Page 203 of 341

201
208_en_Chap08_Informations-pratiques_ed01-2015
Under-inflation alert
The loss of pressure detected does not 
always cause visible bulging of the tyre. 
Do not satisfy yourself with just a visual 
check.This is given by fixed illumination of 
this warning lamp, accompanied by 
an audible signal and, depending on 
equipment, the display of a message.
F  Reduce speed immediately, avoid 
excessive steering movements and sudden 
braking
F  Stop the vehicle as soon as it is safe  
to do so. F 
In the event of a puncture, use the 
temporary puncture repair kit or the spare 
wheel (depending on equipment),
or
F  if you have a compressor, such as the one 
in the temporary puncture repair kit, check 
the pressures of the four tyres when cold,
or
F  if it is not possible to make this check 
immediately, drive carefully at reduced 
speed. The alert is maintained until the system 
is reinitialised.
The under-inflation alert is only 
dependable if the system has been 
reinitialised with all four tyres inflated to 
the correct pressures.
Snow chains
The system does not have to be 
reinitialised after fitting or removing 
snow chains.
8 
Practical information  
     
        
        Page 225 of 341
223
208_en_Chap9b_SMEGplus_ed01-2015
7-inch touch screen
GPS satellite navigation - Multimedia audio - Bluetooth® telephone
Contents
First steps  224
Steering mounted controls  226
Menus  227
Navigation  228
Navigation - Guidance  236
Tr a f fi c 	 2 4 0
Radio Media  242
Radio 248
DAB (Digital Audio Broadcasting) radio  250
Media  252
Settings  256
Internet   264
Internet browser   265
MirrorLink
TM  268
Telephone  270
Frequently asked questions  278
The system is protected in such a way that it will only operate in 
your vehicle. As a safety measure, the driver should only carry out operations 
which require prolonged attention while the vehicle is stationary.
The display of the energy economy mode message signals 
that the system is about to go into standby. Refer to the Energy 
economy (mode) section.
9 
Audio and Telematics  
     
        
        Page 228 of 341
226
208_en_Chap9b_SMEGplus_ed01-2015
Steering mounted controls
Press: mute on / off.
Increase volume.
Change audio source: radio, media.Radio, rotate: automatic search for 
the previous / next station.
Radio, press: preset stations.
Media, rotate: previous / next track.
Press: confirm a selection.
Decrease volume. Telephone: start or answer a call.
Call in progress: telephone menu 
(end call, secret mode, hands-free 
m o d e).
Telephone, press and hold: reject an 
incoming call, end a call in progress; 
other than call in progress, telephone 
menu.
Radio: display the list of stations.
Media: display the list of tracks.
Radio, press and hold: update the list 
of stations received. 
Audio and Telematics  
     
        
        Page 254 of 341

252
208_en_Chap9b_SMEGplus_ed01-2015
Media
USB playerSelection of source
The steering mounted SRC (s o u r c e) 
button can be used to go to the next 
media source, available if the source 
is active. Select change of source. Press on Media  to display the 
primary page.
The system builds playlists (in temporary 
memory), an operation which can take from 
a few seconds to several minutes at the first 
connection.
Reduce the number of non-music files and the 
number of folders to reduce the waiting time.
The playlists are updated every time the 
ignition is switched off or connection of a USB 
memory stick. The lists are memorised: if they 
are not modified, the subsequent loading time 
will be shorter.
Insert the USB memory stick into the USB port 
or connect the USB device to the USB port 
using a suitable cable (not supplied).
Auxiliary socket (AUX)
Connect the portable device (MP3 player…) to 
the auxiliary Jack socket using an audio cable 
(not supplied).
First adjust the volume of your portable device 
(to a high level). Then adjust the volume of your 
audio system.
Display and management of the controls are 
via the portable device.
Choose the source.
CD player
Insert the CD in the player.
Press OK to confirm the selection. 
Audio and Telematics  
     
