NOTICE
, I \ R X X V H D Q D X W R P D W L F F D U Z D V K
P D N H V X U H W K D W \ R X U Y H K L F O H
Page 285 of 288
Downloaded from www.Manualslib.com manuals search engine
6 3 ( & , ) , & $ 7 , 2 1 6
0 6 (
, 7 ( 0 / L J K W V : $ 7 7 $ * ( % 8 / % 1 R
Headlight Halogen 12V 60/55W H4
Discharge 12V 25W D5S
Front fog light 12V 35W H8
Position light 12V 5W W5W
LED –
Turn signal light Front 12V 21W PY21W
Rear 12V 21W PY21W
Side turn signal light 12V 5W WY5W
LED –
Tail/brake light 12V 21/5W P21/5W
High mount stop light 12V 5W W5W
Reversing light 12V 16W W16W
License plate light 12V 5W W5W
Interior light Glove box light (if equipped) 12V 1.4W –
Footwell light (if equipped) /
Instrument panel pocket light
(if equipped)LED –
Center 12V 10W –
Other lights 12V 5W W5W