2015 Peugeot 208 Menu

29
208_en_Chap01_instruments-bord_ed01-2016
Touch screen
It gives access to:
- m enus for adjusting settings for vehicle
functions and systems,
-

a
udio and display configuration menus,
-

a
udio system and telephone controls and
the display of associated information. As a safety measure, the driver
should only carr y out operations
that require close attention, with the
vehicle stationary.
Some functions are not accessible
when driving.
And, depending on equipment, it allows:
-
t
he display of alert messages and the
visual parking sensors information,
-

a
ccess to the controls for the navigation
system and Connected Services, and the
display of associated information.Recommendations
It is necessary to press firmly, particularly for
"flick" gestures (scrolling through lists, moving
the map...).
A light wipe is not enough.
The screen does not recognise pressing with
more than one finger.
This technology allows use at all temperatures
and when wearing gloves.
Do not use pointed objects on the touch
screen.
Do not touch the touch screen with wet hands.
Uses a soft clean cloth to clean the touch
screen.
State of indicator lamps
Some buttons contain an indicator lamp that
gives the state of the corresponding function.
Green indicator: you have switched on the
corresponding function.
Orange indicator: you have switched off the
corresponding function.
1
Instruments

1
31
208_en_Chap01_instruments-bord_ed01-2016
F Select the "Driving" menu.
F

S

elect the desired tab using your finger.
Touch screen
F Press the MENU button to
display the main menu. Successively:
Current information
Range
(miles or km)
The distance that can be
travelled using the remaining
fuel in the tank (based on the
average fuel consumption over
the last few miles).
Once the remaining range is below 20 miles

(30 km), dashes are displayed. After topping-up
with at least 5 litres of fuel, the range is recalculated
and displayed if it exceeds 60 miles (100 km).
Current fuel consumption
(l/100 km or km/l or mpg)
Calculated over the last few seconds.
Stop & Star t time counter
(if function present)
(In minutes
/ seconds -
hours
/ minutes)
This function is only displayed above
20

mph (30 km/h).
This value can vary following a change
in driving conditions or the relief of the
road, giving rise to a big difference in
current fuel consumption.
If dashes instead of figures continue
to be displayed when driving, contact
a PEUGEOT dealer or a qualified
workshop. If your vehicle has Stop & Start, a time counter
records the periods in STOP mode during a
j o u r n ey.
It is reset to zero every time the ignition is
switched on using the key.
Instruments

33
208_en_Chap01_instruments-bord_ed01-2016
Date and time
Press MENU to display the " MAIN
MENU ".
Select "Adjust time " or "Adjust date".
Touch screen
Select " Settings ".
In the secondary page, select " Time/
Date ".
Select "
Secondary page ".
Modify the setting using the virtual keypad then
confirm.Press "Confirm " to save and quit.
Instrument panel
F Each press of this button moves between
the following settings:
-
hours,
-


minutes,
-

1
2 or 24 hour format.
1
Instruments

34
208_en_Chap01_instruments-bord_ed01-2016
Lighting dimmer
Tw o b u t t o n s
With the exterior lighting on:
One button
F Press this button to increase the brightness. F
P ress this button to
adjust the brightness,
F

P
ress this button to
reduce the brightness. F

r
elease the button when the desired level is
reached.
As soon as the lighting reaches the required
level of brightness, release the button. System for the manual adjustment of the
brightness of the instrument panel and the
touch screen to suit the ambient light level.
With the vehicle lighting off or in day
mode (daytime running lamps on),
pressing the button has no effect.
Touch screen
F Select " Screen settings" .
F Press
MENU

to display the "MAIN
MENU" .
F Select
"Settings" .
F Select
"Secondary page" .
Adjustment
F

A

djust the brightness by moving the cursor.
Instruments

Access35
208_en_Chap02_ouvertures_ed01-2016
Remote control
A. Unfolding / Folding.
B. Unlocking.
D

isarming the alarm.
C.


