2. Pull the outboard side of the lamp rearward farenough to unsnap the two receptacles on the outboard
side of the lamp housing from the two plastic snap
post retainers in the outer box side panel. 3. Disconnect the wiring harness connectors from the
bulb socket.
4. Rotate the bulb socket counterclockwise 1/4 turn to unlock it from the housing.
5. Pull the bulb straight out of the socket.
CAUTION!
Do not contaminate the bulb glass by touching it
with your fingers or by allowing it to contact other
oily surfaces. Shortened bulb life will result.
6. Reverse the procedure to install the bulb and housing.
Pulling Out The Tail Lamp
7
MAINTAINING YOUR VEHICLE 809
Recreational.......................... .667
Weight .............................. .649
Towing Vehicle Behind a Motorhome ...........667
Traction ............................... .546
Traction Control ......................... .577
Trailer Sway Control (TSC) ..................586
Trailer Towing .......................... .641
Cooling System Tips .....................662
Hitches ............................. .648
Minimum Requirements ..................651
Mirrors ............................. .140
Trailer and Tongue Weight .................650
Wiring .............................. .659
Trailer Towing Guide ...................... .649
Trailer Weight ........................... .649
Transfer Case ........................... .782
Electronically Shifted ..............491, 498, 503
Fluid ............................... .820
Transmission ........................... .455Automatic
..................455, 464, 476, 782
Fluid ............................... .820
Maintenance .......................... .782
Shifting ............................. .452
Transmitter Battery Service (Remote Keyless Entry) . .30
Transmitter Programming (Remote Keyless Entry) . . .25
Transmitter, Remote Keyless Entry (RKE) .........25
Tread Wear Indicators ..................... .610
Turn Signals ...................175, 285, 806, 808
Uconnect® Customer Programmable Features ........362, 383
Operation ............................ .390
Uconnect® Settings ..................... .351
Uconnect® Settings ..................362, 383
Uconnect® Settings Customer Programmable Features ......42, 359, 380
Passive Entry Programming ..........42, 359, 380
Uconnect® Settings ..................359, 380
10
INDEX 859
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENTSpecial design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.
