2015 MAZDA MODEL 3 HATCHBACK ECO mode

*Some models.4–104
When Driving
i-ACTIVSENSE
High Beam Control System (HBC) *
The High Beam Control System (HBC) determines the conditions in front of the vehicle
using the Forward Sensing Camera (FSC) while driving in darkness to automatically switch
the headlights between high and low beams.
Refer to Warning/Indicator Lights on page 4-40 .
While driving the vehicle at a speed of about 30 km/h (18 mph), the headlights are switched
to high beams when there are no vehicles ahead or approaching in the opposite direction.
The system switches the headlights to low beams when one of the following occurs:
 


 The system detects a vehicle or the headlights/lights of a vehicle approaching in the
opposite direction.
 


 The vehicle is driven on roads lined with streetlamps or on roads in well-lit cities and
towns.
 


 The vehicle is driven at less than about 20 km/h (12 mph).
Forward Sensing
Camera (FSC) The recognition distance of the
Forward Sensing Camera (FSC)
varies according to the
surrounding conditions.
The warning light fl ashes when the system has a malfunction.
Refer to Warning Lights on page 4-41 .
CAUTION
  Do not adjust the vehicle height, modify the headlight units, or remove the camera,
otherwise the system will not operate normally.
 



 Do not rely excessively on the High Beam Control System (HBC) and drive the
vehicle while paying suffi cient attention to safety. Switch the headlights between the
high beams and low beams manually if necessary.
.B[EB@&'&&"@&EJUJPOJOEC







*Some models.4–120
When Driving
i-ACTIVSENSE
Distance Recognition Support System (DRSS) *
The Distance Recognition Support System (DRSS) measures the distance between your
vehicle and a vehicle ahead using a radar sensor while the vehicle speed is 30 km/h or faster
(19 mph or faster), and indicates a recommended distance to maintain between the vehicles.
Furthermore, if your vehicle approaches a vehicle ahead more closely than the appropriate
distance to maintain between the vehicles, the vehicle-ahead indication in the display is
fl ashed to advise the driver to keep a safer distance from the vehicle ahead.
WARNING
Do not rely completely on the Distance Recognition Support System (DRSS) and always
drive carefully:
The Distance Recognition Support System (DRSS) provides advice for safer driving and
notifi es the driver of a recommended, safer distance to maintain with a vehicle ahead.
The ability to detect a vehicle ahead is limited depending on the type of vehicle ahead,
the weather conditions, and the traffi c conditions. Therefore, if the accelerator and
brake pedals are not operated correctly it could lead to an accident. Always verify the
safety of the surrounding area and depress the brake pedal or accelerator pedal while
keeping a safer distance from vehicles ahead or on-coming vehicles.
NOTE
  The Distance Recognition Support System (DRSS) operates when all of the following
conditions are met:
 


 The ignition is switched ON.



 The Distance Recognition Support System (DRSS) is on.



 The selector lever is in a position other than reverse (R).



 The vehicle speed is 30 km/h or faster (19 mph or faster). 

 The objects which activate the system are 4-wheeled vehicles. 
 The Distance Recognition Support System (DRSS) may also operate in the presence of
motorcycles and bicycles.
  The Distance Recognition Support System (DRSS) system may not operate normally
under the following conditions:
 


 The Dynamic Stability Control (DSC) has a malfunction.



 The vehicle ahead is travelling at an extremely slow speed. 

 The system does not operate with the following objects:




 Vehicles approaching in the opposite direction.



 Stationary objects (stopped vehicles, obstructions)
.B[EB@&'&&"@&EJUJPOJOEC







*Some models.4–150
When Driving
i-ACTIVSENSE
Radar Sensor (Front) *
Your vehicle is equipped with a radar sensor (front).
The following systems also use the radar sensor (front).
 


 Smart Brake Support (SBS)



 Mazda Radar Cruise Control (MRCC)



 Distance Recognition Support System (DRSS)
The radar sensor (front) functions by detecting the radio waves refl ected off a vehicle ahead
or an obstruction sent from the radar sensor (front).
The radar sensor (front) is mounted behind the front emblem.
Radar sensor (front)
If the Smart Brake Support (SBS) warning light (amber) is illuminated, the area around the
radar sensor (front) may be dirty. Refer to “Warning Guidance” in the centre display (Type
B audio).
Refer to If a Warning Light Turns On or Flashes on page 7-32 .
.B[EB@&'&&"@&EJUJPOJOEC







*Some models.4–182
When Driving
Parking Sensor System
Front Corner Sensor * , Rear Corner Sensor
Distance Detection area Distance between vehicle and obstruction
Beeper sound *1 Front * /Rear Corner Sensor
Far distance Approx. 50—38 cm (19—14 in)
Medium intermittent sound
Middle distance Approx. 38—25 cm (14.0—9.8 in)
Fast intermittent sound
Close distance Within approx. 25 cm (9.8 in)
Continuous sound
*1 The rate at which the intermittent sound beeps increases as the vehicle approaches the obstruction.
NOTE
If an obstruction is detected in a zone for 6 seconds or more, the beep sound is stopped
(except for the close-distance zone). If the same obstruction is detected in another zone,
the corresponding beep sound is heard.
.B[EB@&'&&"@&EJUJPOJOEC







5–2
Interior Features
Air-Conditioning System
Operating Tips
 












 Operate the air-conditioning system with
the engine running.
 


 To prevent the battery from being
discharged, do not leave the fan control
dial on for a long period of time with the
ignition switched ON when the engine is
not running.
 


