2015 Peugeot RCZ remote control

42
RCZ_en_Chap02_ouvertures_ed01-2015
LOCKING THE VEHICLE WITH EXTERIOR
PERIMETER

MONITORING
ONL
Ydeactivation of the interior volumetric and anti-tilt monitoring
F Switch off the ignition.
F
Within ten seconds, press the button until the indicator lamp is on
continuously

.
F

Get out of the vehicle.
F


Press the locking button on the remote control immediately
.
The exterior perimeter monitoring alone is activated: the indicator lamp\

in
the button flashes once per second.
Reactivation of the interior volumetric and anti-tilt monitoring
F Press the unlocking button on the remote control to deactivate the
exterior perimeter monitoring.
F

Press the locking button on the remote control to activate all the
monitoring functions.
The

indicator lamp in the button again flashes once per second.
Deactivate the interior volumetric and anti-tilt monitoring to avoid
unwanted triggering of the alarm in certain cases such as:
-

leaving a pet in the vehicle,
-

leaving a window partially open,
-
washing your vehicle,
-

changing a wheel,
-


having your vehicle towed,
-


transport by sea. T

o be effective, this deactivation must be carried out each time the
ignition is switched off.

43
RCZ_en_Chap02_ouvertures_ed01-2015
OPERATING FAULT
L
OCKING
THE
VEHICLE WITHOUT
ACTIV
ATING
THE


ALARM
F Lock or deadlock the vehicle using the key in the driver's door lock.
When the ignition is switched on, fixed illumination of the indicator lamp
in the button indicates a fault with the system.
Have

it checked by a PEUGEOT

dealer or a qualified workshop.
FAILURE OF THE REMOTE CONTROL
To deactivate the monitoring functions:
F

unlock the vehicle using the key in the driver's door lock,
F


open the door; the alarm is triggered,
F


switch on the ignition; the alarm stops; the indicator lamp in the
button goes of

f.
TRIGGERING OF THE ALARM
The monitoring functions remain active until the alarm has been
triggered eleven times in succession.
When the vehicle is unlocked using the remote control, rapid
flashing
of the indicator lamp in the button informs you that the
alarm was triggered during your absence. When the ignition is
switched

on, this flashing stops immediately.
This
is indicated by sounding of the siren and flashing of the direction
indicators for thirty seconds.
2 minutes after closing the last door or the boot, the system is activat\
ed
automatically
.
F To
avoid triggering the alarm when entering the vehicle, first press
the remote control unlocking button.
AUTOMATIC ACTIVATION *
* Depending on country of sale.
2/
ACCESS

46
RCZ_en_Chap02_ouvertures_ed01-2015
DOORS
OPENING
From outside
F After unlocking the vehicle completely using the remote control or
the key, take hold of the door handle then pull it.
The window lowers automatically by a few millimetres to permit
opening of the door

.
In freezing conditions, the presence of ice may hinder the automatic
partial opening of the window; remove the ice which may have formed
along the lower seal, located at the base of the window.
When
the selective unlocking is activated, the first press of the
remote control unlocking button permits unlocking of the driver's
door only

.
From inside
F Pull the door control to open the door; this unlocks this vehicle
completely .
The window lowers automatically by a few millimetres to permit
opening of the door

.
With the selective unlocking activated:
-

the driver's door control unlocks the driver's door and the fuel
filler

flap only.
-

the passenger's door control unlocks the passenger's door
and the boot.
The interior door controls do not operate when the vehicle is
deadlocked.
If you leave the door open for more than one minute, the window
rises again.
Pull the handle again to reactivate the system.

47
RCZ_en_Chap02_ouvertures_ed01-2015
CLOSING
The window rises automatically after a few seconds and adjusts to
provide perfect sealing when closed.-

when the engine is running
, this warning lamp comes on,
accompanied by a message in the screen for a few seconds,
CENTRAL LOCKING CONTROL
This control permits simultaneous locking or unlocking of the doors,
boot
lid and fuel filler flap from inside the vehicle.
Locking
F Press this button to lock the vehicle.
The red indicator lamp on the button comes on.
If one of the doors or the boot lid is open, the central locking from
the inside does not take place.
Unlocking
F Press this button again to unlock the vehicle.
The red indicator lamp on the button goes of f.
Locking / deadlocking from the outside
When the vehicle is locked or deadlocked from the outside, the
red indicator lamp flashes and the button is inactive.
F

With normal locking, pull on the interior door control lever to
unlock the vehicle.
F


With deadlocking, you have to use the remote control or the
key to unlock the vehicle.
When washing your vehicle:
-

first

lock

the

vehicle

using

the

remote

control

or

the

key,
-

avoid spraying the upper part of the windows,
-


keep the end of the high pressure nozzle at least 1 metre from
the windows and door seals.
When a door is not closed correctly:
Be aware of the risk of pinching when the window rises
automatically on closing the door

