
Access47
208_en_Chap02_ouvertures_ed01-2016
Reinitialisation
Always remove the key when leaving
the vehicle, even for a short time.
In the event of contact during operation
of the windows, you must reverse the
movement of the window. To do this,
press the switch concerned.
When operating the passenger electric
window controls, the driver must ensure
that no one prevents the correct closing
of the windows.
The driver must ensure that passengers
use the electric windows correctly.
Be aware of children when operating
the windows.Advice
Inhibition
For the safety of your children, press
the control to prevent operation
of the windows of the rear doors,
irrespective of their position.
With the warning lamp on, the rear switches
are deactivated. With the warning lamp off, the
switches are active. Following reconnection of the battery, the
safety anti-pinch function must be reinitialised.
The safety anti-pinch is not active during these
operations:
-
l
ower the window completely, then raise
it; it will rise in steps of a few centimetres
each time the switch is pressed. Repeat
the operation until the window closes
completely,
-
p
ress and hold the switch upwards for at
least 1 second after reaching this position,
window closed.
2

Ease of use and comfort
68
208_en_Chap03_ergonomie-confort_ed01-2016
Courtesy lamp
In this position, the lighting
comes on gradually:
-
w
hen the vehicle is unlocked,
-
w
hen the key is removed from the ignition,
-
w
hen opening a door,
-
w
hen unlocking with the remote control.
It goes off gradually:
-
w
hen the vehicle is locked,
-
w
hen the ignition is switched on,
-
3
0 seconds after the last door is closed. Permanently off.
Permanent lighting. F
W ith the ignition on, press
the corresponding switch.
1.
C
ourtesy lamp
2.
M
ap reading lamp s
With the "permanent lighting" mode, the lighting
time varies according to the circumstances:
- with the ignition off, approximately
10
minutes,
- in energy economy mode, approximately
30 seconds,
- with the engine running, unlimited.
Map reading lamps
Take care to avoid leaving anything in
contact with the courtesy lamp.

Safety97
208_en_Chap05_securite_ed01-2015
Deactivation
When the ignition is on, this warning
lamp comes on in the instrument
panel while the airbag is deactivated.
To assure your child's safety, you
must deactivate the passenger's front
airbag when you install a rear ward
facing child seat on the front passenger
seat. Otherwise, the child risks being
seriously injured or killed if the airbag is
deployed.
Reactivation
When you remove the rear ward facing child
seat, with the ignition on , turn the switch to
the "ON" position to reactivate the airbag and
so assure the safety of your front passenger in
the event of an impact.
Operating fault
If this warning lamp comes on in the
instrument panel, you must contact
a PEUGEOT dealer or a qualified
workshop without delay to have the
system checked. The airbags may no
longer be deployed in the event of a
serious impact.
Only the passenger's front airbag can be
deactivated.
F
W
ith the ignition off
, insert the key into
the passenger airbag deactivation switch.
F
T
urn it to the "OFF"
position,
F
R
emove the key keeping the switch in the
new position.
5

Safety
102
208_en_Chap05_securite_ed01-2015
Deactivating the passenger's
front airbag
Never install a rear ward facing child
restraint system on a seat protected by
an active front airbag. This could cause
the death of the child or serious injury.Passenger airbag OFF
The warning label present on both sides of the
passenger's sun visor repeats this advice. In
line with current legislation, the following tables
contain this warning in all of the languages
required. Only the passenger's front airbag can be
deactivated.
F
W
ith the ignition off, introduce the key into
the passenger airbag deactivation switch.
F
T
urn it to the "OFF" position.
F R emove the key, leaving the switch in this
position.
When the ignition is on, this warning
lamp comes on in the instrument
panel and stays on while the airbag is
deactivated.

Safety113
208_en_Chap05_securite_ed01-2015
The incorrect installation of a child seat in a
vehicle compromises the child's protection in
the event of an accident.
Ensure that there is no seat belt or seat belt
buckle under the child seat, as this could
destabilise it.
Remember to fasten the seat belts or the
child seat harnesses keeping the slack
relative to the child's body to a minimum,
even for short journeys.
When installing a child seat using the seat
belt, ensure that the seat belt is tightened
correctly on the child seat and that it secures
the child seat firmly on the seat of your
vehicle. If your passenger seat is adjustable,
move it for wards if necessary.
At rear seating positions, always leave
sufficient space between the front seat and:
-
a r
ear ward facing child seat,
-
t
he child's feet for a child seat fitted
forward facing.
To do this, move the front seat for wards
and, if necessary, move its backrest into the
upright position.
Advice
Children at the front
For optimum installation of the forward facing
child seat, ensure that the back of the child
seat is as close as possible to the backrest
of the vehicle's seat, in contact if possible.
You must remove the head restraint before
installing a child seat with backrest to a
passenger seat.
Ensure that the head restraint is stored or
attached securely to prevent it from being
thrown around the vehicle in the event of
sharp braking. Refit the head restraint when
the child seat is removed.
The legislation on carrying children on the
front passenger seat is specific to each
country. Refer to the legislation in force in
your country.
Deactivate the passenger's front airbag
when a rear ward facing child seat is installed
on the front passenger seat.
Otherwise, the child risks being seriously
injured or killed if the airbag is deployed.Installing a booster seat
The chest part of the seat belt must be
positioned on the child's shoulder without
touching the neck.
Ensure that the lap part of the seat belt
passes correctly over the child's thighs.
PEUGEOT recommends the use of a booster
seat which has a back, fitted with a seat belt
guide at shoulder level.
As a safety precaution, do not leave:
-
a c
hild or children alone and
unsupervised in a vehicle,
-
a c
hild or an animal in a vehicle which
is exposed to the sun, with the windows
closed,
-
t
he keys within reach of children inside
the vehicle.
To prevent accidental opening of the doors
and rear windows, use the child lock.
Take care not to open the rear windows by
more than one third.
To protect young children from the rays of
the sun, fit side blinds on the rear windows.
5

