2015 MAZDA MODEL CX-3 key

6–40
Maintenance and Care
Owner Maintenance
2. Twist a tape-wrapped fl athead
screwdriver in the direction of the
arrow and open the cover slightly.
Cover
3. Insert the tape-wrapped fl athead
screwdriver into the gap and slide it in
the direction of the arrow.
Cover
Gap
4. Twist the fl athead screwdriver in the
direction of the arrow and remove the
cover.
Cover
5. Remove the battery cap, then remove
the battery.
6. Insert a new battery with the positive
pole facing up, and then cover the
battery with the battery cap.
7. Close the cover.
8. Reinsert the auxiliary key.
$9@&;&&%@&EJUJPOJOEC







*Some models.7–41
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
Signal Warning
(Flashing)
Tyre Pressure
Monitoring System
Warning Light
*
If the tyre pressure monitoring system has a malfunction, the tyre pressure warning
light fl ashes for about 1 minute when the ignition is switched ON and then continues
illuminating. Have your vehicle checked by an expert repairer, we recommend an
Authorised Mazda Repairer as soon as possible.
WARNING
If the tyre pressure monitoring system warning light illuminates or fl ashes, or the tyre
pressure warning beep sound is heard, decrease vehicle speed immediately and avoid
sudden manoeuvring and braking:
If the tyre pressure monitoring system warning light illuminates or fl ashes, or the
tyre pressure warning beep sound is heard, it is dangerous to drive the vehicle at high
speeds, or perform sudden manoeuvring or braking. Vehicle drivability could worsen
and result in an accident.
To determine if you have a slow leak or a fl at, pull over to a safe position where you
can check the visual condition of the tyre and determine if you have enough air
to proceed to a place where air may be added and the system monitored again by
an expert repairer, we recommend an Authorised Mazda Repairer or a tyre repair
station.
Do not ignore the TPMS Warning Light: Ignoring the TPMS warning light is dangerous, even if you know why it is
illuminated. Have the problem taken care of as soon as possible before it develops
into a more serious situation that could lead to tyre failure and a dangerous accident.
(Red)
(Illuminate)
KEY Warning Light If any malfunction occurs in the keyless entry system, it illuminates continuously.
CAUTION
If the key warning indicator light illuminates or the push button start indicator light
(amber) fl ashes, the engine may not start. If the engine cannot be started, try starting it
using the emergency operation for starting the engine, and have the vehicle inspected at
an expert repairer, we recommend an Authorised Mazda Repairer as soon as possible.
Refer to Emergency Operation for Starting the Engine on page 4-11 .
$9@&;&&%@&EJUJPOJOEC







*Some models.7–47
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
Signal Warning Action to be taken
(Amber)
Smart Brake
Support/Smart
City Brake Support
(SBS/SCBS)
Warning Light
*
The light turns on if the windscreen or the
radar sensor are dirty, or there is a malfunction
in the system.
(Vehicles with type C/type D audio)
Verify the reason why the warning light
is illuminated on the centre display (page
7-35 ).
If the reason why the warning light is
illuminated is due to a dirty windscreen,
clean the windscreen.
If the warning light is illuminated because
of a dirty radar sensor, clean the front
emblem.
For any other reasons, have the vehicle
inspected at an expert repairer, we
recommend an Authorised Mazda Repairer.
(Vehicles without type C/type D audio)
If the reason why the warning light is
illuminated is due to a dirty windscreen,
clean the windscreen. For any other
reasons, have the vehicle inspected at
an expert repairer, we recommend an
Authorised Mazda Repairer.
KEY Warning Light
Take the appropriate action and verify that the warning light turns off.
Signal Cause Action to be taken
(Red)
(Flashing) The advanced key battery is dead. Replace the key battery (page 6-39 ).
The advanced key is not within the
operation range.
Bring the advanced key into the operation
range (page 3-7 ). The advanced key is placed in areas inside
the cabin where it is diffi cult for the key to
be detected.
A key from another manufacturer similar to
the advanced key is in the operation range. Take the key from another manufacturer
similar to the advanced key out of the
operation range.
Without the ignition switched off, the
advanced key is taken out of the cabin, and
then all the doors are closed. Bring the advanced key back into the
cabin.
$9@&;&&%@&EJUJPOJOEC







*Some models.7–51
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
NOTE

 Placing heavy items on the front
passenger seat may cause the front
passenger seat belt warning function
to operate depending on the weight
of the item.
  To allow the front passenger seat
weight sensor to function properly,
do not place and sit on an additional
seat cushion on the front passenger
seat. The sensor may not function
properly because the additional
seat cushion could cause sensor
interference.
  When a small child sits on the front
passenger seat, it is possible that the
warning beep will not operate.
Rear seat
*
The warning beep only sounds if a seat
belt is unfastened after being fastened.
Ignition Not Switched Off (STOP)
Warning Beep
If the driver's door is opened while
the ignition is switched to ACC, a
continuous beep sound will be heard to
notify the driver that the ignition has not
been switched off (STOP). Left in this
condition, the keyless entry system will
not operate, the car cannot be locked, and
the battery power will be depleted.
Key Removed from Vehicle
Warning Beep
A beep sound will be heard 6 times and
the KEY warning light (red) will fl ash
continuously if the ignition has not been
switched off, all the doors are closed, and
the key is removed from the vehicle. This
is to notify the driver that the key has been
removed from the vehicle and the ignition
has not been switched off.
NOTE
Because the key utilizes low-intensity
radio waves, the Key Removed From
Vehicle Warning may activate if the key
is carried together with a metal object
or it is placed in a poor signal reception
area.
Request Switch Inoperable
Warning Beep (With the advanced
keyless function)
If the request switch is pressed with a door
open or ajar or the ignition has not been
switched off while the key is being carried,
a beep will be heard for about 2 seconds
to indicate that the doors and the liftgate
cannot be locked.
$9@&;&&%@&EJUJPOJOEC







