Emergencies
Lifting the vehicle Fig. 158
Jack position points Fig. 159
Fitting the jack. In order to remove the wheel, the vehicle
must be raised with a jack.
– Locate the jacking point under the door sill
closest to the punctured wheel ››› Fig. 158.
– Place the jack under the jacking point and
turn the crank until the arm of the jack is di- rectly below the vertical rib under the door
sill.
– Align the jack so that the arm of the jack
fits around the rib under the door sill and
the movable base plate of the jack is flat on
the ground ››› Fig. 159 .
– Rai
se the vehicle until the defective wheel
is just clear of the ground.
Recesses at the front and rear of the door
sills mark the jacking points ››› Fig. 158.
There i
s only one jacking point for each
wheel. Do not fit the jack anywhere else.
An
unstable surface under the jack may
cause the vehicle to slip off the jack. There-
fore, it must be fitted on solid ground offer-
ing good support. Use a large and stable
base, if necessary. On a hard, slippery sur-
face (such as tile) use a rubber mat or similar
to prevent the jack from slipping. WARNING
● Take all precautions so that the base of the
jack does not slip. Failure to follow this in-
struction could result in an accident.
● The vehicle can be damaged if the jack is
not applied at the correct jacking points.
There is also a risk of injury since the jack can
slip off suddenly if it is not properly engaged. Jack position points for vehicles with
sill panel trim*
Fig. 160
Plastic sill panel trim with jack an-
chor cover. Vehicles with plastic sill panel trim, with
cover*
– Remove the cap A to access the anchor
point for the vehicle jack ››› Fig. 160 .
– Pull on the cover and remove it from its al-
lotment in the direction of the arrow
››› Fig. 160 .
– Onc e the c
over has been released, it will re-
main connected to its strap so that is not
lost.
185
Technical specifications
Advice
Operation
Safety