        
        Page 278 of 341

276
208_en_Chap9b_SMEGplus_ed01-2015
Managing paired 
telephones
This function allows the connection or 
disconnection of a peripheral device as 
well as the deletion of a pairing.Using the telephone is not 
recommended while driving.
Park the vehicle.
Make the call using the steering 
mounted controls.
Press on Telephone
 to display the 
primary page.
Press on the secondary page.
Select " Bluetooth " to display the list 
of paired peripheral devices.
Select the peripheral in the list. Select "Search for devices "
Or "Connect / Disconnect " to start or 
end the Bluetooth connection with 
the selected device.
Or "Delete " to delete the pairing.
Receiving a call
An incoming call is announced by a ring and a 
superimposed display in the screen.
Make a short press on the steering 
mounted TEL  button to accept an 
incoming call.
Make a long press
on the steering mounted TEL  button 
to reject the call.
Or Select "End call".
Making a call
Calling a new number
Press on Telephone  to display the 
primary page.
Enter the phone number using the 
digital keypad.
Press " Call" to start the call.
Calling a contact
Press on Telephone  to display the 
primary page.
Or make a long press
on the steering mounted TEL  button. 
Audio and Telematics  
     
        
        Page 282 of 341

280
208_en_Chap9b_SMEGplus_ed01-2015
Radio
QUESTIONANSWER SOLUTION
The quality of reception of 
the radio station listened 
to gradually deteriorates 
or the stored stations do 
not function (no sound, 
87.5 Mhz is displayed...). The vehicle is too far from the transmitter used by the station 
listened to or there is no transmitter in the geographical area 
through which the vehicle is travelling.
Activate the "RDS" function by means of the 
short-cut menu to enable the system to check 
whether there is a more power ful transmitter in 
the geographical area.
The environment (hills, buildings, tunnels, basement car parks...) 
block reception, including in RDS mode. This phenomenon is normal and does not 
indicate a fault with the audio system.
The aerial is absent or has been damaged (for example when going 
through a car wash or into an underground car park). Have the aerial checked by a PEUGEOT dealer.
I cannot find some radio 
stations in the list of 
stations received. The station is not received or its name has changed in the list.
Press and hold the "List" button at the steering 
mounted controls to update the list of stations 
received or press on the system update function: 
"Update list".
Some radio stations send other information in place of their name 
(the title of the song for example).
The system interprets this information as the name of the station.
The name of the radio 
station changes. 
Audio and Telematics  
     
        
        Page 289 of 341
287
208_en_Chap9c_RDE2_ed01-2015
Audio system / Bluetooth®
Contents
First steps  288
Steering mounted controls  289
Radio 290
Media 292
Telephone  296
Audio settings   299
Configuration	 300
Screen menu map(s)  301
Frequently asked questions  302
As a safety measure, the driver must only carry out operations 
which require prolonged attention while the vehicle is stationary.
When the engine is switched off and to prevent discharging of 
the battery, the system switches off after activation of energy 
economy mode.
9 
Audio and Telematics  
     
        
        Page 291 of 341
289
208_en_Chap9c_RDE2_ed01-2015
Steering mounted controls
Radio: select the previous / next 
preset station.
CD / USB: select the genre / 
artist / folder / playlist from the list 
depending on classification.
Select the previous / next item in a 
menu.Volume decrease.
Radio: automatic search for a higher 
frequency.
CD / MP3 / USB: select the next 
track.
CD / USB: press and hold: fast 
forward.
Mute: cut the sound by 
simultaneously pressing the volume 
increase and decrease buttons.
Restore the sound: by pressing one 
of the two volume buttons. Radio: automatic search for a lower 
frequency.
CD / MP3 / USB: select the previous 
track.
CD / USB: press and hold: fast back.
Change the audio sound.
Confirm a selection.
Start /end call with the telephone.
Press and hold: access to the 
call log. Volume increase.
9 
Audio and Telematics