*Some models.7–52
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
Key Left-in-luggage Compartment
Warning Beep (With the advanced
keyless function)
If the key is left in the luggage
compartment with all doors locked
and the liftgate closed, a beep sound is
heard for about 10 seconds to remind
the driver the key has been left in the
luggage compartment. If this happens,
open the liftgate by pressing the electric
liftgate opener and remove the key. A key
removed from the luggage compartment
may not function because its functions
may have been temporarily suspended.
To restore the key function, perform the
applicable procedure (page 3-7 ).
Key Left-in-vehicle Warning Beep
(With the advanced keyless
function)
If a key is left in the vehicle cabin and all
the doors and the luggage compartment
are locked using a separate key, a beep
sound is heard for about 10 seconds to
remind the driver that the key has been
left in the vehicle cabin. If this happens,
open the door and remove the key. A key
removed from the vehicle this way may
not function because its functions may
have been temporarily suspended. Perform
the applicable procedure to restore the
functions of the key (page 3-7 ).
i-stop Warning Beep *
















 If the driver's door is opened while
engine idling is stopped, the warning
sound operates to notify the driver that
engine idling is stopped. It stops when
the driver's door is closed.
 


 The warning sound operates if the
following operations are performed
while the engine idling is stopped. In
such cases, the engine does not restart
automatically to ensure safety. Start the
engine using the normal method.
 

 
(European model)
 The driver's seat belt is unfastened and
the driver's door is opened.
 

 
(Except European model)



 
(Manual transaxle)
 With the shift lever in a position other
than neutral, the driver's seat belt is
unfastened and the driver's door is
opened.
 

 
(Automatic transaxle)
 With the selector lever in the D or
M (not in second gear fi xed mode)
position, the driver's seat belt is
unfastened and the driver's door is
opened.
Vehicle Speed Alarm *
The vehicle speed alarm function is
designed to alarm the driver via a single
beep sound and a warning indication in the
instrument cluster that the previously set
vehicle speed has been exceeded.
You can change the vehicle speed setting
at which the warning is triggered (page
4-31 ).
$9@&;&&%@&EJUJPOJOEC







8–6
Customer Information
Declaration of Conformity
Declaration of Conformity
Keyless Entry System/Immobilizer System
$9@&;&&%@&EJUJPOJOEC







9–15
Specifi cations
Personalisation Features
Item Feature Factory
Setting Available
Settings Settings change method
Safety
Distance
Recognition
Support
System
(DRSS)
Refer to
Distance
Recognition
Support
System
(DRSS) on
page 4-118 . The system can be
changed so that
Distance Recognition
Support System
(DRSS) does not
operate.
*1
On On/Off Refer to
Settings
on page
5-65 . —
The distance at which
the vehicle ahead
indicator in the display
fl ashes can be changed. Near Far/Medium/
Near Refer to
Settings
on page
5-65 . —
Vehicle Power door
lock
Refer to
Auto Lock/
Unlock
Function
on page
3-16 . Changes the auto
lock/unlock function
setting for all the
doors according to
the vehicle speed, the
vehicle power supply
condition, and the
selector lever position. Lock:
When
Driving
Unlock:
IGN Off Lock: When
Driving
Unlock: In
Park/
Lock: Out of
Park Unlock:
In Park/
Lock: Shifting
Out of Park/
Lock: When
Driving
Unlock: IGN
Off/
Lock: When
Driving/
Off
Refer to
Settings
on page
5-65 . Refer to
Auto Lock/
Unlock
Function
on page
3-16 .
Keyless
entry
system
Refer to
Keyless
Entry
System on
page 3-3 . The time required for
the doors to relock
automatically after
unlocking with the
transmitter can be
changed. 30 seconds 90 seconds/
60 seconds/
30 seconds
Refer to
Settings
on page
5-65 . —
$9@&;&&%@&EJUJPOJOEC







9–16
Specifi cations
Personalisation Features
Item Feature Factory
Setting Available
Settings Settings change method
Vehicle Advanced
keyless
entry
system
Refer to
Advanced
Keyless
Entry
System on
page 3-8 . The
volume of
the answer-
back beep
during
advanced
keyless
entry
system
operation
can be
changed. European
models Off
High/
Medium/
Low/
Off
Refer to
Settings
on page
5-65 .
Refer to
Locking,
Unlocking
with
Request
Switch
(With the
advanced
keyless
function)
on page
3-13 .
Except
European
models Medium
The function to
automatically lock the
doors when leaving the
vehicle while carrying
the key can be changed. Off On/Off
Refer to
Settings
on page
5-65 . —
The time required
for the doors to
relock automatically
after unlocking with
the request switch/
transmitter can be
changed. 30 seconds 90 seconds/
60 seconds/
30 seconds
Refer to
Settings
on page
5-65 . —
Illumination
entry
Refer to
Illuminated
Entry
System on
page 5-147 .
The time required for
the interior lamp to turn
off automatically can
be changed (prevents
battery depletion when
a door is open/ajar). 30 minutes 60 minutes/
30 minutes/
10 minutes
Refer to
Settings
on page
5-65 . —
The time required for
the interior lamp to turn
off automatically after
all doors are closed can
be changed. 15 seconds 60 seconds/
30 seconds/
15 seconds/
7.5 seconds Refer to
Settings
on page
5-65 . —
Auto-wiper
control
Refer to
Windscreen
Wipers and
Washer on
page 4-68 .
The auto-wiper control
function can be
changed. On On/Off *4 Refer to
Settings
on page
5-65 . —
$9@&;&&%@&EJUJPOJOEC