(With i-stop)
 The airfl ow amount may decrease
slightly while the i-stop function is
operating.
 


 Clear all obstructions such as leaves,
snow and ice from the bonnet and the
air inlet in the cowl grille to improve the
system effi ciency.




 Use the air-conditioning system to defog
the windows and dehumidify the air.
 


 The recirculate mode should be used
when driving through tunnels or while in
a traffi c jam, or when you would like to
shut off outside air for quick cooling of
the interior.
 


 Use the outside air position for
ventilation or windscreen defrosting.
 


 If the vehicle has been parked in direct
sunlight during hot weather, open the
windows to let warm air escape, then
run the air-conditioning system.
(With A/C switch)
 




 Run the air conditioner about 10 minutes
at least once a month to keep internal
parts lubricated.
 


 Have the air conditioner checked before
the weather gets hot. Lack of refrigerant
may make the air conditioner less
effi cient.

 The refrigerant specifi cations are
indicated on a label attached to the
inside of the engine compartment. Check
the label before refi lling the refrigerant.
If the wrong type of refrigerant is used,
it could result in a serious malfunction
of the air conditioner.
  For details, consult an expert repairer,
we recommend an Authorised Mazda
Repairer.
Label
.B[EB@&'&&"@&EJUJPOJOEC







5–14
Interior Features
Air-Conditioning System
Dual-Zone Automatic Air-Conditioning
Air-conditioning information is displayed on the display.
Airflow display Temperature setting display (driver)
Mode selector
display A/C mode display
Temperature setting display (passenger)
Air intake selector
(recirculated air
position)
Air intake selector
(outside air position) Driver temperature control dial
AUTO switch
Mode selector switch Fan control switchOFF switchWindscreen defroster
switch
Rear window defogger switch
Passenger temperature
control dial
DUAL switch A/C switch
Control Switches
AUTO switch
By pressing the AUTO switch the
following functions will be automatically
controlled in accordance with the selected
set temperature:
 


 Airfl ow temperature



 Amount of airfl ow



 Selection of airfl ow mode



 Outside/Recirculated air selection



 Air conditioner operation



 A/C or A/C ECO selection
NOTE
AUTO switch indicator light


 When on, it indicates auto operation,
and the system will function
automatically.
  If any of the following switches are
operated while in auto control, the
AUTO switch indicator turns off.
 


 Mode selector switch



 Fan control switch



 Windscreen defroster switch
The functions for switches other
than those operated in the above
continue to operate in auto control.
.B[EB@&'&&"@&EJUJPOJOEC







5–15
Interior Features
Air-Conditioning System
OFF switch
Pressing the OFF switch shuts off the air-
conditioning system.
Temperature control dial
This dial controls temperature. Turn it
clockwise for hot and anticlockwise for
cold.
 


 When the DUAL switch is off:
 Turn the driver temperature control dial
to control the temperature throughout
the entire cabin.
 


 When the DUAL switch is on:
 Turn the driver or front passenger
temperature control dial to
independently control the temperature
on each side of the cabin.
NOTE
The air-conditioning system changes to
the individual operation mode ( DUAL
switch indicator light illuminated) by
turning the front passenger temperature
control dial even when the DUAL
switch is off, which allows individual
control of the set temperature for the
driver and front passenger.
Fan control switch
The fan has seven speeds. The selected
speed will be displayed.
Mode selector switch
The desired airfl ow mode can be selected
(page 5-4 ).
NOTE
  With the airfl ow mode set to the
position and the temperature control
dial set at a medium temperature,
heated air is directed to the feet and
air at a comparably lower
temperature will fl ow through the
central, left and right vents.
  To set the air vent to , press the
windscreen defroster switch.
  In the position, the outside air
position is automatically selected.
A/C switch
Pressing the A/C switch while the AUTO
switch is turned on will turn off the air
conditioning (cooling/dehumidifying
functions).
The air conditioning can be turned on and
off by pressing the A/C switch while the
fan control switch is on.
Changes as follows each time the A/C
switch is pressed.
A/C
: A/C ECO
:Stop
NOTE

 The air conditioning operates when
the A/C switch is pressed even if the
fan is off.
  The A/C ECO function is designed
to economize use of the air-
conditioning system. “ A/C ECO ” is
displayed to indicate that the air-
conditioning system is operating at
optimum control.
  The air conditioner may not function
when the outside temperature
approaches 0 °C (32 °F).
.B[EB@&'&&"@&EJUJPOJOEC







*Some models.5–19
Interior Features
Audio System
Aerial
Aerial (Saloon)
The aerial is embedded into the window
glass.
CAUTION
When washing the inside of the window
which has an aerial, use a soft cloth
dampened in lukewarm water, gently
wiping the aerial lines.
Use of glass cleaning products could
damage the aerial.
Aerial (Hatchback)
Type A
To remove the aerial, turn it anticlockwise.
To install the aerial, turn it clockwise.
Make sure the aerial is securely installed.
RemoveInstall
CAUTION
  To prevent damage to the aerial,
remove it before entering a car wash
facility or passing beneath a low
overhead clearance.
  Be careful around the aerial when
removing snow from the roof.
Otherwise the aerial could be
damaged.
NOTE
When leaving your vehicle unattended,
we recommend that you remove the
aerial and store it inside the vehicle.
Type B
Aerial
Type C *
The aerial is embedded into the window
glass.
.B[EB@&'&&"@&EJUJPOJOEC