Locking.
L

ocating the vehicle.
A

rming the alarm.
Complete unlocking
Using the key
F Turn to the front.
Using the remote control
F Press.
Selective unlocking
F Press once to unlock the driver's d o o r o n l y.
Using the remote control
This is set in the " Driving
assistance " menu, then " Vehicle
settings " and "Vehicle access ". Unlocking is confirmed by rapid
flashing of the direction indicators for
approximately 2 seconds.
According to version, the electric door
mirrors unfold at the same time as the
first unlocking action.
F
P
ress twice in succession to unlock the
other doors and the boot.
Complete unlocking is activated by default.
In the "Driving assistance" menu
Doors
2

Ease of use and comfort69
208_en_Chap03_ergonomie-confort_ed01-2016
Mood lighting
Switching on
At night, panoramic sunroof light-emitting
diodes (LEDs) come on automatically when the
sidelamps are switched on.
Switching off
The interior mood lighting switches off
automatically when the sidelamps are switched
of f.
Settings
Settings for the mood lighting can
be adjusted via the vehicle settings
menu in the touch screen.
3

79
The sidelamps and dipped beam headlamps are
switched on automatically, without any action
on the part of the driver, when a low level of
ambient light is detected or in certain cases of
activation of the windscreen wipers.
As soon as the brightness returns to a sufficient
level or after the windscreen wipers are switched
off, the lamps are switched off automatically.
AUTO mode
On
F Turn the ring to the "AUTO" position.
Activation of the function is accompanied
by a message in the screen.
Off
F Turn the ring to another position. Deactivation of the function is
accompanied by a message in the screen.
Automatic guide-me-home
lighting
Association with the automatic lighting provides
the guide-me-home lighting with the following
additional options:
-

s
election of the lighting duration of 15, 30
or 60 seconds,
-

a
utomatic activation of guide-me-home
lighting when the automatic illumination of
headlamps is in operation. In the event of a fault with the
sunshine sensor, the lighting comes
In fog or snow, the sunshine sensor
may detect sufficient light. In this
case, the lighting will not come on
automatically.
Do not cover the sunshine sensor,
coupled with the rain sensor and
located in the centre of the windscreen
behind the rear view mirror; the
associated functions would no longer
be controlled.
Configuration
Press "MENU" to display the "MAIN
MENU" .
Select "Driving" .
Select "Secondary page" .
Select the "Driving assistance" tab.
Activate the "Guide me home"
function. Select "Vehicle settings" .Switching off
Switching on Deactivate the "Guide me home"

function.
on, this warning lamp is displayed in the
instrument panel and/or a message appears in
the screen, accompanied by an audible signal.
Contact a PEUGEOT dealer or a qualified
workshop.
4
Lighting and visibility

83
Daytime running lamps
Daytime lighting, compulsory in certain
countries, which comes on automatically when
the engine is started making the vehicle more
visible to other users.
LED lamps
They come on when the engine is started.
Depending on the country of sale, they are
used for:
-
d
aytime running lamps* in day mode and
sidelamps in night mode (they are brighter
when daytime running lamps),
or
-

s
idelamps in day and night mode.
*

F
unction that can be set in the vehicle
configuration menu. This function is assured:
-

i
n countries where it is imposed by
regulations,
b
y illumination of the dipped beam
headlamps with the sidelamps and number
plate lamps; this function cannot be
deactivated.
- f or other countries where it is provided, b
y the use of dedicated lamps (bulbs or
LEDs); this function can be activated or
deactivated via the vehicle configuration
menu.
The lighting control stalk must be placed in
the
"0"

or "AUTO" (day mode) position.
Deactivation of the daytime running lamps is
effective after operation of the lighting control
stalk or after the next engine start; activation is
effective immediately. The instruments and controls (instrument
panel, multifunction screen, air conditioning
control panel, ...) are not illuminated, except
in night mode with manual or automatic
illumination of headlamps.
4
Lighting and visibility