2015 Peugeot RCZ ECU

4
RCZ_en_Chap00b_vue-ensemble_ed01-2015
ExTERIOR
Remote control key 37-40
- opening / closing
-

unlocking / partial opening of the boot
-


anti-theft protection
-

battery
Alarm
41-43
Boot
49
Temporary puncture repair kit

150-156
Changing a wheel


157-161
Active,

fixed spoiler 93-94,
95
Parking sensors

135-137
T

owbar 186-187
Towing

184-185
Changing bulbs


172-176
-


rear lamps
-


3rd stop lamp
-


number plate lamps Accessories

190-191
Cleaning, maintenance

188-189
Fuel tank


139-140Wipers

83-86
Changing a wiper blade

163
Door mirrors


55-56
Active bonnet


92
Lighting controls


75-80
Directional lighting


82
Headlamp height adjustment


81
Changing bulbs


169-172
-


front lamps
-


direction indicator repeaters
Doors

46-48
-

opening / closing
-


central locking
-


anti-intrusion security
-


emergency locking
Electric windows


44-45
Braking assistance


89
T

rajectory control
90-91
T

yre under-inflation detection 127-128
Tyre pressures

156, 198
Snow chains


162

8
RCZ_en_Chap00b_vue-ensemble_ed01-2015
DSC/ASR system 90-91
Parking sensors 135-137
Assistance call

88, 201-202
Hazard warning lamps


87
Emergency call


88, 201-202
V

olumetric alarm monitoring

41-43
Central locking /

Anti-intrusion
security

47-48
INSTRUMENTS AND CONTROLS
CENTRAL
SWITCH P ANEL

44
RCZ_en_Chap02_ouvertures_ed01-2015
ELECTRIC WINDOWS
Fitted with a safety anti-pinch system.
A.
Left-hand electric window
.
B.

Right-hand electric window
.
ONE-TOUCH ELECTRIC WINdOWS
There are two options:
-
manual mode
F


Press or pull the switch gently
. The window stops when the
switch is released.
-

automatic mode
F

Press or pull the switch firmly.
The
window opens or closes fully
when the switch is released.
F


Pressing the switch again stops the movement of the window
.The electric window switches remain operational for approximately
45 seconds after the ignition is switched off or until the vehicle is
locked after a door is opened.
If the passenger's window cannot be operated from the driver's
door control panel, carry out the operation from the control panel
of the passenger door.
After approximately ten consecutive complete opening/closing
movements of the window, a protection function is activated which
only authorises closing of the windows, so as to prevent damage
to the electric window motor.
Once the window is closed, the switches will become operational
again after approximately 40 minutes.
Safety anti-pinch
When the window rises and meets an obstacle, it stops and partially
lowers again.
If the window cannot be closed (for example, in the presence of
ice), immediately after the movement is reversed:
F

press and hold the switch until the window opens fully
,
F

then pull the switch immediately and hold it until the window
closes,
F


continue to hold the switch for approximately one second after
the window has closed.
The safety anti-pinch function is not operational during these
operations.

48
RCZ_en_Chap02_ouvertures_ed01-2015
Pressing the central locking control unlocks the vehicle.
Opening a door from the inside, when stationary, also unlocks the
vehicle, but the vehicle will be locked again when the speed exceeds
6 mph (10 km/h).
Activation / deactivation
You can activate or deactivate this function.
F
With the ignition on, press the button for more than two seconds.
A


confirmation message appears in the screen.
EMERGENCY LOCKING
To lock or unlock the doors mechanically in the event of a central
locking
system failure or flat battery.
Locking the driver's door
F Insert the key in the lock, then turn it to the right.
Unlocking the driver's door
F Insert the key in the lock, then turn it to the left.
Locking the passenger door
F Using the key, remove the black cap on the edge of the door.
F
Insert the key in the cavity without forcing, then without turning it,
move the the latch sideways towards the interior of the door

.
F Remove
the key and refit the cap.
Unlocking the passenger door
F Pull the interior door opening control.
ANTI-INTRUSION SECURITY
This function permits automatic and simultaneous locking of the doors,
boot lid and fuel filler flap as soon as the vehicle speed exceeds 6 mph
(10 km/h).
Operation
If one of the doors is open, the automatic central locking does not take\

place.
If the boot lid is open, the automatic central locking of the doors is
active.