.
-

when the vehicle is moving
(speed higher than 6 mph (10 km/h)),
this warning lamp comes on, accompanied by an audible signal and
a message in the screen for a few seconds.
2/
ACCESS

49
RCZ_en_Chap02_ouvertures_ed01-2015
BOOT
OPENING
F Press this button for more than two seconds to unlock
the boot lid. The boot lid opens slightly.
F

Lift the boot lid.
This


action
also unlocks the doors and the fuel filler flap.
Using the manual control; vehicle unlocked
F Press the opening control above the number plate.
F
Lift the boot lid.
CLOSING
F Lower the boot lid using one of the interior grab handles.
F
If necessary
, press the top of the boot lid to close it fully.
If the boot lid is not closed correctly: -

when the engine is running
, this warning lamp comes on,
accompanied by a message in the screen for a few seconds,
When selective unlocking is activated, the boot can also be
opened by a second press on the open padlock on the remote
control.
Using the remote control
Emergency locking
If the central locking system fails (flat battery), you are advised to disconnect the battery.
-

when the vehicle is moving
(speed above 6 mph (10 km/h)), this
warning lamp comes on, accompanied by an audible signal and a
message in the screen for a few seconds.
Never grasp the boot lid by the active spoiler
.
2/
ACCESS

56
RCZ_en_Chap03_confort_ed01-2015
Folding
F From outside: lock the vehicle using the remote control or the key.
F
From inside: with the ignition on, pull the control A

in the central
position rearwards.
If the mirrors are folded using control A, they will not unfold when
the vehicle is unlocked. Pull again on control A.
Unfolding
F From outside: unlock the vehicle using the remote control or
the
key.
F

From inside: with the ignition on, pull the control A

in the central
position rearwards.
The folding and unfolding of the door mirrors using the remote
control
can be deactivated by a PEUGEOT

dealer or a qualified
workshop.
If necessary the mirrors can be folded manually

.
Automatic tilting in reverse gear
System which provides a view of the ground during parking
manoeuvres in reverse gear.
Programming
F With the engine running, engage reverse gear.
F
Select and adjust the left-hand and right-hand mirrors in
succession.
The adjustment is stored immediately

.
Switching on
F With the engine running, engage reverse gear .
F
Move control
A to the right or to the left to select the corresponding
mirror.
The glass of the mirror selected tilts downwards, in accordance with its\

programming.
Switching off
F Exit reverse gear and wait ten seconds.
or
F

Return control A

to the central position.
The mirror glass returns to its initial position.
The mirror glass also returns to its initial position:
-

if the speed exceeds 6 mph (10 km/h),
-


if the engine is switched of
f.

64
RCZ_en_Chap03_confort_ed01-2015
COURTESY LAMP
A. Courtesy lamp
B.
Map reading lamps
COURTESY LAMP
In this position, the courtesy lamp comes on gradually:
-

when the vehicle is unlocked,
-


when the key is removed from the ignition,
-


when a door is opened,
-


when the remote control locking button is activated, in order to
locate your vehicle. It switches of

f gradually:
-
when the vehicle is locked,
-

when the ignition is switched on,
-

30 seconds after the last door is closed.
Permanently of
f.
Permanent lighting.
With the "permanent lighting" mode, the duration of lighting varies,
depending on the circumstances:
-
with the ignition of
f, approximately ten minutes,
-
in energy economy mode, approximately thirty seconds,
-

with the engine running, unlimited.
MAP
REA d ING LAMPS
F With the ignition on, press the corresponding switch.

65
RCZ_en_Chap03_confort_ed01-2015
INTERIOR MOOD LIGHTING
The dimmed passenger compartment lighting improves visibility in the
vehicle when the light is poor.
SWITCHING ON
At night, the footwell lighting and the front courtesy mood lamp come on\

automatically when the sidelamps are switched on.
SWITCHING OFF
The interior mood lighting switches off automatically when the
sidelamps are switched off.
PROGRAMMING
The function is activated or deactivated via the vehicle
configuration menu.
This function is activated by default.
INTERIOR WELCOME LIGHTING
The remote switching on of the passenger compartment lighting
makes your entry into the vehicle easier in poor light. It is activated \
in
accordance with the light intensity detected by the brightness sensor.
SWITCHING ON
F Press the open padlock on the remote control.
The front door sill lighting, the footwell lighting and the courtesy lam\
ps
come on; your vehicle is also unlocked.
SWITCHING OFF
The interior welcome lighting switches off automatically after a certain
time, when one of the doors is opened or the ignition is switched on.
3/
EASE OF USE and COMFORT