2015 Ram 1500 glove box

!STORAGE............................237
▫Glove Compartment...................237
▫Door Storage.........................239
▫Center Storage Compartment — If Equipped . .240
▫Second Row In-Floor Storage Bin — If
Equipped...........................242
▫Seatback Storage......................243
▫Storage (Regular Cab)..................243
▫Storage and Seats (Crew Cab).............244
▫Plastic Grocery Bag Retainers (Regular Cab
Models)............................245
!REAR WINDOW FEATURES..............245
▫Rear Window Defroster.................245
▫Power Sliding Rear Window — If Equipped . .246
▫Manual Sliding Rear Window —
If Equipped.........................247
!FOLD FLAT LOAD FLOOR — IF EQUIPPED . .247
!PICKUP BOX.........................251
▫Cargo Camera — If Equipped.............253
▫Turning Cargo Camera On Or Off — With
Uconnect® 8.4A/8.4AN.................253
!RAMBOX® — IF EQUIPPED..............254
▫RamBox® Integrated Box Side Storage Bins . . .254
▫Locking And Unlocking RamBox®.........256
▫RamBox® Safety Warning................257
▫Bed Extender — If Equipped.............258
▫Bed Rail Tie-Down System..............266
!SLIDE-IN CAMPERS....................268
124 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Disconnecting the Rear Camera or Remote
Keyless Entry — If Equipped
1. Open the tailgate to access the rear camera or RKE
connector bracket located on the rear sill.
2. Remove the connector bracket from the sill by press-
ing inward in the locking tab.
3. Disconnect the chassis wiring harness, ensuring the
connector bracket does not fall into the sill.
4. Connect the chassis plug and bracket (provided in the
glove box) to the chassis wiring harness and insert the
bracket back into the sill.
Connector Bracket
Locking Tab
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 269

5. Connect the tailgate plug (provided in the glove box)
to the tailgate wiring harness to ensure that the
terminals do not corrode.
6. Tape the tailgate harness and bracket against the
forward-facing surface of the tailgate. This will pre-
vent damaging the connector and bracket when stor-
ing or reinstalling the tailgate.
Removing The Tailgate
1. Disconnect the wiring harness for the rear camera and
or power locks (if equipped), refer to “Disconnecting
the Rear Camera — If Equipped” in this section.
2. Unlatch the tailgate and remove the support cables by
releasing the lock tang from the pivot.
NOTE:Make sure tailgate is supported when removing
support cables.
3. Raise the tailgate to a 45 degree angle.
4. Raise the right side of the tailgate until the right side
pivot clears the hanger bracket.
Locking Tang
270 UNDERSTANDING THE FEATURES OF YOUR VEHICLE