53
RCZ_en_Chap03_confort_ed01-2015
STORING DRIVING POSITIONS
System which takes into account the electrical settings of the driver's \
seat and the door mirrors. It enables you to store two positions using
the buttons on the side of the driver's seat.
STORING A POSITION
Using buttons M / 1 / 2
F Switch on the ignition.
F
Adjust your seat and your door mirrors.
F


Press button
M, then press button 1 or 2 within four seconds.
An audible signal is heard indicating that the settings have been
stored.
RECALLING A STORE d POSITION
Storing a new position cancels the previous position.
Using button 1 or 2
F Press and hold button 1 or 2 until the audible signal is heard
indicating the end of the adjustment.
When the ignition is off, after a few consecutive position recalls,
the function will be deactivated until the engine is started,
to
prevent discharging of the battery.
3/
EASE OF USE and COMFORT

58
RCZ_en_Chap03_confort_ed01-2015
ACCESS TO THE REAR SEATS
REAR SEATS
Two-seat bench with one-piece fixed seat cushion and one-piece folding backrest.
The
rear seat headrests are fixed.
FOLdING dOWN THE REAR BACKREST
RETURNING THE REAR BACKREST TO THE UPRIGHT POSITION
When returning the backrest to the upright position, ensure that it is
locked securely to assure your safety. F
Open the boot.
F

Pull the backrest release handle, located under the shelf.
When transporting long objects, do not place a load of more
than 30 kg on the rear of the backrest.
Do not place rough objects on the rear of the backrest which
could damage it.
F

Check

that

the

front

seat

has

been

moved

forward

sufficiently.
F

Pull the control upwards to fold the backrest; this control does not
release the seat cushion.
When put back in place, the backrest returns to its initial position.
The backrest can be folded down to increase the boot storage space.
The backrest release control is located in the boot.
F

Check

that

the

front

seats

have

been

moved

forward

sufficiently.
F

Check that nothing has been left on the rear seats.
F


Store the seat belt buckles on their respective securing points
located between the headrests. F

Fold the backrest down onto the seat cushion.

72
RCZ_en_Chap03_confort_ed01-2015
MATS
Fitting
When fitting the mat for the first time, on the driver's side use only the fixings provided in the wallet attached.
The other mats are simply placed on the carpet.
Removal
To remove the mat on the driver's side:
F
move the seat as far back as possible,
F

unclip the fixings,
F

remove the mat.
Refitting
To refit the mat on the driver's side:
F
position the mat correctly
,
F refit
the fixings by pressing,
F

check that the mat is secured correctly
.
To avoid any risk of jamming of the pedals:
- only
use mats which are suited to the fixings already present
in

the vehicle; these fixings must be used,
- never
fit one mat on top of another.
The use of mats not approved by PEUGEOT may interfere with
access to the pedals and hinder the operation of the cruise
control
/ speed limiter.
The
mats approved by PEUGEOT

have two fixings located below
the seat.

74
RCZ_en_Chap03_confort_ed01-2015
The duration of lighting varies, depending on the context:
-
when the ignition is of
f, approximately ten minutes,
-

in energy economy mode, approximately thirty seconds,
-


when the engine is running, no limit.
STORAGE BOX
This has areas for storing a box of spare bulbs, a first aid kit, the temporary puncture repair kit, a warning triangle, the removable ball
of the towbar system...
BOOT LAMPS
Your vehicle is fitted with two boot lamps; one in the right-hand boot side trim and a second in the centre under the rear shelf.
They come on automatically when the boot is opened and switch of f
automatically when the boot is closed.
They cannot be deactivated manually.
A second warning triangle can be stored in the boot lid trim.
For access to it:
F raise

the

floor

using

the

strap,
F

secure it in the vertical position behind the stops, located on
the sides of the boot.