Safety
114
208_en_Chap05_securite_ed01-2015
Electric operation
Electric system, with the control located at the
front, for locking the rear doors so that they
cannot be opened using their interior controls.
Switching on
F With the ignition on, press this button.
The indicator lamp in the button comes on,
accompanied by a message to confirm that the
child lock is on.
This indicator lamp remains on until the child
lock is switched off.
It is still possible to open the doors from the
outside and operate the rear electric windows
from the driver's control panel.
Switching off
Any other status of the indicator lamp
indicates a fault with the electric child
lock.
Have it checked by a PEUGEOT dealer
or a qualified workshop.
This system is independent and in no
circumstances does it take the place of
the central locking control.
Check the state of the child lock every
time you switch on the ignition.
Always remove the key from the ignition
when leaving the vehicle, even for a
short time.
Child lock
Mechanical system to prevent opening of a rear
door using its interior lever.
The control is located on the edge of each rear
d o o r.
Locking
F Using the ignition key, turn the red control as far as it will go:
-
t
o the left on the left-hand rear door,
-
t
o the right on the right-hand rear door.
Manual operation
F With the ignition on, press this button again.
The indicator lamp in the button goes off,
accompanied by a message to confirm that the
child lock is off.
This indicator lamp remains off while the child
lock is switched off.
Unlocking
F Using the ignition key, turn the red control as far as it will go:
-
t
o the right on the left-hand rear door,
-
t
o the left on the right-hand rear door.

Driving
118
208_en_Chap06_conduite_ed01-2016
Starting
Gearbox Ignition
Avoid attaching heavy objects to the
key or the remote control, which would
weigh down on its blade in the ignition
switch and could cause a malfunction.
It could adversely affect the deployment
of the front airbag.
The original key contains a coded electronic chip.
When the ignition is switched on, starting is only
possible if the code is detected and recognised.
This protection against theft locks the engine
management system a few moments after the
ignition is switched off and prevents starting of
the engine following a break-in.
Electronic engine immobiliser
Keep away from your vehicle, the
label attached to the keys given to you
on acquisition of the vehicle. It will
help in finding the original code for
replacement of the key.
In the event of a fault, you are informed
by illumination of the warning lamp, an
Manual
F Place the gear lever in neutral.Advice
Automatic
F Place the gear lever at position P or N .
Electronic
F Place the gear lever at position N.
Steering wheel
In some cases, you may have to apply
some force to turn the steering (if the
wheels are on lock against a kerb, for
example).
Starting
F Insert the key into the ignition switch. T
he system recognises the starting code.
F
U
nlock the steering column by
simultaneously turning the steering wheel
and the key.
F
T
urn the key towards the dashboard to
position 3 (Starting) .
F
W
hen the engine starts, release the key. audible signal and the display of a message.
In this case, your vehicle will not start; contact a
PEUGEOT dealer as soon as possible.

Driving
120
208_en_Chap06_conduite_ed01-2016
Switching off
Ignition
Key left in the "Ignition on" position
On opening the driver's door, an alert
message is displayed, accompanied
by an audible signal, to remind you that
the key is still in the ignition switch at
position 1 (Stop) .
If the key has been left in the ignition
switch at position 2 (Ignition on) ,
the ignition will be switched off
automatically after one hour.
To switch the ignition back on, turn the
key to position 1 (Stop) , then back to
position 2 (Ignition on) .
Coasting
As a safety measure, do not coast (free-wheeling
in neutral or with the clutch pedal depressed).
Switching off the engine leads to a loss
of braking assistance.
Gearbox
Manual
F Place the gear lever in neutral.
F
Imm obilise the vehicle.
F
A
pply the parking brake.
F
T
urn the key towards you to position 1
(Stop) .
F
R
emove the key from the ignition switch.
Electronic
F Place the gear lever at position N .
F Imm obilise the vehicle.
F
A
pply the parking brake.
F
T
urn the key towards you to position 1
(Stop) .
F
R
emove the key from the ignition switch.
Automatic
F Place the gear lever at position P or N .
F Imm obilise the vehicle.
F
A
pply the parking brake.
F
T
urn the key towards you to position 1
(Stop) .
F
R
emove the key from the ignition switch.
Steering wheel
To facilitate unlocking of the steering
wheel, it is recommended that you
place the wheels in the straight ahead
position before switching off the engine.