X
Unscrew and remove oil filler cap 0043with
the integrated dipstick.
X Wipe the oil dipstick.
X Screw on oil filler cap 0043againtot he stop.
X Unscrew oil filler cap 0043againa nd read the
dipstick.
If the level is between MIN mark 0087and
MAX mark 0044,the oil level is correct.
X If the oil level has dropped to MIN mark 0087
or below,a dd 1.1 US qt (1. 0liter )engine oil.
Adding engineo ilG
WARNING
Certain componentsint he engine compart-
ment, such as the engine, radiator and parts
of the exhaust system, can become very hot.
Working in the engine compartment poses a
risk of injury.
Where possible,l et the engine cool down and
touch only the componentsd escribed in the
following. G
WARNING
If engine oil comes into contact with hot com- ponents in the engine compartment,itm ay
ignite. There is arisk of fire and injury.
Make sure that engine oil is not spilledn ext to
the filler neck. Let the engine cool down and
thoroughly clean the engine oil off the com-
ponents before starting the engine. H
Environmental note
When adding oil, take care not to spill any. If
oil enters the soil or waterways, it is harmful to the environment.
! Only use engine oils and oil filters that
have been approved for vehicles with a
service system. You can obtain alist of the
engine oils and oil filters tested and
approved in accordance with the
Mercedes-Benz Specifications for Service
Products at any Mercedes-Benz Service
center. Damage to the engine or exhaust system is
caused by the following:
R using engine oils and oil filters that have
not been specificallya pproved for the
service system
R replacing engine oil and oil filters after
the interval for replacement specified by
the service system has been exceeded
R using engine oil additives.
! Do not add too much oil. adding too much
engine oil can result in damage to the
engine or to the catalytic converter. Have
excess engine oil siphoned off. X
Unscrew and remove oil filler cap 0043with
the integrated dipstick.
X Add engine oil.
If the oil level is at or below the MIN mark on
the oil dipstick, add 1.1 US qt (1.0 l)of
engine oil.
X Replace cap 0043on the filler neck and
tighten clockwise.
Ensure that the cap locks into place
securely.
X Check the oil level again with the oil dip-
stick (Y page 219).
You will find further information about engine
oil in the "Technical data" section
(Y page 283). 220
Engine compartmentMaintenance and care
engin
eoils and oil filters that are approved for
vehicles with maintenanc esystems.
For alist of approved engin eoils and oil filters,
consult an authorized Mercedes-Benz
Center .Orvisit the website
http://bevo.mercedes-benz.com.
The table shows which engine oils have been
approved for your vehicle. MB sheet number
229.5
7 i
MB approval is indicated on the oil con-
tainers.
Filling capacities The following values refer to an oil change
including the oil filter.
Engine with oil filter
10.0USq
t(9.5l) Ad
ditives !
Do not us
eany additive sinthe engine oil.
Thi scould damag ethe engine.
Engine oi lviscosity Viscosity describe
sthe flo wcharacteristics
of afluid .Ifane ngine oi lhas ah ighv iscosity,
this means tha titisthick; alow viscosity
means tha titisthin.
Select an engine oi lwithanS AE classification
(viscosity )suitabl efor the prevailing outside
temperatures. The table shows yo uwhich
SAE classifications are to be used .The low- temperature characteristics of engine oils
can deteriorate significantly, e.g. as
aresult
of aging, soo tand fue ldep osits. It is therefore
strongly recommended tha tyou carr youtreg-
ular oi lchanges using an approved engine oil
with the appropriate SAE classification. Refrigerant of the air-conditioning
system
Important safety notes Type of refrigerant
The climate control system of your vehicl
eis
fille dwithr efrigerant R ‑134a.
The instruction labe lregarding the refrigerant
typ eusedc an be found on the radiator cross
member.
Refrigerant R‑ 134a
! Only the refrigerant R‑134a and the PAG
oi la pp roved by Mercedes-Benz may be
used .The approved PAG oi lmay not be
mixe dwitha ny othe rPAG oi ltha tisn ot
approved for R-134a refrigerant. Other-
wise, the climate control system may be
damaged.
Service work, such as topping-u prefrigerant
or replacing components ,may only be carried
ou tb yaq ualified specialist workshop. All
applicabl eregulations mus tbea dhered to,
SAE standard J63 9included.
Alway shavew orkont he climate control sys-
tem carrie doutataq uali fied specialist work-
shop.
7 Restriction: only us eSAE 0W-40/SAE 5W-40 engine oils. 284
Servic
eproducts and filling capacitiesTechnical data
