2015 Ram ProMaster hood release

Turn the adjuster wheel to the right or left to adjust the
height of the armrest up or down.TO OPEN AND CLOSE THE HOOD
To open the hood, two latches must be released.
1. Open the drivers door to gain access to the hoodrelease lever. Pull the hood release lever located on the
side of the instrument panel.
Adjuster Wheel
Hood Release
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 89

2. Move to the outside of the vehicle, reach into theopening beneath the center of the hood and push the
safety latch lever to the right to release it, before
raising the hood.
3. Raise the hood and place the hood prop rod in hood slot to secure the hood in the open position.
CAUTION!
To prevent possible damage:
•Before closing hood, make sure the hood prop rod
is fully seated into its storage retaining clips.
(Continued)
Hood Safety Latch Lever Location
Hood Prop Rod Slot
90 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

INSTRUMENT PANEL FEATURES
1 — Air Outlet10 — Lower Glove Compartment 19 — Uconnect® Phone Buttons
2 — Multifunction Lever (External Lights) 11 — Cup Holder20 — Tilt Steering Column Release Lever
3 — Instrument Cluster 12 — USB Charger/12V21 — Horn
4 — Multifunction Lever (Front/Rear Wiper, Trip Computer) 13 — Climate Controls 22 — Mute/Uconnect® Voice Command Buttons
5 — Radio 14 — Lower Switch Ban23 — Cruise Control Switches
6 — Clip Board 15 — Cup Holders24 — Fuse Box Lid
7 — Upper Glove Compartment 16 — Shift Lever25 — Electronic Vehicle information Center (EVIC)
Controls
8 — Passenger Air Bag
17 — USB / AUX
26 — Hood Release
9 — Storage Compartment
18 — Ignition Switch
126 UNDERSTANDING YOUR INSTRUMENT PANEL

3. Install the A/C air filter/filter retainer back into thefresh air inlet. When installing the filter retainer make
sure the retainer is fully engaged.
4. Install the two screws back into the assembly to secure the filter retainer to the fresh air inlet.
Body Lubrication
Locks and all body pivot points, including such items as
seat tracks, door hinge pivot points and rollers, liftgate,
tailgate, decklid, sliding doors and hood hinges, should
be lubricated periodically with a lithium based grease,
such as MOPAR® Spray White Lube to assure quiet, easy
operation and to protect against rust and wear. Prior to
the application of any lubricant, the parts concerned
should be wiped clean to remove dust and grit; after
lubricating excess oil and grease should be removed.
Particular attention should also be given to hood latching
components to ensure proper function. When performing other underhood services, the hood latch, release mecha-
nism and safety catch should be cleaned and lubricated.
The external lock cylinders should be lubricated twice a
year, preferably in the Fall and Spring. Apply a small
amount of a high quality lubricant, such as MOPAR®
Lock Cylinder Lubricant directly into the lock cylinder.Windshield Wiper Blades
Clean the rubber edges of the wiper blades and the
windshield periodically with a sponge or soft cloth and a
mild nonabrasive cleaner. This will remove accumula-
tions of salt or road film.
Operation of the wipers on dry glass for long periods
may cause deterioration of the wiper blades. Always use
washer fluid when using the wipers to remove salt or dirt
from a dry windshield.
344 MAINTAINING YOUR VEHICLE

GaugesFuel .................................128
Odometer ............................ .128
Speedometer ..........................128
Tachometer ............................128
Gear Ranges ............................ .205
Gear Select Lever Override ..................324
General Information ....................183, 261
General Maintenance .......................128
Glass Cleaning .......................... .360
Gross Axle Weight Rating ................269, 272
Gross Vehicle Weight Rating ..............269, 272
Guide, Body Builders ........................6
GVWR .................................269
Hazard Driving Through Flowing, Rising, Or Shallow
Standing Water ........................ .215
Hazard Warning Flasher ....................287 Headlights
Cleaning ............................ .359
High Beam ............................94
High Beam/Low Beam Select Switch ..........94
Passing ...............................94
Switch ................................92
Head Restraints ...........................86
Heated Mirrors ............................74
Heated Seats .............................85
Heater .................................183
Heater, Engine Block .......................202
High Beam/Low Beam Select (Dimmer) Switch .....94
Hill Start Assist .......................... .228
Hitches Trailer Towing ........................ .274
Hood Release .............................89
Ignition .................................11
Key..................................11
412 INDEX